Searched refs:cr3 (Results 1 – 5 of 5) sorted by relevance
| /drivers/tty/serial/ |
| A D | stm32-usart.c | 49 .cr3 = 0x14,
67 .cr3 = 0x08,
90 .cr3 = 0x08,
192 *cr3 |= USART_CR3_DEM; in stm32_usart_config_reg_rs485()
235 cr3 = readl_relaxed(port->membase + ofs->cr3); in stm32_usart_config_rs485()
255 writel_relaxed(cr3, port->membase + ofs->cr3); in stm32_usart_config_rs485()
1198 cr3 = readl_relaxed(port->membase + ofs->cr3); in stm32_usart_set_termios()
1380 writel_relaxed(cr3, port->membase + ofs->cr3); in stm32_usart_set_termios()
1872 u32 cr3; in stm32_usart_serial_remove() local
1893 cr3 = readl_relaxed(port->membase + ofs->cr3); in stm32_usart_serial_remove()
[all …]
|
| A D | fsl_lpuart.c | 1773 u8 cr3; in lpuart_rx_dma_startup() local
1795 cr3 = readb(sport->port.membase + UARTCR3); in lpuart_rx_dma_startup()
1796 cr3 |= UARTCR3_FEIE; in lpuart_rx_dma_startup()
1797 writeb(cr3, sport->port.membase + UARTCR3); in lpuart_rx_dma_startup()
1993 u8 cr1, old_cr1, old_cr2, cr3, cr4, bdh, modem; in lpuart_set_termios() local
2000 cr3 = readb(port->membase + UARTCR3); in lpuart_set_termios()
2053 cr3 |= UARTCR3_T8; in lpuart_set_termios()
2055 cr3 &= ~UARTCR3_T8; in lpuart_set_termios()
2123 writeb(cr3, port->membase + UARTCR3); in lpuart_set_termios()
|
| A D | stm32-usart.h | 14 u16 cr3; member
|
| /drivers/firmware/efi/libstub/ |
| A D | x86-5lvl.c | 13 static void (*la57_toggle)(void *cr3);
69 u64 *cr3 = (u64 *)__native_read_cr3(); in efi_5level_switch() local
82 new_cr3[0] = (u64)cr3 | _PAGE_TABLE_NOENC; in efi_5level_switch()
85 new_cr3 = (u64 *)(cr3[0] & PAGE_MASK); in efi_5level_switch()
|
| /drivers/media/platform/nxp/ |
| A D | imx7-media-csi.c | 362 u32 cr3; in imx7_csi_dma_reflash() local
365 cr3 |= BIT_DMA_REFLASH_RFF; in imx7_csi_dma_reflash()
382 cr3 |= BIT_DMA_REQ_EN_RFF; in imx7_csi_dmareq_rff_enable()
383 cr3 |= BIT_HRESP_ERR_EN; in imx7_csi_dmareq_rff_enable()
384 cr3 &= ~BIT_RXFF_LEVEL_MASK; in imx7_csi_dmareq_rff_enable()
385 cr3 |= BIT_RXFF_LEVEL(2); in imx7_csi_dmareq_rff_enable()
394 cr3 &= ~BIT_DMA_REQ_EN_RFF; in imx7_csi_dmareq_rff_disable()
395 cr3 &= ~BIT_HRESP_ERR_EN; in imx7_csi_dmareq_rff_disable()
532 u32 cr3 = BIT_FRMCNT_RST; in imx7_csi_configure() local
581 cr3 |= BIT_TWO_8BIT_SENSOR; in imx7_csi_configure()
[all …]
|
Completed in 29 milliseconds