1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /*
3 * Copyright (c) 2011-2016 Zhang, Keguang <keguang.zhang@gmail.com>
4 */
5
6 #include <linux/clk.h>
7 #include <linux/dma-mapping.h>
8 #include <linux/err.h>
9 #include <linux/mtd/partitions.h>
10 #include <linux/sizes.h>
11 #include <linux/phy.h>
12 #include <linux/serial_8250.h>
13 #include <linux/stmmac.h>
14 #include <linux/usb/ehci_pdriver.h>
15
16 #include <platform.h>
17 #include <loongson1.h>
18 #include <dma.h>
19 #include <nand.h>
20
21 /* 8250/16550 compatible UART */
22 #define LS1X_UART(_id) \
23 { \
24 .mapbase = LS1X_UART ## _id ## _BASE, \
25 .irq = LS1X_UART ## _id ## _IRQ, \
26 .iotype = UPIO_MEM, \
27 .flags = UPF_IOREMAP | UPF_FIXED_TYPE, \
28 .type = PORT_16550A, \
29 }
30
31 static struct plat_serial8250_port ls1x_serial8250_pdata[] = {
32 LS1X_UART(0),
33 LS1X_UART(1),
34 LS1X_UART(2),
35 LS1X_UART(3),
36 {},
37 };
38
39 struct platform_device ls1x_uart_pdev = {
40 .name = "serial8250",
41 .id = PLAT8250_DEV_PLATFORM,
42 .dev = {
43 .platform_data = ls1x_serial8250_pdata,
44 },
45 };
46
ls1x_serial_set_uartclk(struct platform_device * pdev)47 void __init ls1x_serial_set_uartclk(struct platform_device *pdev)
48 {
49 struct clk *clk;
50 struct plat_serial8250_port *p;
51
52 clk = clk_get(&pdev->dev, pdev->name);
53 if (IS_ERR(clk)) {
54 pr_err("unable to get %s clock, err=%ld",
55 pdev->name, PTR_ERR(clk));
56 return;
57 }
58 clk_prepare_enable(clk);
59
60 for (p = pdev->dev.platform_data; p->flags != 0; ++p)
61 p->uartclk = clk_get_rate(clk);
62 }
63
64 /* Synopsys Ethernet GMAC */
65 static struct stmmac_mdio_bus_data ls1x_mdio_bus_data = {
66 .phy_mask = 0,
67 };
68
69 static struct stmmac_dma_cfg ls1x_eth_dma_cfg = {
70 .pbl = 1,
71 };
72
ls1x_eth_mux_init(struct platform_device * pdev,void * priv)73 int ls1x_eth_mux_init(struct platform_device *pdev, void *priv)
74 {
75 struct plat_stmmacenet_data *plat_dat = NULL;
76 u32 val;
77
78 val = __raw_readl(LS1X_MUX_CTRL1);
79
80 #if defined(CONFIG_LOONGSON1_LS1B)
81 plat_dat = dev_get_platdata(&pdev->dev);
82 if (plat_dat->bus_id) {
83 __raw_writel(__raw_readl(LS1X_MUX_CTRL0) | GMAC1_USE_UART1 |
84 GMAC1_USE_UART0, LS1X_MUX_CTRL0);
85 switch (plat_dat->phy_interface) {
86 case PHY_INTERFACE_MODE_RGMII:
87 val &= ~(GMAC1_USE_TXCLK | GMAC1_USE_PWM23);
88 break;
89 case PHY_INTERFACE_MODE_MII:
90 val |= (GMAC1_USE_TXCLK | GMAC1_USE_PWM23);
91 break;
92 default:
93 pr_err("unsupported mii mode %d\n",
94 plat_dat->phy_interface);
95 return -ENOTSUPP;
96 }
97 val &= ~GMAC1_SHUT;
98 } else {
99 switch (plat_dat->phy_interface) {
100 case PHY_INTERFACE_MODE_RGMII:
101 val &= ~(GMAC0_USE_TXCLK | GMAC0_USE_PWM01);
102 break;
103 case PHY_INTERFACE_MODE_MII:
104 val |= (GMAC0_USE_TXCLK | GMAC0_USE_PWM01);
105 break;
106 default:
107 pr_err("unsupported mii mode %d\n",
108 plat_dat->phy_interface);
109 return -ENOTSUPP;
110 }
111 val &= ~GMAC0_SHUT;
112 }
113 __raw_writel(val, LS1X_MUX_CTRL1);
114 #elif defined(CONFIG_LOONGSON1_LS1C)
115 plat_dat = dev_get_platdata(&pdev->dev);
116
117 val &= ~PHY_INTF_SELI;
118 if (plat_dat->phy_interface == PHY_INTERFACE_MODE_RMII)
119 val |= 0x4 << PHY_INTF_SELI_SHIFT;
120 __raw_writel(val, LS1X_MUX_CTRL1);
121
122 val = __raw_readl(LS1X_MUX_CTRL0);
123 __raw_writel(val & (~GMAC_SHUT), LS1X_MUX_CTRL0);
124 #endif
125
126 return 0;
127 }
128
129 static struct plat_stmmacenet_data ls1x_eth0_pdata = {
130 .bus_id = 0,
131 .phy_addr = -1,
132 #if defined(CONFIG_LOONGSON1_LS1B)
133 .phy_interface = PHY_INTERFACE_MODE_MII,
134 #elif defined(CONFIG_LOONGSON1_LS1C)
135 .phy_interface = PHY_INTERFACE_MODE_RMII,
136 #endif
137 .mdio_bus_data = &ls1x_mdio_bus_data,
138 .dma_cfg = &ls1x_eth_dma_cfg,
139 .has_gmac = 1,
140 .tx_coe = 1,
