Searched refs:GPIO (Results 1 – 13 of 13) sorted by relevance
| /arm-trusted-firmware-2.8.0/include/dt-bindings/pinctrl/ |
| A D | stm32-pinfunc.h | 11 #define GPIO 0x0 macro
|
| /arm-trusted-firmware-2.8.0/include/drivers/nxp/gpio/ |
| A D | nxp_gpio.h | 38 #error Please define GPIO register endianness
|
| /arm-trusted-firmware-2.8.0/include/plat/marvell/armada/a8k/common/ |
| A D | armada_common.h | 32 GPIO, enumerator
|
| /arm-trusted-firmware-2.8.0/plat/marvell/armada/a8k/a70x0/board/ |
| A D | marvell_plat_config.c | 138 .detection_method = GPIO,
|
| /arm-trusted-firmware-2.8.0/plat/marvell/armada/a8k/a70x0_amc/board/ |
| A D | marvell_plat_config.c | 135 .detection_method = GPIO,
|
| /arm-trusted-firmware-2.8.0/plat/marvell/armada/a8k/a80x0/board/ |
| A D | marvell_plat_config.c | 189 .detection_method = GPIO,
|
| /arm-trusted-firmware-2.8.0/docs/plat/marvell/armada/ |
| A D | porting.rst | 52 - GPIO
68 implemented using GPIO: mpp 33 (SW5).
76 Press reset and keep pressing the button connected to the chosen GPIO pin. A
|
| /arm-trusted-firmware-2.8.0/plat/nxp/soc-lx2160a/ |
| A D | soc.def | 57 # Defining the endianness for NXP GPIO
|
| /arm-trusted-firmware-2.8.0/docs/plat/nxp/ |
| A D | nxp-ls-fuse-prov.rst | 11 | | Platform | Jumper | Switch | LED to Verify | Through GPIO Pin (=number) |
203 Note: If GPIO Pin supports enabling POVDD, it can be done through the below input_fuse_file.
|
| /arm-trusted-firmware-2.8.0/plat/marvell/armada/a8k/common/ |
| A D | plat_ble_setup.c | 696 case GPIO: in ble_skip_current_image()
|
| /arm-trusted-firmware-2.8.0/ |
| A D | changelog.yaml | 1047 - title: GPIO
|
| /arm-trusted-firmware-2.8.0/docs/ |
| A D | change-log.md | 1523 - **GPIO**
3142 - GPIO, NCDI, SPMC drivers
3154 - following drivers: SD, EMMC, QSPI, FLEXSPI, GPIO, GIC, CSU, PMU, DDR
4208 - rpi3: Include GPIO driver in all BL stages and use same "clock-less" setup
4335 - rpi3: gpio: Simplify GPIO setup
4404 - allwinner: Fix H6 GPIO and CCU memory map addresses and incorrect ARISC code
|
| /arm-trusted-firmware-2.8.0/docs/getting_started/ |
| A D | porting-guide.rst | 534 If the platform port uses the PL061 GPIO driver, the following constant may
539 much memory is allocated for PL061 GPIO controllers. The default value is
|
Completed in 30 milliseconds