/* SPDX-License-Identifier: BSD-3-Clause */ /* * Copyright (c) 2016-2018, STMicroelectronics - All Rights Reserved */ #ifndef __STPMIC1_H__ #define __STPMIC1_H__ #include #include #define TURN_ON_REG 0x1U #define TURN_OFF_REG 0x2U #define ICC_LDO_TURN_OFF_REG 0x3U #define ICC_BUCK_TURN_OFF_REG 0x4U #define RESET_STATUS_REG 0x5U #define VERSION_STATUS_REG 0x6U #define MAIN_CONTROL_REG 0x10U #define PADS_PULL_REG 0x11U #define BUCK_PULL_DOWN_REG 0x12U #define LDO14_PULL_DOWN_REG 0x13U #define LDO56_PULL_DOWN_REG 0x14U #define VIN_CONTROL_REG 0x15U #define PONKEY_TIMER_REG 0x16U #define MASK_RANK_BUCK_REG 0x17U #define MASK_RESET_BUCK_REG 0x18U #define MASK_RANK_LDO_REG 0x19U #define MASK_RESET_LDO_REG 0x1AU #define WATCHDOG_CONTROL_REG 0x1BU #define WATCHDOG_TIMER_REG 0x1CU #define BUCK_ICC_TURNOFF_REG 0x1DU #define LDO_ICC_TURNOFF_REG 0x1EU #define BUCK_APM_CONTROL_REG 0x1FU #define BUCK1_CONTROL_REG 0x20U #define BUCK2_CONTROL_REG 0x21U #define BUCK3_CONTROL_REG 0x22U #define BUCK4_CONTROL_REG 0x23U #define VREF_DDR_CONTROL_REG 0x24U #define LDO1_CONTROL_REG 0x25U #define LDO2_CONTROL_REG 0x26U #define LDO3_CONTROL_REG 0x27U #define LDO4_CONTROL_REG 0x28U #define LDO5_CONTROL_REG 0x29U #define LDO6_CONTROL_REG 0x2AU #define BUCK1_PWRCTRL_REG 0x30U #define BUCK2_PWRCTRL_REG 0x31U #define BUCK3_PWRCTRL_REG 0x32U #define BUCK4_PWRCTRL_REG 0x33U #define VREF_DDR_PWRCTRL_REG 0x34U #define LDO1_PWRCTRL_REG 0x35U #define LDO2_PWRCTRL_REG 0x36U #define LDO3_PWRCTRL_REG 0x37U #define LDO4_PWRCTRL_REG 0x38U #define LDO5_PWRCTRL_REG 0x39U #define LDO6_PWRCTRL_REG 0x3AU #define FREQUENCY_SPREADING_REG 0x3BU #define USB_CONTROL_REG 0x40U #define ITLATCH1_REG 0x50U #define ITLATCH2_REG 0x51U #define ITLATCH3_REG 0x52U #define ITLATCH4_REG 0x53U #define ITSETLATCH1_REG 0x60U #define ITSETLATCH2_REG 0x61U #define ITSETLATCH3_REG 0x62U #define ITSETLATCH4_REG 0x63U #define ITCLEARLATCH1_REG 0x70U #define ITCLEARLATCH2_REG 0x71U #define ITCLEARLATCH3_REG 0x72U #define ITCLEARLATCH4_REG 0x73U #define ITMASK1_REG 0x80U #define ITMASK2_REG 0x81U #define ITMASK3_REG 0x82U #define ITMASK4_REG 0x83U #define ITSETMASK1_REG 0x90U #define ITSETMASK2_REG 0x91U #define ITSETMASK3_REG 0x92U #define ITSETMASK4_REG 0x93U #define ITCLEARMASK1_REG 0xA0U #define ITCLEARMASK2_REG 0xA1U #define ITCLEARMASK3_REG 0xA2U #define ITCLEARMASK4_REG 0xA3U #define ITSOURCE1_REG 0xB0U #define ITSOURCE2_REG 0xB1U #define ITSOURCE3_REG 0xB2U #define ITSOURCE4_REG 0xB3U /* Registers masks */ #define LDO_VOLTAGE_MASK GENMASK_32(6, 2) #define BUCK_VOLTAGE_MASK GENMASK_32(7, 2) #define LDO_BUCK_VOLTAGE_SHIFT 2 #define LDO_BUCK_ENABLE_POS 0 #define LDO_BUCK_ENABLE_MASK BIT(LDO_BUCK_ENABLE_POS) #define LDO_BUCK_HPLP_POS 1 #define LDO_BUCK_RANK_MASK BIT(0) #define LDO_BUCK_RESET_MASK BIT(0) #define LDO_BUCK_PULL_DOWN_MASK GENMASK_32(1, 0) /* Pull down register */ #define BUCK1_PULL_DOWN_SHIFT 0 #define BUCK2_PULL_DOWN_SHIFT 2 #define BUCK3_PULL_DOWN_SHIFT 4 #define BUCK4_PULL_DOWN_SHIFT 6 #define VREF_DDR_PULL_DOWN_SHIFT 4 /* Buck Mask reset register */ #define BUCK1_MASK_RESET_SHIFT 0 #define BUCK2_MASK_RESET_SHIFT 1 #define BUCK3_MASK_RESET_SHIFT 2 #define BUCK4_MASK_RESET_SHIFT 3 /* LDO Mask reset register */ #define LDO1_MASK_RESET_SHIFT 0 #define LDO2_MASK_RESET_SHIFT 1 #define LDO3_MASK_RESET_SHIFT 2 #define LDO4_MASK_RESET_SHIFT 3 #define LDO5_MASK_RESET_SHIFT 4 #define LDO6_MASK_RESET_SHIFT 5 #define VREF_DDR_MASK_RESET_SHIFT 6 /* Main PMIC Control Register (MAIN_CONTROL_REG) */ #define ICC_EVENT_ENABLED BIT(4) #define PWRCTRL_POLARITY_HIGH BIT(3) #define PWRCTRL_PIN_VALID BIT(2) #define RESTART_REQUEST_ENABLED BIT(1) #define SOFTWARE_SWITCH_OFF_ENABLED BIT(0) /* Main PMIC PADS Control Register (PADS_PULL_REG) */ #define WAKEUP_DETECTOR_DISABLED BIT(4) #define PWRCTRL_PD_ACTIVE BIT(3) #define PWRCTRL_PU_ACTIVE