141 .rx_queues_to_use = 1,
142 .tx_queues_to_use = 1,
143 .init = ls1x_eth_mux_init,
144 };
145
146 static struct resource ls1x_eth0_resources[] = {
147 [0] = {
148 .start = LS1X_GMAC0_BASE,
149 .end = LS1X_GMAC0_BASE + SZ_64K - 1,
150 .flags = IORESOURCE_MEM,
151 },
152 [1] = {
153 .name = "macirq",
154 .start = LS1X_GMAC0_IRQ,
155 .flags = IORESOURCE_IRQ,
156 },
157 };
158
159 struct platform_device ls1x_eth0_pdev = {
160 .name = "stmmaceth",
161 .id = 0,
162 .num_resources = ARRAY_SIZE(ls1x_eth0_resources),
163 .resource = ls1x_eth0_resources,
164 .dev = {
165 .platform_data = &ls1x_eth0_pdata,
166 },
167 };
168
169 #ifdef CONFIG_LOONGSON1_LS1B
170 static struct plat_stmmacenet_data ls1x_eth1_pdata = {
171 .bus_id = 1,
172 .phy_addr = -1,
173 .phy_interface = PHY_INTERFACE_MODE_MII,
174 .mdio_bus_data = &ls1x_mdio_bus_data,
175 .dma_cfg = &ls1x_eth_dma_cfg,
176 .has_gmac = 1,
177 .tx_coe = 1,
178 .rx_queues_to_use = 1,
179 .tx_queues_to_use = 1,
180 .init = ls1x_eth_mux_init,
181 };
182
183 static struct resource ls1x_eth1_resources[] = {
184 [0] = {
185 .start = LS1X_GMAC1_BASE,
186 .end = LS1X_GMAC1_BASE + SZ_64K - 1,
187 .flags = IORESOURCE_MEM,
188 },
189 [1] = {
190 .name = "macirq",
191 .start = LS1X_GMAC1_IRQ,
192 .flags = IORESOURCE_IRQ,
193 },
194 };
195
196 struct platform_device ls1x_eth1_pdev = {
197 .name = "stmmaceth",
198 .id = 1,
199 .num_resources = ARRAY_SIZE(ls1x_eth1_resources),
200 .resource = ls1x_eth1_resources,
201 .dev = {
202 .platform_data = &ls1x_eth1_pdata,
203 },
204 };
205 #endif /* CONFIG_LOONGSON1_LS1B */
206
207 /* GPIO */
208 static struct resource ls1x_gpio0_resources[] = {
209 [0] = {
210 .start = LS1X_GPIO0_BASE,
211 .end = LS1X_GPIO0_BASE + SZ_4 - 1,
212 .flags = IORESOURCE_MEM,
213 },
214 };
215
216 struct platform_device ls1x_gpio0_pdev = {
217 .name = "ls1x-gpio",
218 .id = 0,
219 .num_resources = ARRAY_SIZE(ls1x_gpio0_resources),
220 .resource = ls1x_gpio0_resources,
221 };
222
223 static struct resource ls1x_gpio1_resources[] = {
224 [0] = {
225 .start = LS1X_GPIO1_BASE,
226 .end = LS1X_GPIO1_BASE + SZ_4 - 1,
227 .flags = IORESOURCE_MEM,
228 },
229 };
230
231 struct platform_device ls1x_gpio1_pdev = {
232 .name = "ls1x-gpio",
233 .id = 1,
234 .num_resources = ARRAY_SIZE(ls1x_gpio1_resources),
235 .resource = ls1x_gpio1_resources,
236 };
237
238 /* USB EHCI */
239 static u64 ls1x_ehci_dmamask = DMA_BIT_MASK(32);
240
241 static struct resource ls1x_ehci_resources[] = {
242 [0] = {
243 .start = LS1X_EHCI_BASE,
244 .end = LS1X_EHCI_BASE + SZ_32K - 1,
245 .flags = IORESOURCE_MEM,
246 },
247 [1] = {
248 .start = LS1X_EHCI_IRQ,
249 .flags = IORESOURCE_IRQ,
250 },
251 };
252
253 static struct usb_ehci_pdata ls1x_ehci_pdata = {
254 };
255
256 struct platform_device ls1x_ehci_pdev = {
257 .name = "ehci-platform",
258 .id = -1,
259 .num_resources = ARRAY_SIZE(ls1x_ehci_resources),
260 .resource = ls1x_ehci_resources,
261 .dev = {
262 .dma_mask = &ls1x_ehci_dmamask,
263 .platform_data = &ls1x_ehci_pdata,
264 },
265 };
266
267 /* Real Time Clock */
ls1x_rtc_set_extclk(struct platform_device * pdev)268 void __init ls1x_rtc_set_extclk(struct platform_device *pdev)
269 {
270 u32 val = __raw_readl(LS1X_RTC_CTRL);
271
272 if (!(val & RTC_EXTCLK_OK))
273 __raw_writel(val | RTC_EXTCLK_EN, LS1X_RTC_CTRL);
274 }
275
276 struct platform_device ls1x_rtc_pdev = {
277 .name = "ls1x-rtc",
278 .id = -1,
279 };
280
281 /* Watchdog */
282 static struct resource ls1x_wdt_resources[] = {
283 {
284 .start = LS1X_WDT_BASE,
285 .end = LS1X_WDT_BASE + SZ_16 - 1,
286 .flags = IORESOURCE_MEM,
287 },
288 };
289
290 struct platform_device ls1x_wdt_pdev = {
291 .name = "ls1x-wdt",
292 .id = -1,
293 .num_resources = ARRAY_SIZE(ls1x_wdt_resources),
294 .resource = ls1x_wdt_resources,
295 };
296