Searched refs:hw_err (Results 1 – 11 of 11) sorted by relevance
| /drivers/media/platform/st/sti/hva/ |
| A D | hva-hw.c | 145 ctx->hw_err = false; in hva_hw_its_irq_thread()
160 ctx->hw_err = true; in hva_hw_its_irq_thread()
165 ctx->hw_err = true; in hva_hw_its_irq_thread()
170 ctx->hw_err = true; in hva_hw_its_irq_thread()
175 ctx->hw_err = true; in hva_hw_its_irq_thread()
180 ctx->hw_err = true; in hva_hw_its_irq_thread()
185 ctx->hw_err = true; in hva_hw_its_irq_thread()
190 ctx->hw_err = true; in hva_hw_its_irq_thread()
247 ctx->hw_err = true; in hva_hw_err_irq_thread()
253 ctx->hw_err = true; in hva_hw_err_irq_thread()
[all …]
|
| A D | hva.h | 270 bool hw_err; member
|
| /drivers/net/ethernet/intel/ixgbe/ |
| A D | ixgbe_x550.c | 210 hw_err(hw, "CS4227 reset did not complete\n"); in ixgbe_reset_cs4227()
216 hw_err(hw, "CS4227 EEPROM did not load successfully\n"); in ixgbe_reset_cs4227()
237 hw_err(hw, "semaphore failed with %d\n", status); in ixgbe_check_cs4227()
258 hw_err(hw, "semaphore failed with %d\n", status); in ixgbe_check_cs4227()
266 hw_err(hw, "CS4227 reset failed: %d", status); in ixgbe_check_cs4227()
279 hw_err(hw, "semaphore failed with %d", status); in ixgbe_check_cs4227()
572 hw_err(hw, "rx_pause not valid in strict IEEE mode\n"); in ixgbe_setup_fw_link()
2899 hw_err(hw, "Flow control param set incorrectly\n"); in ixgbe_setup_fc_x550em()
2954 hw_err(hw, "Flow control autoneg is disabled"); in ixgbe_fc_autoneg_backplane_x550em_a()
2960 hw_err(hw, "The link is down"); in ixgbe_fc_autoneg_backplane_x550em_a()
[all …]
|
| A D | ixgbe_common.h | 187 #define hw_err(hw, format, arg...) \ macro
|
| A D | ixgbe_common.c | 2849 hw_err(hw, "eeprom read at offset %d failed\n", in ixgbe_get_san_mac_addr_offset()
2889 hw_err(hw, "eeprom read at offset %d failed\n", in ixgbe_get_san_mac_addr_generic()
3446 hw_err(hw, "eeprom read at offset %d failed\n", offset); in ixgbe_get_wwn_prefix_generic()
3455 hw_err(hw, "eeprom read at offset %d failed\n", offset); in ixgbe_get_wwn_prefix_generic()
4012 hw_err(hw, "eeprom read at offset %d failed\n", in ixgbe_init_thermal_sensor_thresh_generic()
|
| A D | ixgbe_phy.c | 1500 hw_err(hw, "eeprom read at offset %d failed\n", data_offset); in ixgbe_reset_phy_nl()
2037 hw_err(hw, "eeprom read at %d failed\n", in ixgbe_get_sfp_init_sequence_offsets()
2081 hw_err(hw, "eeprom read at offset %d failed\n", *list_offset); in ixgbe_get_sfp_init_sequence_offsets()
|
| A D | ixgbe_82599.c | 161 hw_err(hw, "eeprom read at offset %d failed\n", data_offset); in ixgbe_setup_sfp_modules_82599()
1910 hw_err(hw, "eeprom read at offset %d failed\n", offset); in ixgbe_verify_fw_version_82599()
|
| /drivers/crypto/hisilicon/ |
| A D | qm.c | 2620 struct qm_hw_err *err, *tmp, *hw_err; in qm_hw_err_isolate() local
2632 hw_err = kzalloc(sizeof(*hw_err), GFP_KERNEL); in qm_hw_err_isolate()
2633 if (!hw_err) in qm_hw_err_isolate()
2643 hw_err->timestamp = jiffies; in qm_hw_err_isolate()
2645 if ((hw_err->timestamp - err->timestamp) / HZ > in qm_hw_err_isolate()
2653 list_add(&hw_err->list, &isolate->qm_hw_errs); in qm_hw_err_isolate()
|
| /drivers/accel/habanalabs/common/ |
| A D | habanalabs_ioctl.c | 896 info = &hdev->captured_err_info.hw_err; in hw_err_info()
|
| A D | device.c | 2796 struct hw_err_info *info = &hdev->captured_err_info.hw_err; in hl_capture_hw_err()
|
| A D | habanalabs.h | 3161 struct hw_err_info hw_err; member
|
Completed in 60 milliseconds