Home
last modified time | relevance | path

Searched refs:BT (Results 1 – 25 of 140) sorted by relevance

123456

/linux-6.3-rc2/Documentation/scsi/
A DFlashPoint.rst78 BusLogic FlashPoint LT/BT-948 Upgrade Program
82 BusLogic FlashPoint LW/BT-958 Upgrade Program
99 customers to make sure the BT-946C/956C MultiMaster cards would still be
101 the FlashPoint would be able to upgrade to the BT-946C. While this helped
135 to trade in their FlashPoint LT for the new BT-948 MultiMaster PCI Ultra
136 SCSI Host Adapter. The BT-948 is the Ultra SCSI successor to the BT-946C
137 and has all the best features of both the BT-946C and FlashPoint LT,
148 LW (BT-950) for a BT-958 MultiMaster PCI Ultra SCSI Host Adapter. The
152 my BusLogic driver already included latent support for the BT-948/958.
169 from the unsupported FlashPoint LT (BT-930) to the supported BT-948 for US
[all …]
A DBusLogic.rst69 the BT-948 PCI Ultra SCSI Host Adapter, and then again for the BT-958 PCI Wide
227 FlashPoint LT (BT-920) Ultra SCSI-3 (BT-930 without BIOS)
239 BT-948 PCI Ultra SCSI-3
240 BT-958 PCI Wide Ultra SCSI-3
247 BT-946C PCI Fast SCSI-2
248 BT-956C PCI Wide Fast SCSI-2
250 BT-445C VLB Fast SCSI-2
251 BT-747C EISA Fast SCSI-2
252 BT-757C EISA Wide Fast SCSI-2
259 BT-445S VLB Fast SCSI-2
[all …]
/linux-6.3-rc2/net/bluetooth/
A DKconfig6 menuconfig BT config
49 depends on BT
75 depends on BT
100 depends on BT
109 depends on BT
116 depends on BT
123 depends on BT && DEBUG_FS
131 depends on BT && DEBUG_KERNEL
158 depends on BT && !DYNAMIC_DEBUG
/linux-6.3-rc2/Documentation/devicetree/bindings/net/
A Drealtek-bluetooth.yaml14 RTL8723CS/RTL8723CS/RTL8822CS is WiFi + BT chip. WiFi part is connected over
15 SDIO, while BT is connected over serial. It speaks H5 protocol with few
28 description: GPIO specifier, used to wakeup the BT module
32 description: GPIO specifier, used to enable the BT module
A Dnokia-bluetooth.txt16 - reset-gpios: GPIO specifier, used to reset the BT module (active low)
17 - bluetooth-wakeup-gpios: GPIO specifier, used to wakeup the BT module (active high)
29 /* controlled (enabled/disabled) directly by BT module */
A Dti,bluetooth.yaml18 * TI WiLink 7/8 (wl12xx/wl18xx) Shared Transport BT/FM/GPS devices
22 standard BT HCI protocol with additional channels for the other functions.
/linux-6.3-rc2/drivers/net/ethernet/intel/i40e/
A Di40e_dcb.h176 #define I40E_BT2KB(BT) (((BT) + (8 * 1024 - 1)) / (8 * 1024)) argument
177 #define I40E_B2BT(BT) ((BT) * 8) argument
178 #define I40E_BT2B(BT) (((BT) + (8 - 1)) / 8) argument
/linux-6.3-rc2/Documentation/userspace-api/media/v4l/
A Dbiblio.rst70 ITU BT.470
74 :title: ITU-R Recommendation BT.470-6 "Conventional Television Systems"
80 ITU BT.601
84 :title: ITU-R Recommendation BT.601-5 "Studio Encoding Parameters of Digital Television for Sta…
90 ITU BT.653
94 :title: ITU-R Recommendation BT.653-3 "Teletext systems"
100 ITU BT.709
104 :title: ITU-R Recommendation BT.709-5 "Parameter values for the HDTV standards for production a…
110 ITU BT.1119
114 :title: ITU-R Recommendation BT.1119 "625-line television Wide Screen Signalling (WSS)"
[all …]
A Dcolorspaces-defs.rst118 - Use the BT.601 Y'CbCr encoding.
122 - Use the extended gamut xvYCC BT.601 encoding.
126 - Use the default non-constant luminance BT.2020 Y'CbCr encoding.
128 - Use the constant luminance BT.2020 Yc'CbcCrc encoding.
A Dcolorspaces-details.rst80 BT.601 as well, even though BT.601 does not mention any color primaries.
