Lines Matching refs:PHY
7 title: Ethernet PHY Common Properties
38 If the PHY reports an incorrect ID (or none at all) then the
39 compatible list may contain an entry with the correct PHY ID
57 The ID number for the PHY.
78 Maximum PHY supported speed in Mbits / seconds.
92 If set, indicates the PHY device does not correctly release
99 If set, indicates the PHY will swap the TX/RX lanes to
106 If set, indicates that PHY will disable swap of the
107 TX/RX lanes. This property allows the PHY to work correcly after
156 If set, indicates that the PHY is integrated into the same
158 should be configured to ensure the integrated PHY is
160 should be configured so that the external PHY is used.
171 The GPIO phandle and specifier for the PHY reset signal.
190 RGMII Receive PHY Clock Delay defined in pico seconds. This is used for
191 PHY's that have configurable RX internal delays. If this property is
192 present then the PHY applies the RX delay.
196 RGMII Transmit PHY Clock Delay defined in pico seconds. This is used for
197 PHY's that have configurable TX internal delays. If this property is
198 present then the PHY applies the TX delay.