| /linux-6.3-rc2/Documentation/devicetree/bindings/sound/ |
| A D | renesas,rz-ssi.yaml | 58 The second cell specifies the encoded MID/RID values of the SSI port
61 bits[0:9] - Specifies MID/RID value of a SSI channel as below
62 MID/RID value of SSI rx0 = 0x256
63 MID/RID value of SSI tx0 = 0x255
64 MID/RID value of SSI rx1 = 0x25a
65 MID/RID value of SSI tx1 = 0x259
66 MID/RID value of SSI rt2 = 0x25f
67 MID/RID value of SSI rx3 = 0x262
68 MID/RID value of SSI tx3 = 0x261
|
| A D | renesas,rsnd.txt | 17 SSI : Serial Sound Interface
25 Multi channel is supported by Multi-SSI, or TDM-SSI.
27 Multi-SSI : 6ch case, you can use stereo x 3 SSI
28 TDM-SSI : 6ch case, you can use TDM
185 But you can't use it if SSI was PIO mode.
192 and these sounds will be merged SSIU/SSI.
211 * SSI (Serial Sound Interface)
242 ** Multi-SSI
244 You can use Multi-SSI.
249 ** TDM-SSI
[all …]
|
| A D | fsl,ssi.txt | 3 The SSI is a serial device that communicates with audio codecs. It can
13 - cell-index: The SSI, <0> = SSI1, <1> = SSI2, and so on.
23 - clocks: "ipg" - Required clock for the SSI unit
24 "baud" - Required clock for SSI master mode. Otherwise this
33 codec connected to this SSI. This node is typically
37 where an incompatible codec is connected to this SSI, e.g.
44 "ac97-slave" - AC97 mode, SSI is clock slave
45 "ac97-master" - AC97 mode, SSI is clock master
47 If specified, the SSI is to be programmed in asynchronous
74 On SOCs that have an SSI, specific DMA channels are hard-wired for playback
|
| A D | renesas,rsnd.yaml | 98 description: References to SSI/SRC/MIX/CTU/DVC/AUDIO_CLK clocks.
226 description: SSI subnode.
255 description: BUSIF is not used when [mem -> SSI] via DMA case
329 <0xec541000 0x1280>, /* SSI */
333 clocks = <&mstp10_clks 1005>, /* SSI-ALL */
|
| A D | eukrea-tlv320.txt | 9 - ssi-controller : The phandle of the SSI controller.
|
| A D | imx-audio-sgtl5000.txt | 9 - ssi-controller : The phandle of the i.MX SSI controller
|
| A D | imx-audio-es8328.txt | 6 - ssi-controller : The phandle of the i.MX SSI controller
|
| A D | fsl,asrc.txt | 6 Ends Audio controller such as ESAI, SSI and SAI. It has three pairs to support
|
| /linux-6.3-rc2/drivers/hsi/clients/ |
| A D | Kconfig | 28 tristate "SSI protocol"
31 If you say Y here, you will enable the SSI protocol aka McSAAB.
36 tristate "HSI/SSI character driver"
39 If you say Y here, you will enable the HSI/SSI character driver.
41 serial communication with the cellular modem over HSI/SSI bus.
|
| /linux-6.3-rc2/drivers/hsi/controllers/ |
| A D | Kconfig | 8 tristate "OMAP SSI hardware driver"
12 SSI is a legacy version of HSI. It is usually used to connect
14 If you say Y here, you will enable the OMAP SSI hardware driver.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/mfd/ |
| A D | hisilicon,hi655x.txt | 4 Between PMIC Hi655x and Hi6220, the physical signal channel is SSI.
9 | Hi6220 | SSI bus | Hi655x |
|
| A D | mc13xxx.txt | 14 - adc-port: Contain PMIC SSI port number used for ADC.
15 - dac-port: Contain PMIC SSI port number used for DAC.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/dma/ |
| A D | fsl,imx-sdma.yaml | 69 - MCU domain SSI: 0
70 - Shared SSI: 1
91 - SSI Dual FIFO: 22
|
| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | gemini-ssi1328.dts | 4 * Device Tree file for SSI 1328
12 model = "SSI 1328";
|
| /linux-6.3-rc2/sound/soc/sh/ |
| A D | Kconfig | 40 tristate "R-Car series SRU/SCU/SSIU/SSI support"
46 This option enables R-Car SRU/SCU/SSIU/SSI sound support
|
| /linux-6.3-rc2/arch/sh/kernel/cpu/sh4a/ |
| A D | setup-sh7780.c | 307 SCIF1, SIOF, HSPI, MMCIF, TMU3, TMU4, TMU5, SSI, FLCTL, GPIO, enumerator
343 INTC_VECT(SSI, 0xe80),
358 SSI, MMCIF, HSPI, SIOF, PCIC5, PCIINTD, PCIINTC, PCIINTB,
373 { 0xffd40018, 0, 32, 8, /* INT2PRI6 */ { SIOF, HSPI, MMCIF, SSI } },
|
| A D | setup-sh7734.c | 363 SSI, enumerator
439 INTC_GROUP(SSI, SSI0, SSI1, SSI2, SSI3),
487 SSI, /* SSI 0-3 */
505 { HUDI, SHDMAC, USB, SSI } },
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/hsi/ |
| A D | omap-ssi.txt | 1 OMAP SSI controller bindings
3 OMAP3's Synchronous Serial Interface (SSI) controller implements a
|
| /linux-6.3-rc2/sound/soc/fsl/ |
| A D | Kconfig | 47 tristate "Synchronous Serial Interface module (SSI) support"
52 Say Y if you want to add Synchronous Serial Interface (SSI)
272 to the SSI interface
284 via SSI/I2S over either SPI or I2C.
322 ESAI/SAI/SSI and connect with external CODECs such as WM8962, CS42888,
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/powerpc/fsl/ |
| A D | dma.txt | 200 DMA driver, such as the SSI sound drivers for the MPC8610. Therefore, any DMA
202 "fsl,elo-dma-channel" or "fsl,eloplus-dma-channel". For the SSI drivers, for
|
| /linux-6.3-rc2/drivers/pinctrl/ |
| A D | pinctrl-xway.c | 689 MFP_XWAY(GPIO34, GPIO, SIN, SSI, NONE),
690 MFP_XWAY(GPIO35, GPIO, SIN, SSI, NONE),
691 MFP_XWAY(GPIO36, GPIO, SIN, SSI, NONE),
902 MFP_XWAY(GPIO34, GPIO, SIN, SSI, NONE),
903 MFP_XWAY(GPIO35, GPIO, SIN, SSI, NONE),
904 MFP_XWAY(GPIO36, GPIO, SIN, SSI, EXIN),
1158 MFP_XWAY(GPIO34, GPIO, NONE, SSI, NONE),
1159 MFP_XWAY(GPIO35, GPIO, NONE, SSI, NONE),
1160 MFP_XWAY(GPIO36, GPIO, NONE, SSI, NONE),
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/clock/ti/ |
| A D | interface.txt | 22 "ti,omap3-ssi-interface-clock" - interface clock with SSI specific HW handling
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/arm/ |
| A D | gemini.yaml | 63 - description: SSI 1328
|
| /linux-6.3-rc2/arch/arm64/boot/dts/renesas/ |
| A D | rz-smarc-common.dtsi | 12 * SSI-WM8978
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/spi/ |
| A D | snps,dw-apb-ssi.yaml | 82 - description: DW APB SSI controller memory mapped registers
|