Searched refs:ATA (Results 1 – 25 of 62) sorted by relevance
123
14 menuconfig ATA config15 tristate "Serial ATA and Parallel ATA drivers (libata)"21 If you want to use an ATA hard disk, ATA tape drive, ATA CD-ROM or24 that "speaks" the ATA protocol, also called ATA controller),32 if ATA44 bool "Verbose ATA error reporting"71 bool "ATA ACPI Support"402 bool "ATA BMDMA support"785 ATA layer.1179 ATA controllers via the new ATA layer[all …]
12 transports for ATA and ATAPI devices, and SCSI<->ATA translation for ATA24 with the ATA and SCSI layers.35 Disable ATA port123 ATA command execute175 Select ATA device on bus463 ATA NO DATA or DMA468 ATA PIO569 Errors which aren't ATA device errors are treated as ATA device800 Note that ATA bus errors can be reported as ATA device NCQ errors. This807 ATA bus error[all …]
18 bool "ATA support for libsas (requires libata)"20 depends on ATA = y || ATA = SCSI_SAS_LIBSAS23 Builds in ATA support into libsas. Will necessitate
27 ATA, /* ATA */ enumerator39 INTC_IRQ(ATA, IRQ_ATA),48 { BUTTON, POWER, FATA, ATA,
7 title: Generic Parallel ATA Controller13 Generic Parallel ATA controllers supporting PIO modes only.39 description: Maximum ATA PIO transfer mode
7 title: Common Properties for Serial ATA AHCI controllers16 conform to the technical standard defined by Intel (see Serial ATA29 Generic AHCI registers space conforming to the Serial ATA AHCI
3 SATA nodes are defined to describe on-chip Serial ATA controllers.
10 SATA nodes are defined to describe on-chip Serial ATA controllers.
14 ATA (PATA, also known as IDE) AT attachment storage devices.
14 a CompactFlash card to the system as a true IDE (parallel ATA) device. The
7 title: Renesas R-Car Serial-ATA Interface
1 MediaTek Serial ATA controller
14 optional for some drivers (like ATA), but required for24 This option enables the support for the ATA task.
11 Information technology - AT Attachment 8 - ATA/ATAPI Command Set (ATA8-ACS)17 Information technology - SCSI / ATA Translation - 5 (SAT-5)26 If supported, it uses the ATA SCT Command Transport feature to read
21 ATA/ATAPI-7 specifies the IDLE IMMEDIATE command with unload feature.39 For each ATA device, the kernel exports the file76 reality. In fact, the ATA specs clearly state that the time for an77 unload operation to complete is vendor specific. The hint in ATA-779 been dropped in ATA-8.109 version of the ATA standard than ATA-7, but do support the unload
2 ATA over Ethernet (AoE)
4 ATA over Ethernet is a network protocol that provides simple access to52 limit ATA over Ethernet traffic to eth2 and eth4. AoE traffic from127 all network interfaces may be used for ATA over Ethernet. Here is a
12 Because ATA over Ethernet is not fragmented by the kernel's IP code,
16 select ATA_NONSTANDARD if ATA
38 libata: Un-break ATA blacklist
8 depends on ATA
65 tristate "ISD-200 USB/ATA Bridge support"68 on the In-Systems Design ISD-200 USB/ATA bridge.167 tristate "SAT emulation on Cypress USB/ATA Bridge with ATACB"170 on the Cypress USB/ATA bridge supporting ATACB. This will allow you
123 ATA drive identity information. For full description, see125 the ATA specification.171 If you don't have a copy of the ANSI ATA specification174 - Execute an ATA disk command directly by writing the "taskfile"397 Note: If you don't have a copy of the ANSI ATA specification472 Note: If you don't have a copy of the ANSI ATA specification
3 Provide a place in sysfs for storing the ATA topology of the4 system. This allows retrieving various information about ATA
Completed in 28 milliseconds