| /linux-6.3-rc2/arch/parisc/include/asm/ |
| A D | led.h | 10 #define LED2 0x04 macro
16 #define LED_DISK_IO LED2 /* for disk activity */
|
| /linux-6.3-rc2/drivers/iio/health/ |
| A D | afe4404.c | 99 LED2 = 1, enumerator
108 [LED2] = AFE440X_LED2VAL,
117 [LED2] = F_ILED2,
123 [LED2] = F_OFFDAC_LED2,
131 AFE440X_INTENSITY_CHAN(LED2, BIT(IIO_CHAN_INFO_OFFSET)),
138 AFE440X_CURRENT_CHAN(LED2),
|
| A D | afe4403.c | 83 LED2 = 1, enumerator
92 [LED2] = AFE440X_LED2VAL,
101 [LED2] = F_ILED2,
107 AFE440X_INTENSITY_CHAN(LED2, 0),
114 AFE440X_CURRENT_CHAN(LED2),
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-bus-iio-health-afe440x | 11 1 LED2
17 Note that channels 5 and 6 represent LED2-ALED2 and LED1-ALED1
|
| /linux-6.3-rc2/drivers/leds/ |
| A D | leds-bd2802.c | 40 LED2, enumerator
224 reg = bd2802_get_reg_addr(LED2, RED, BD2802_REG_HOURSETUP); in bd2802_configure()
237 enum led_ids other_led = (id == LED1) ? LED2 : LED1; in bd2802_enable()
551 BD2802_CONTROL_RGBS(led2r, LED2, RED);
552 BD2802_CONTROL_RGBS(led2g, LED2, GREEN);
553 BD2802_CONTROL_RGBS(led2b, LED2, BLUE);
|
| /linux-6.3-rc2/include/linux/mfd/ |
| A D | tps65010.h | 113 #define LED2 2 macro
|
| /linux-6.3-rc2/arch/arc/boot/dts/ |
| A D | abilis_tb101_dvk.dts | 65 label = "LED2";
|
| A D | abilis_tb100_dvk.dts | 65 label = "LED2";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/leds/ |
| A D | leds-mt6323.txt | 56 label = "LED2";
|
| A D | leds-lm3692x.txt | 29 2 - Will enable the LED2 sync
|
| /linux-6.3-rc2/arch/arm/mach-omap1/ |
| A D | board-osk.c | 224 tps65010_set_led(LED2, OFF); in osk_tps_setup()
|
| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | s3c6410-mini6410.dts | 136 label = "LED2";
|
| A D | imx6qdl-solidsense.dtsi | 64 /* Red/Green LED2 - next to GPS SMA */
|
| A D | sun4i-a10-cubieboard.dts | 85 gpios = <&pio 7 20 GPIO_ACTIVE_HIGH>; /* LED2 */
|
| A D | imx6dl-plybas.dts | 319 /* LED2 (lighttower) */
|
| A D | sh73a0-kzm9g.dts | 89 label = "LED2";
|
| A D | omap3-devkit8000-common.dtsi | 27 gpios = <&gpio6 3 GPIO_ACTIVE_HIGH>; /* 163 -> LED2 */
|
| A D | imx6q-marsboard.dts | 322 MX6QDL_PAD_EIM_D28__GPIO3_IO28 0x1b0b1 /* LED2 */
|
| A D | armada-385-clearfog-gtr.dtsi | 54 52 - Front LED2, or front panel
|
| /linux-6.3-rc2/drivers/usb/gadget/udc/ |
| A D | net2272.h | 363 #define LED2 26 macro
|
| /linux-6.3-rc2/arch/arm64/boot/dts/xilinx/ |
| A D | zynqmp-sm-k26-revA.dts | 254 "QSPI_CS_B", "SPI_CLK", "LED1", "LED2", "SPI_CS_B", /* 5 - 9 */
|
| /linux-6.3-rc2/drivers/pinctrl/cirrus/ |
| A D | pinctrl-lochnagar.c | 209 LN1_PIN_MUX(LED2, "led2");
310 LN1_PIN(LED1), LN1_PIN(LED2),
648 LN1_GROUP_PIN(LED1), LN1_GROUP_PIN(LED2),
|
| /linux-6.3-rc2/arch/arm64/boot/dts/renesas/ |
| A D | r8a774c0-cat874.dts | 55 label = "LED2";
|
| /linux-6.3-rc2/drivers/net/wireless/zydas/zd1211rw/ |
| A D | zd_chip.c | 336 chip->link_led = ((value >> 4) & 1) ? LED1 : LED2; in read_pod()
1321 other_led = chip->link_led == LED1 ? LED2 : LED1; in zd_chip_control_leds()
1326 ioreqs[1].value = v[1] & ~(LED1|LED2); in zd_chip_control_leds()
|
| /linux-6.3-rc2/arch/arm64/boot/dts/actions/ |
| A D | s900-bubblegum-96.dts | 233 "LED2", /* GPIO_139 */
|