Searched refs:CAN (Results 1 – 25 of 75) sorted by relevance
123
| /arch/arm/boot/dts/ti/omap/ |
| A D | am335x-netcan-plus-1xx.dts | 42 AM33XX_PADCONF(AM335X_PIN_UART1_RXD, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* CAN Data LED */
43 AM33XX_PADCONF(AM335X_PIN_UART1_TXD, PIN_OUTPUT_PULLDOWN, MUX_MODE7) /* CAN Error LED */
49 AM33XX_PADCONF(AM335X_PIN_UART0_CTSN, PIN_OUTPUT, MUX_MODE2) /* CAN TX */
50 AM33XX_PADCONF(AM335X_PIN_UART0_RTSN, PIN_INPUT, MUX_MODE2) /* CAN RX */
|
| A D | am335x-wega.dtsi | 90 /* CAN Busses */
|
| A D | am335x-pcm-953.dtsi | 86 /* CAN */
|
| A D | am335x-regor.dtsi | 53 /* CAN Busses */
|
| /arch/sh/kernel/cpu/sh4a/ |
| A D | setup-sh7770.c | 343 DU, VIDEO_IN, REMOTE, YUV, USB, ATAPI, CAN, GPS, GFX2D, enumerator
377 INTC_VECT(CAN, 0x880), INTC_VECT(GPS, 0x8a0),
424 GPS, CAN, ATAPI, USB, YUV, REMOTE, VIDEO_IN, DU, SRC, I2S,
433 { 0xffe00010, 0, 32, 8, /* INT2PRI4 */ { ATAPI, CAN, GPS, GFX2D } },
|
| /arch/arm/boot/dts/microchip/ |
| A D | sama5d3_can.dtsi | 4 * CAN support
|
| A D | at91-sam9x60_curiosity.dts | 271 AT91_PIOC 9 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_DOWN>; /* Enable CAN Transceivers */
280 AT91_PIOB 17 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_DOWN>; /* Enable CAN Transceivers */
|
| A D | at91-sam9x60ek.dts | 472 AT91_PIOD 21 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_DOWN>; /* Enable CAN Transceivers */
482 AT91_PIOD 21 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_DOWN>; /* Enable CAN Transceivers */
|
| /arch/arm64/boot/dts/freescale/ |
| A D | imx8mm-mx8menlo.dts | 44 /* Fixed clock dedicated to SPI CAN on carrier board */
60 /* CAN controller on the baseboard */
|
| A D | imx8x-colibri.dtsi | 660 /* Colibri optional CAN on UART_B RTS/CTS */
666 /* Colibri optional CAN on PS2 */
672 /* Colibri optional CAN on UART_A TXD/RXD */
|
| A D | imx95-libra-rdk-fpsc.dts | 105 /* CAN FD */
|
| A D | imx8mp-libra-rdk-fpsc.dts | 117 /* CAN FD */
|
| A D | imx93-phyboard-nash.dts | 85 /* CAN */
|
| A D | imx93-phyboard-segin.dts | 115 /* CAN */
|
| A D | imx8-ss-dma.dtsi | 420 /* CAN0 clock and PD is shared among all CAN instances as
441 /* CAN0 clock and PD is shared among all CAN instances as
|
| A D | imx8mm-emtop-baseboard.dts | 108 /* CAN BUS */
|
| /arch/powerpc/boot/dts/ |
| A D | tqm8560.dts | 316 2 0x0 0xe3000000 0x00008000 // CAN (2 x i82527)
354 /* Note: CAN support needs be enabled in U-Boot */
|
| A D | tqm8xx.dts | 68 /* Note: CAN support needs be enabled in U-Boot */
|
| A D | tqm8548-bigflash.dts | 346 2 0x0 0xa3000000 0x00008000 // CAN (2 x CC770)
386 /* Note: CAN support needs be enabled in U-Boot */
|
| A D | tqm8548.dts | 346 2 0x0 0xe3000000 0x00008000 // CAN (2 x CC770)
386 /* Note: CAN support needs be enabled in U-Boot */
|
| A D | mpc5125twr.dts | 125 can@1300 { // CAN rev.2
|
| /arch/arm/boot/dts/nxp/imx/ |
| A D | imx27-phytec-phycore-rdk.dts | 202 MX27_PAD_SD1_D1__GPIO5_19 0x0 /* CAN IRQ */
|
| A D | imx6ul-ccimx6ulsbcpro.dts | 208 /* UART3 RTS/CTS muxed with CAN 1 */
|
| /arch/powerpc/platforms/512x/ |
| A D | clock-commonclk.c | 1059 NODE_CHK("ipg", clks[MPC512x_CLK_BDLC], 0, CAN); in mpc5121_clk_provide_backwards_compat()
1060 NODE_CHK("mclk", clks[MPC512x_CLK_MSCAN0_MCLK + idx], 0, CAN); in mpc5121_clk_provide_backwards_compat()
|
| /arch/arm64/boot/dts/renesas/ |
| A D | rzg3e-smarc-som.dtsi | 21 * 0 - Select CAN routing
|
Completed in 37 milliseconds
123