119 The full name of this standard is Rec. ITU-R BT.709-5.
161 in which case the BT.601 Y'CbCr encoding is used.
180 similar to the BT.601 encoding, but it allows for R', G' and B' values
278 170M/BT.601. The Y'CbCr quantization is limited range.
347 170M/BT.601. The Y'CbCr quantization is limited range.
352 Colorspace BT.2020 (V4L2_COLORSPACE_BT2020)
361 .. flat-table:: BT.2020 Chromaticities
640 identical to one defined in SMPTE 170M/BT.601.
711 identical to one defined in SMPTE 170M/BT.601.
/linux-6.3-rc2/Documentation/devicetree/bindings/ipmi/
A Daspeed,ast2400-ibt-bmc.txt1 * Aspeed BT (Block Transfer) IPMI interface
4 (BaseBoard Management Controllers) and the BT interface can be used to
18 - interrupts: interrupt generated by the BT interface. without an
/linux-6.3-rc2/arch/arm/boot/dts/
A Dsun8i-h2-plus-bananapi-m2-zero.dts242 "WL-SDIO-D2", "WL-SDIO-D3", "BT-UART-TX", "BT-UART-RX",
243 "BT-UART-RTS", "BT-UART-CTS", "WL-WAKE-AP", "BT-WAKE-AP",
244 "BT-RST-N", "AP-WAKE-BT", "", "",
A Dimx6ull-dhcom-som-cfg-sdcard.dtsi13 * Disabled: WiFi and BT
18 * BT is also not available, so remove BT from the UART node.
A Dbcm2837-rpi-3-a-plus.dts80 /* Used by BT module */
142 /* uart0 communicates with the BT module
144 * WL_REG_ON and BT_REG_ON of the CYW43455 Wifi/BT module are driven
A Dbcm2837-rpi-3-b.dts86 /* Used by BT module */
131 /* uart0 communicates with the BT module */
A Dbcm2837-rpi-3-b-plus.dts86 /* Used by BT module */
148 /* uart0 communicates with the BT module */
A Dbcm283x-rpi-wifi-bt.dtsi26 /* uart0 communicates with the BT module */
/linux-6.3-rc2/drivers/net/wireless/rsi/
A DKconfig48 bool "Redpine Signals WLAN BT Coexistence support"
49 depends on BT && RSI_91X
50 depends on !(BT=m && RSI_91X=y)
53 This option enables the WLAN BT coex support in rsi drivers.
/linux-6.3-rc2/Documentation/devicetree/bindings/clock/
A Dsamsung,s2mps11.yaml16 The S2MPS11/13/15 and S5M8767 provide three(AP/CP/BT) buffered 32.768 kHz
17 outputs. The S2MPS14 provides two (AP/BT) buffered 32.768 KHz outputs.
38 description: Names for AP, CP and BT clocks.
/linux-6.3-rc2/drivers/misc/ti-st/
A DKconfig4 # drivers (BT, FM and GPS)
14 BT / FM and GPS combo chips. This enables protocol drivers
/linux-6.3-rc2/arch/nios2/include/asm/
A Dasm-macros.h78 .macro BT reg1, reg2, bit
98 BT \reg1, \reg2, \bit
110 BT \reg1, \reg2, \bit
/linux-6.3-rc2/arch/arm64/boot/dts/allwinner/
A Dsun50i-h6-orangepi-lite2.dts11 serial1 = &uart1; /* BT-UART */
58 /* There's the BT part of the AP6255 connected to that UART */
/linux-6.3-rc2/Documentation/driver-api/media/
A Dtx-rx.rst28 `BT.601`_ and `BT.656`_ are the most common parallel busses.
30 .. _`BT.601`: https://en.wikipedia.org/wiki/Rec._601
31 .. _`BT.656`: https://en.wikipedia.org/wiki/ITU-R_BT.656
/linux-6.3-rc2/Documentation/sound/soc/
A Ddpcm.rst38 PCM3 <------------> * * <----DAI3-----> BT
69 PCM3 <------------> * * <----DAI3-----> BT
86 PCM3 <------------> * * <----DAI3-----> BT
139 PCM3 <------------> * * <----DAI3-----> BT
204 like a BT phone call :-
214 PCM3 <------------> * * <====DAI3=====> BT
221 This allows the host CPU to sleep while the DSP, MODEM DAI and the BT DAI are
322 PCM3 <------------> * * <----DAI3-----> BT
/linux-6.3-rc2/drivers/char/ipmi/
A DKconfig66 Provides a driver for System Interfaces (KCS, SMIC, BT).
166 tristate "BT IPMI bmc driver"
168 Provides a driver for the BT (Block Transfer) IPMI interface
170 implements the BMC side of the BT interface.

Completed in 32 milliseconds

123456