Searched refs:AP (Results 1 – 19 of 19) sorted by relevance
| /drivers/clk/thead/ |
| A D | Kconfig | 4 bool "T-HEAD TH1520 AP clock support"
10 Say yes here to support the AP sub system clock controller
|
| /drivers/net/wireless/purelifi/plfxlc/ |
| A D | chip.h | 15 AP = 1, enumerator
|
| /drivers/firmware/samsung/ |
| A D | Kconfig | 10 (AP, AOC, ...). ACPM firmware operates on the Active Power Management
|
| /drivers/net/wireless/marvell/mwifiex/ |
| A D | README | 46 The above command can be used to connect to an AP with a particular SSID.
47 Ap's operating frequency can be specified or even the bssid. If the AP is using
49 …Note: Every time before connecting to an AP scan command (iw dev mlan0 scan) should be used by use…
52 This command will be used to disconnect from an AP.
|
| /drivers/net/ipa/ |
| A D | Kconfig | 18 between the AP and modem.
|
| /drivers/clk/versatile/ |
| A D | Kconfig | 12 - Integrator/AP and Integrator/CP
|
| /drivers/firmware/imx/ |
| A D | Kconfig | 6 This enables DSP IPC protocol between host AP (Linux)
|
| /drivers/firmware/ |
| A D | Kconfig | 18 Cores(AP) and the System Control Processor(SCP). The MHU peripheral
20 and AP.
177 between host AP (Linux) and the firmware running on ADSP.
|
| /drivers/staging/greybus/Documentation/ |
| A D | sysfs-bus-greybus | 224 The AP interface ID, a 1-byte non-zero integer which
225 defines the position of the AP module on the frame.
|
| /drivers/net/wireless/marvell/libertas/ |
| A D | README | 172 echo "LINKSYS-AP" > extscan
|
| /drivers/bus/ |
| A D | Kconfig | 30 found on the ARM Integrator AP (Application Platform)
|
| /drivers/clocksource/ |
| A D | Kconfig | 256 bool "Integrator-AP timer driver" if COMPILE_TEST
259 Enables support for the Integrator-AP timer.
|
| /drivers/staging/greybus/Documentation/firmware/ |
| A D | firmware-management | 11 Firmware Management Protocol. To support Firmware Management by the AP, the
|
| /drivers/regulator/ |
| A D | max8998.c | 534 MAX8998_OTHERS_REG(EN32KHz-AP, MAX8998_EN32KHZ_AP),
|
| /drivers/input/serio/ |
| A D | Kconfig | 268 tristate "OLPC AP-SP input support"
|
| /drivers/firmware/arm_scmi/vendors/imx/ |
| A D | imx95.rst | 955 auxiliary CPUs in a target LM (e.g. additional cores in an AP cluster or
958 - For cores in AP cluster, PSCI should be used and PSCI firmware will use CPU
959 protocol to handle them. For cores in non-AP cluster, Operating System(e.g.
|
| /drivers/mailbox/ |
| A D | Kconfig | 329 controller driver enables communication between AP and CPUCP. Say
|
| /drivers/crypto/ |
| A D | Kconfig | 70 depends on AP
|
| /drivers/tty/serial/ |
| A D | Kconfig | 27 an Integrator/AP or Integrator/PP2 platform, or if you have a
|
Completed in 27 milliseconds