BIT(2) #define WAKEUP_PD_ACTIVE BIT(1) #define PONKEY_PU_ACTIVE BIT(0) /* Main PMIC VINLOW Control Register (VIN_CONTROL_REGC DMSC) */ #define SWIN_DETECTOR_ENABLED BIT(7) #define SWOUT_DETECTOR_ENABLED BIT(6) #define VINLOW_HYST_MASK GENMASK_32(5, 4) #define VINLOW_HYST_SHIFT 4 #define VINLOW_THRESHOLD_MASK GENMASK_32(3, 1) #define VINLOW_THRESHOLD_SHIFT 1 #define VINLOW_ENABLED BIT(0) #define VINLOW_CTRL_REG_MASK GENMASK_32(7, 0) /* USB Control Register */ #define BOOST_OVP_DISABLED_POS 7 #define VBUS_OTG_DETECTION_DISABLED_POS 6 #define OCP_LIMIT_HIGH_POS 3 #define SWIN_SWOUT_ENABLED_POS 2 #define USBSW_OTG_SWITCH_ENABLED_POS 1 #define BOOST_ENABLED_POS 0 /* * Bind SPMIC1 device driver with a specific I2C bus instance * @i2c_handle: target I2C instance to use * @i2c_addr: I2C address of the STPMIC1 device */ void stpmic1_bind_i2c(struct i2c_handle_s *i2c_handle, uint16_t i2c_addr); /* Read STPMIC1 device version information */ int stpmic1_get_version(unsigned long *version); /* Read STPMIC1 device internal registers content */ void stpmic1_dump_regulators(void); /* Enable power control in STPMIC1 device */ int stpmic1_powerctrl_on(void); /* Disable STPMIC1 device */ int stpmic1_switch_off(void); /* Read/write/update STPMIC1 device internal register */ int stpmic1_register_read(uint8_t register_id, uint8_t *value); int stpmic1_register_write(uint8_t register_id, uint8_t value); int stpmic1_register_update(uint8_t register_id, uint8_t value, uint8_t mask); int stpmic1_regulator_mask_reset_set(const char *name); /* API for low power configuration of regulators driven from STPMIC1 device */ int stpmic1_lp_copy_reg(const char *name); int stpmic1_lp_reg_on_off(const char *name, uint8_t enable); int stpmic1_lp_set_mode(const char *name, uint8_t hplp); int stpmic1_lp_set_voltage(const char *name, uint16_t millivolts); /* * Specific API for controlling regulators driven from STPMIC1 device * from unpaged execution context of the STPMIC1 driver. */ /* * The STPMIC1 is accessed during low power sequence in unpaged * execution context. To prevent adding an unpaged constraint on * STPMIC1 regulator definitions, conversion tables and device tree * content, the regulators configurations are read from device tree * at boot time and saved in memory for being applied at runtime * without needing pager support. * * There are 2 types of regulator configuration loaded during such * low power and unpaged sequences: boot-on (bo) configuration and * low power (lp) configuration. */ struct stpmic1_bo_cfg { uint8_t ctrl_reg; uint8_t min_value; uint8_t enable_pos; uint8_t mask; uint8_t pd_reg; uint8_t pd_value; uint8_t pd_mask; uint8_t mrst_reg; uint8_t mrst_value; uint8_t mrst_mask; }; struct stpmic1_lp_cfg { uint8_t ctrl_reg; uint8_t lp_reg; uint8_t value; uint8_t mask; }; int stpmic1_bo_enable_cfg(const char *name, struct stpmic1_bo_cfg *cfg); int stpmic1_bo_enable_unpg(struct stpmic1_bo_cfg *cfg); int stpmic1_bo_voltage_cfg(const char *name, uint16_t min_millivolt, struct stpmic1_bo_cfg *cfg); int stpmic1_bo_voltage_unpg(struct stpmic1_bo_cfg *cfg); int stpmic1_bo_pull_down_cfg(const char *name, struct stpmic1_bo_cfg *cfg); int stpmic1_bo_pull_down_unpg(struct stpmic1_bo_cfg *cfg); int stpmic1_bo_mask_reset_cfg(const char *name, struct stpmic1_bo_cfg *cfg); int stpmic1_bo_mask_reset_unpg(struct stpmic1_bo_cfg *cfg); bool stpmic1_regu_has_lp_cfg(const char *name); int stpmic1_lp_cfg(const char *name, struct stpmic1_lp_cfg *cfg); int stpmic1_lp_load_unpg(struct stpmic1_lp_cfg *cfg); int stpmic1_lp_on_off_unpg(struct stpmic1_lp_cfg *cfg, int enable); int stpmic1_lp_mode_unpg(struct stpmic1_lp_cfg *cfg, unsigned int mode); int stpmic1_lp_voltage_cfg(const char *name, uint16_t millivolts, struct stpmic1_lp_cfg *cfg); int stpmic1_lp_voltage_unpg(struct stpmic1_lp_cfg *cfg); #endif /*__STPMIC1_H__*/