Lines Matching refs:conversion
81 a conversion and send the result. Note that the
82 conversion duration depend on the resolution (if
115 (RW) trigger a bulk read conversion. read the status
119 conversion in progress on at least 1 sensor
121 conversion complete but at least one sensor
125 trigger a conversion on each device
143 (RW) Get, set, or measure a temperature conversion time. The
145 reset to default (datasheet) conversion time for a new
149 Actual conversion time in milliseconds.
153 Set the default conversion time from the datasheet.
155 Measure and set the conversion time. Make a single
156 temperature conversion, measure an actual value.
158 conversion time can be obtained by reading this
161 Set the conversion time in milliseconds.
174 1 Enable check for conversion success. If byte 6 of
175 scratchpad memory is 0xC after conversion, and
177 (insufficient power) - return a conversion error.
179 2 Enable poll for conversion completion. Generate read cycles
180 after the conversion start and wait for 1's. In parasite