Home
last modified time | relevance | path

Searched refs:programmed (Results 1 – 20 of 20) sorted by relevance

/drivers/slimbus/
A DKconfig21 programmed using Linux kernel.
32 Component is programmed using Linux kernel.
/drivers/mtd/chips/
A DKconfig162 A subset of them are pre-programmed at the factory with a
166 programmable (OTP) bits; when programmed, register bits cannot be
171 Lock Register bit is programmed, the associated Protection Register
172 can only be read; it can no longer be programmed. Additionally,
173 because the Lock Register bits themselves are OTP, when programmed,
/drivers/staging/iio/Documentation/
A Dsysfs-bus-iio-adc-ad7280a8 enable for the programmed amount of time, before it
/drivers/net/ethernet/via/
A DKconfig41 programmed I/O ports (PIO). Enabling this gives an improvement in
/drivers/mtd/nand/onenand/
A DKconfig51 The OTP block can be read, programmed and locked using the same
/drivers/leds/rgb/
A DKconfig24 It is a 3 or 4 channel LED driver programmed via an I2C interface.
/drivers/message/fusion/
A DKconfig117 The debug level can be programmed on the fly via SysFS (hex values)
/drivers/nvmem/
A DKconfig36 such as the M1. These are e.g. used to store factory programmed
367 tristate "STMicroelectronics STM32 factory-programmed memory support"
372 factory-programmed memory area.
/drivers/soundwire/
A Dbus.c825 static int sdw_program_device_num(struct sdw_bus *bus, bool *programmed) in sdw_program_device_num() argument
835 *programmed = false; in sdw_program_device_num()
895 *programmed = true; in sdw_program_device_num()
/drivers/net/ethernet/realtek/
A DKconfig63 This instructs the driver to use programmed I/O ports (PIO) instead
/drivers/net/ethernet/dec/tulip/
A DKconfig74 the Tulip's PIO (programmed I/O ports). Faster, but could produce
/drivers/leds/trigger/
A DKconfig16 via sysfs. Some LED hardware can be programmed to start
/drivers/usb/dwc3/
A DKconfig168 The Designware Core USB3 IP is programmed to operate in
/drivers/mtd/devices/
A DKconfig79 other key product data. The second half is programmed with a
/drivers/media/dvb-frontends/drx39xyj/
A Ddrx_driver.h173 bool programmed; /* only valid if self_check is OK */ member
/drivers/usb/misc/
A DKconfig107 driver supports the pre-programmed devices (incl. firmware)
/drivers/regulator/
A DKconfig84 the voltage is programmed via I2C interface.
423 programmed through an I2C interface.
1384 programmed from 4.5V to 20V.
/drivers/clk/
A DKconfig137 be pre-programmed to support other configurations and features not yet
/drivers/leds/
A DKconfig116 It is a matrix LED driver programmed via an I2C interface. Devices have
/drivers/firmware/arm_scmi/vendors/imx/
A Dimx95.rst570 programmed with the next nearest alarm time. So only one agent in an LM should

Completed in 45 milliseconds