Searched refs:AUX_CS (Results 1 – 3 of 3) sorted by relevance
| /drivers/staging/gpib/tms9914/ |
| A D | tms9914.c | 103 write_byte(priv, AUX_SIC | AUX_CS, AUXCR); in tms9914_interface_clear()
115 write_byte(priv, AUX_SRE | AUX_CS, AUXCR); in tms9914_remote_enable()
143 write_byte(priv, AUX_STDL | AUX_CS, AUXCR); in tms9914_t1_delay()
150 write_byte(priv, AUX_VSTDL | AUX_CS, AUXCR); in tms9914_t1_delay()
174 write_byte(priv, AUX_HLDE | AUX_CS, AUXCR); in tms9914_set_holdoff_mode()
179 write_byte(priv, AUX_HLDA | AUX_CS, AUXCR); in tms9914_set_holdoff_mode()
218 write_byte(priv, AUX_CS | AUX_RPP, AUXCR); in tms9914_parallel_poll()
266 write_byte(priv, AUX_RSV2 | AUX_CS, AUXCR); in tms9914_serial_poll_response()
641 write_byte(priv, AUX_LON | AUX_CS, AUXCR); in check_my_address_state()
655 write_byte(priv, AUX_TON | AUX_CS, AUXCR); in check_my_address_state()
[all …]
|
| /drivers/staging/gpib/include/ |
| A D | tms9914.h | 251 AUX_CS = 0x80, /* set bit instead of clearing it, used with commands marked 'd' below */ enumerator
254 AUX_VAL = (AUX_INVAL | AUX_CS), // release dac holdoff, valid command byte
|
| /drivers/staging/gpib/agilent_82357a/ |
| A D | agilent_82357a.c | 804 write.value |= AUX_CS; in agilent_82357a_interface_clear()
826 write.value |= AUX_CS; in agilent_82357a_remote_enable()
961 writes[0].value = AUX_CS | AUX_RPP; in agilent_82357a_parallel_poll()
1392 writes[0].value = AUX_CS | AUX_CHIP_RESET; in agilent_82357a_go_idle()
|
Completed in 11 milliseconds