| /linux-6.3-rc2/drivers/net/wireless/ath/ath9k/ |
| A D | ar9003_eeprom.c | 570 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 1),
571 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 0),
576 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 1),
577 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 0),
582 CTL(60, 0), CTL(60, 1), CTL(60, 0), CTL(60, 1),
583 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 1),
588 CTL(60, 0), CTL(60, 1), CTL(60, 1), CTL(60, 0),
589 CTL(60, 1), CTL(60, 0), CTL(60, 0), CTL(60, 0),
594 CTL(60, 1), CTL(60, 1), CTL(60, 1), CTL(60, 0),
595 CTL(60, 0), CTL(60, 0), CTL(60, 0), CTL(60, 0),
[all …]
|
| /linux-6.3-rc2/sound/pci/lola/ |
| A D | lola_pcm.c | 64 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_start()
75 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_stop()
88 val = lola_dsd_read(chip, str->dsd, CTL); in wait_for_srst_clear()
163 lola_dsd_write(chip, str->dsd, CTL, LOLA_DSD_CTL_SRUN | in lola_sync_pause()
175 lola_dsd_write(chip, str->dsd, CTL, in lola_stream_reset()
179 lola_dsd_write(chip, str->dsd, CTL, LOLA_DSD_CTL_SRST); in lola_stream_reset()
443 lola_dsd_write(chip, str->dsd, CTL, in lola_setup_controller()
|
| A D | lola_proc.c | 186 lola_dsd_read(chip, i, CTL)); in lola_proc_regs_read()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/net/ |
| A D | micrel-ksz90x1.txt | 49 - rxdv-skew-ps : Skew control of RX CTL pad
51 - txen-skew-ps : Skew control of TX CTL pad
142 - rxdv-skew-ps : Skew control of RX CTL pad
143 - txen-skew-ps : Skew control of TX CTL pad
176 - rxdv-skew-psec : Skew control of RX CTL pad
177 - txen-skew-psec : Skew control of TX CTL pad
|
| /linux-6.3-rc2/drivers/char/xilinx_hwicap/ |
| A D | xilinx_hwicap.c | 126 .CTL = 5,
151 .CTL = 5,
176 .CTL = 5,
201 .CTL = 5,
|
| A D | xilinx_hwicap.h | 130 u32 CTL; member
|
| /linux-6.3-rc2/drivers/net/wan/ |
| A D | hd64570.h | 63 #define CTL 0x11 /* Control */ macro
|
| A D | c101.c | 184 sca_out(0, MSCI1_OFFSET + CTL, port); /* RTS uses ch#2 output */ in c101_open()
206 sca_out(CTL_NORTS, MSCI1_OFFSET + CTL, port); in c101_close()
|
| A D | hd64572.h | 64 #define CTL 0x130 /* Control reg */ macro
|
| A D | hd64572.c | 459 sca_out(CTL_IDLE | CTL_URCT | CTL_URSKP, msci + CTL, card); in sca_open()
|
| A D | hd64570.c | 501 sca_out(CTL_IDLE, msci + CTL, card); in sca_open()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/memory-controllers/fsl/ |
| A D | imx8m-ddrc.yaml | 36 Base address and size of DDRC CTL area.
|
| /linux-6.3-rc2/sound/soc/qcom/ |
| A D | lpass-lpaif-reg.h | 159 __LPAIF_CDC_DMA_REG(v, chan, dir, CTL, dai_id) : \
160 __LPAIF_DMA_REG(v, chan, dir, CTL, dai_id))
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-bus-coresight-devices-etb10 | 66 is read directly from HW register CTL, 0x020.
|
| A D | sysfs-bus-coresight-devices-tmc | 54 is read directly from HW register CTL, 0x020.
|
| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | intel-ixp42x-gateworks-gw2348.dts | 100 /* First register set is CMD second is CTL (notice it uses CS2) */
|
| A D | intel-ixp43x-gateworks-gw2358.dts | 116 /* First register set is CMD second is CTL */
|
| /linux-6.3-rc2/drivers/media/dvb-frontends/ |
| A D | bcm3510_priv.h | 29 u8 CTL :8; member
|
| A D | bcm3510.c | 746 v.TSTCTL_2e.CTL = 0; in bcm3510_init_cold()
|
| /linux-6.3-rc2/drivers/usb/gadget/udc/ |
| A D | atmel_usba_udc.c | 1438 epctrl = usba_ep_readl(ep, CTL); in usba_control_irq()
1625 epctrl = usba_ep_readl(ep, CTL); in usba_ep_irq()
1663 epctrl = usba_ep_readl(ep, CTL); in usba_ep_irq()
|
| /linux-6.3-rc2/drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
| A D | fwsignal.c | 981 brcmf_dbg(CTL, "rssi %d\n", rssi); in brcmf_fws_rssi_indicate()
1590 brcmf_dbg(CTL, "received: seq %d, timestamp %d\n", data[1], in brcmf_fws_dbg_seqnum_check()
|
| A D | sdio.c | 3271 brcmf_dbg(CTL, "resumed on rxctl frame, got %d expected %d\n", in brcmf_sdio_bus_rxctl()
3277 brcmf_dbg(CTL, "cancelled\n"); in brcmf_sdio_bus_rxctl()
3280 brcmf_dbg(CTL, "resumed for unknown reason?\n"); in brcmf_sdio_bus_rxctl()
|