| /drivers/power/reset/ |
| A D | linkstation-poweroff.c | 56 __phy_modify(phydev, MII_PHY_LED_CTRL, LEDMASK, LED2_FORCE_ON); in linkstation_mvphy_reg_intn()
59 __phy_modify(phydev, MII_88E1318S_PHY_LED_TCR, in linkstation_mvphy_reg_intn()
95 __phy_modify(phydev, MII_PHY_LED_POL_CTRL, in readynas_mvphy_set_reg()
|
| /drivers/net/phy/ |
| A D | icplus.c | 247 err = __phy_modify(phydev, IP101G_DIGITAL_IO_SPEC_CTRL, in ip101a_g_config_intr_pin()
254 err = __phy_modify(phydev, IP101G_DIGITAL_IO_SPEC_CTRL, in ip101a_g_config_intr_pin()
373 ret = __phy_modify(phydev, IP10XX_SPEC_CTRL_STATUS, in ip101a_g_config_mdix()
378 ret = __phy_modify(phydev, IP101A_G_PHY_SPEC_CTRL, in ip101a_g_config_mdix()
|
| A D | motorcomm.c | 475 return __phy_modify(phydev, YTPHY_PAGE_DATA, mask, set); in ytphy_modify_ext()
583 ret = __phy_modify(phydev, YTPHY_INTERRUPT_ENABLE_REG, 0, in ytphy_set_wol()
598 ret = __phy_modify(phydev, YTPHY_INTERRUPT_ENABLE_REG, in ytphy_set_wol()
710 ret = __phy_modify(phydev, YT8511_PAGE, 0, YT8511_CLK_125M); in yt8511_config_init()
1521 ret = __phy_modify(phydev, MII_BMCR, mask, set); in yt8521_modify_bmcr_paged()
1811 ret = __phy_modify(phydev, MII_BMCR, BMCR_ANENABLE, 0); in yt8521_fiber_setup_forced()
1858 return __phy_modify(phydev, MII_BMCR, BMCR_ISOLATE, in ytphy_check_and_restart_aneg()
1901 __phy_modify(phydev, MII_BMCR, 0, BMCR_PDOWN); in yt8521_fiber_config_aneg()
1903 __phy_modify(phydev, MII_BMCR, BMCR_PDOWN, 0); in yt8521_fiber_config_aneg()
2049 return __phy_modify(phydev, MII_BMCR, ~(BMCR_LOOPBACK | in ytphy_utp_config_aneg()
[all …]
|
| A D | mxl-86110.c | 189 return __phy_modify(phydev, MXL86110_EXTD_REG_ADDR_DATA, mask, set); in __mxl86110_modify_extended_reg()
308 ret = __phy_modify(phydev, PHY_IRQ_ENABLE_REG, 0, in mxl86110_set_wol()
326 ret = __phy_modify(phydev, PHY_IRQ_ENABLE_REG, in mxl86110_set_wol()
|
| A D | phy-core.c | 530 int __phy_modify(struct phy_device *phydev, u32 regnum, u16 mask, u16 set) in __phy_modify() function
538 EXPORT_SYMBOL_GPL(__phy_modify);
556 ret = __phy_modify(phydev, regnum, mask, set); in phy_modify()
|
| A D | marvell.c | 1967 err = __phy_modify(phydev, MII_88E1318S_PHY_LED_TCR, in m88e1318_set_wol()
2009 err = __phy_modify(phydev, MII_88E1318S_PHY_WOL_CTRL, in m88e1318_set_wol()
2022 err = __phy_modify(phydev, MII_88E1318S_PHY_WOL_CTRL, 0, in m88e1318_set_wol()
2033 err = __phy_modify(phydev, MII_88E1318S_PHY_WOL_CTRL, in m88e1318_set_wol()
3606 ret = __phy_modify(phydev, MII_88E1510_GEN_CTRL_REG_1, in m88e1510_sfp_insert()
3628 ret = __phy_modify(phydev, MII_88E1510_GEN_CTRL_REG_1, in m88e1510_sfp_remove()
|
| A D | broadcom.c | 928 err = __phy_modify(phydev, MII_BRCM_FET_SHDW_AUXMODE4, in brcm_fet_config_init()
|
| /drivers/net/ethernet/realtek/ |
| A D | r8169_phy_config.c | 26 __phy_modify(phydev, reg, mask, val); in r8168d_modify_extpage()
37 __phy_modify(phydev, 0x06, mask, val); in r8168d_phy_param()
48 __phy_modify(phydev, 0x14, mask, val); in r8168g_phy_param()
|
| /drivers/net/phy/mediatek/ |
| A D | mtk-ge-soc.c | 1062 __phy_modify(phydev, MTK_PHY_LPI_REG_14, in mt798x_phy_eee()
1066 __phy_modify(phydev, MTK_PHY_LPI_REG_1c, MTK_PHY_SMI_DET_ON_THRESH_MASK, in mt798x_phy_eee()
|
| /drivers/net/phy/qcom/ |
| A D | at803x.c | 196 return __phy_modify(phydev, AT803X_REG_CHIP_CONFIG, mask, set); in at803x_write_page()
|
| /drivers/net/phy/realtek/ |
| A D | realtek_main.c | 212 ret = __phy_modify(phydev, regnum, mask, set); in rtl821x_modify_ext_page()
|
| /drivers/net/phy/mscc/ |
| A D | mscc_main.c | 1568 __phy_modify(phydev, MSCC_PHY_GPIO_CONTROL_2, in vsc85xx_coma_mode_release()
|