| /arch/sh/kernel/cpu/sh4/ |
| A D | setup-sh7760.c | 26 I2C0, I2C1, enumerator
55 INTC_VECT(I2C0, 0x9c0), INTC_VECT(I2C1, 0x9e0),
90 SSI0, SSI1, HAC0, HAC1, I2C0, I2C1, USB, LCDC,
110 HAC0, HAC1, I2C0, I2C1 } },
|
| /arch/sh/kernel/cpu/sh4a/ |
| A D | setup-sh7734.c | 315 I2C0, enumerator
393 INTC_VECT(I2C0, 0x860),
493 I2C0, /* I2C */ /* I2C 0, 1*/
515 { HPBDMAC23_25_27_28, I2C0, SRC0, SRC1 } },
|
| A D | setup-sh7343.c | 329 DMAC0123, VIOVOU, MMC, DMAC45, FLCTL, I2C0, I2C1, SIM, USB, enumerator
374 INTC_GROUP(I2C0, I2C0_ALI, I2C0_TACKI, I2C0_WAITI, I2C0_DTEI),
414 { 0xa408001c, 0, 16, 4, /* IPRH */ { SIOF0, SIOF1, FLCTL, I2C0 } },
|
| A D | setup-sh7786.c | 475 I2C0, I2C1, enumerator
518 INTC_VECT(I2C0, 0xcc0), INTC_VECT(I2C1, 0xce0),
592 I2C0, I2C1,
631 { 0xfe410848, 0, 32, 8, /* INT2PRI18 */ { 0, 0, I2C0, I2C1 } },
|
| A D | setup-sh7724.c | 895 DMAC1B, DMAC0B, I2C0, I2C1, SDHI0, SDHI1, SPU, MMCIF, enumerator
1010 INTC_GROUP(I2C0, I2C0_ALI, I2C0_TACKI, I2C0_WAITI, I2C0_DTEI),
1069 I2C1, I2C0 } },
|
| /arch/arm64/boot/dts/mediatek/ |
| A D | mt6797-x20-dev.dts | 53 /* LS - I2C0 */
|
| /arch/arm/boot/dts/intel/socfpga/ |
| A D | socfpga_cyclone5_chameleon96.dts | 74 label = "LS-I2C0";
|
| /arch/arm64/boot/dts/socionext/ |
| A D | uniphier-ld20-akebi96.dts | 141 /* LS connector I2C0 */
|
| /arch/arm/boot/dts/renesas/ |
| A D | r8a7790-lager.dts | 305 * IIC0/I2C0 is routed to EXIO connector A, pins 114 (SCL) + 116 (SDA) only.
307 * depending on the use case (e.g. DMA with IIC0 or slave support with I2C0).
309 * bus with IIC3 on pins 110 (SCL) + 112 (SDA), select I2C0 at runtime, and
313 * IIC0/I2C0 does not appear to support fallback to GPIO.
|
| /arch/arm64/boot/dts/hisilicon/ |
| A D | hi3798cv200-poplar.dts | 164 label = "LS-I2C0";
|
| A D | hi3660-hikey960.dts | 523 label = "LS-I2C0";
|
| /arch/arm/boot/dts/st/ |
| A D | stih410-b2260.dts | 120 label = "LS-I2C0";
|
| A D | stm32mp157a-stinger96.dtsi | 85 /* LS-I2C0 */
|
| A D | ste-ux500-samsung-skomer.dts | 386 /* I2C0 */
|
| A D | ste-ux500-samsung-kyle.dts | 406 /* I2C0 */
|
| /arch/arm/boot/dts/microchip/ |
| A D | at91sam9x5.dtsi | 421 <AT91_PIOA 30 AT91_PERIPH_A AT91_PINCTRL_NONE /* PA30 periph A I2C0 data */
422 AT91_PIOA 31 AT91_PERIPH_A AT91_PINCTRL_NONE>; /* PA31 periph A I2C0 clock */
445 <AT91_PIOA 30 AT91_PERIPH_GPIO AT91_PINCTRL_MULTI_DRIVE /* PA30 gpio multidrive I2C0 data */
446 … AT91_PIOA 31 AT91_PERIPH_GPIO AT91_PINCTRL_MULTI_DRIVE>; /* PA31 gpio multidrive I2C0 clock */
|
| /arch/arm64/boot/dts/qcom/ |
| A D | qrb5165-rb5.dts | 604 /* LS-I2C0 */
1184 "I2C0-SDA",
1185 "I2C0-SCL",
|
| A D | sar2130p-qar2130p.dts | 39 /* pm3003a on I2C0, should not be controlled */
|
| A D | apq8016-sbc.dts | 151 /* On Low speed expansion: LS-I2C0 */
|
| /arch/arm64/boot/dts/freescale/ |
| A D | imx8mq-thor96.dts | 141 /* LS-I2C0 */
|
| /arch/arm64/boot/dts/rockchip/ |
| A D | px30-pp1516.dtsi | 169 /* I2C0 = PMIC, Touchscreen */
|
| A D | px30-cobra.dtsi | 148 /* I2C0 = PMIC, STUSB4500, RTC */
|
| /arch/arm64/boot/dts/marvell/ |
| A D | armada-8040-clearfog-gt-8k.dts | 271 * [35-38] CP0 I2C1 and I2C0
|
| /arch/arm64/boot/dts/xilinx/ |
| A D | zynqmp-zcu100-revC.dts | 195 label = "LS-I2C0";
|
| /arch/arm/boot/dts/marvell/ |
| A D | armada-385-clearfog-gtr.dtsi | 24 2,3 - I2C0 - connected to I2C EEPROM, two temperature sensors,
|