Searched refs:bcma (Results 1 – 19 of 19) sorted by relevance
| /drivers/bcma/ |
| A D | Makefile | 2 bcma-y += main.o scan.o core.o sprom.o 3 bcma-y += driver_chipcommon.o driver_chipcommon_pmu.o 4 bcma-y += driver_chipcommon_b.o 5 bcma-$(CONFIG_BCMA_PFLASH) += driver_chipcommon_pflash.o 8 bcma-$(CONFIG_BCMA_DRIVER_PCI) += driver_pci.o 9 bcma-$(CONFIG_BCMA_DRIVER_PCI) += driver_pcie2.o 11 bcma-$(CONFIG_BCMA_DRIVER_MIPS) += driver_mips.o 13 bcma-$(CONFIG_BCMA_DRIVER_GPIO) += driver_gpio.o 14 bcma-$(CONFIG_BCMA_HOST_PCI) += host_pci.o 15 bcma-$(CONFIG_BCMA_HOST_SOC) += host_soc.o [all …]
|
| A D | Kconfig | 86 Enabling this symbol will let bcma recognize serial flash and register 107 Driver to provide access to the GPIO pins of the bcma bus.
|
| /drivers/net/ethernet/broadcom/ |
| A D | bgmac-bcma-mdio.c | 55 if (bgmac->bcma.core->id.id == BCMA_CORE_4706_MAC_GBIT) { in bcma_mdio_phy_read() 56 core = bgmac->bcma.core->bus->drv_gmac_cmn.core; in bcma_mdio_phy_read() 60 core = bgmac->bcma.core; in bcma_mdio_phy_read() 94 if (bgmac->bcma.core->id.id == BCMA_CORE_4706_MAC_GBIT) { in bcma_mdio_phy_write() 95 core = bgmac->bcma.core->bus->drv_gmac_cmn.core; in bcma_mdio_phy_write() 99 core = bgmac->bcma.core; in bcma_mdio_phy_write() 109 bcma_write32(bgmac->bcma.core, BGMAC_INT_STATUS, BGMAC_IS_MDIO); in bcma_mdio_phy_write() 110 if (bcma_read32(bgmac->bcma.core, BGMAC_INT_STATUS) & BGMAC_IS_MDIO) in bcma_mdio_phy_write() 133 struct bcma_chipinfo *ci = &bgmac->bcma.core->bus->chipinfo; in bcma_mdio_phy_init() 153 struct bcma_drv_cc *cc = &bgmac->bcma.core->bus->drv_cc; in bcma_mdio_phy_init() [all …]
|
| A D | bgmac-bcma.c | 36 return bcma_read32(bgmac->bcma.core, offset); in bcma_bgmac_read() 41 bcma_write32(bgmac->bcma.core, offset, value); in bcma_bgmac_write() 46 return bcma_aread32(bgmac->bcma.core, offset); in bcma_bgmac_idm_read() 51 return bcma_awrite32(bgmac->bcma.core, offset, value); in bcma_bgmac_idm_write() 56 return bcma_core_is_enabled(bgmac->bcma.core); in bcma_bgmac_clk_enabled() 61 bcma_core_enable(bgmac->bcma.core, flags); in bcma_bgmac_clk_enable() 67 struct bcma_drv_cc *cc = &bgmac->bcma.core->bus->drv_cc; in bcma_bgmac_cco_ctl_maskset() 82 bcma_maskset32(bgmac->bcma.cmn, offset, mask, set); in bcma_bgmac_cmn_maskset32() 121 MODULE_DEVICE_TABLE(bcma, bgmac_bcma_tbl); 137 bgmac->bcma.core = core; in bgmac_probe() [all …]
|
| A D | Makefile | 16 obj-$(CONFIG_BGMAC_BCMA) += bgmac-bcma.o bgmac-bcma-mdio.o
|
| A D | bgmac.h | 450 } bcma; member
|
| /drivers/pci/controller/ |
| A D | pcie-iproc-bcma.c | 85 MODULE_DEVICE_TABLE(bcma, iproc_bcma_pcie_table);
|
| A D | Makefile | 28 obj-$(CONFIG_PCIE_IPROC_BCMA) += pcie-iproc-bcma.o
|
| /drivers/firmware/broadcom/ |
| A D | Kconfig | 23 bootloader firmware CFE. This driver provides method to ssb and bcma
|
| /drivers/usb/host/ |
| A D | Makefile | 88 obj-$(CONFIG_USB_HCD_BCMA) += bcma-hcd.o
|
| A D | bcma-hcd.c | 488 MODULE_DEVICE_TABLE(bcma, bcma_hcd_table);
|
| A D | Kconfig | 696 Enable support for the EHCI and OCHI host controller on an bcma bus. 697 It converts the bcma driver into two platform device drivers 708 Enable support for the EHCI and OCHI host controller on an bcma bus. 709 It converts the bcma driver into two platform device drivers
|
| /drivers/ |
| A D | Makefile | 147 obj-$(CONFIG_BCMA) += bcma/
|
| A D | Kconfig | 104 source "drivers/bcma/Kconfig"
|
| /drivers/net/wireless/broadcom/b43/ |
| A D | bus.c | 99 bcm47xx_bus.bcma.bus.chipinfo.id == BCMA_CHIP_ID_BCM4716) in b43_bus_dev_bcma_init()
|
| A D | main.c | 129 MODULE_DEVICE_TABLE(bcma, b43_bcma_tbl);
|
| /drivers/mtd/devices/ |
| A D | Kconfig | 120 registered by bcma as platform devices. This enables driver for
|
| /drivers/mtd/nand/raw/ |
| A D | Kconfig | 204 registered by bcma as platform devices. This enables driver for
|
| /drivers/net/wireless/broadcom/brcm80211/brcmsmac/ |
| A D | mac80211_if.c | 103 MODULE_DEVICE_TABLE(bcma, brcms_coreid_table);
|
Completed in 38 milliseconds