| /linux-6.3-rc2/drivers/gpio/ |
| A D | gpio-davinci.c | 230 chips = devm_kzalloc(dev, sizeof(*chips), GFP_KERNEL); in davinci_gpio_probe()
231 if (!chips) in davinci_gpio_probe()
240 if (chips->irqs[i] < 0) in davinci_gpio_probe()
265 ret = devm_gpiochip_add_data(dev, &chips->chip, chips); in davinci_gpio_probe()
527 chips); in davinci_gpio_irq_setup()
556 irq = chips->irqs[0]; in davinci_gpio_irq_setup()
562 g = chips->regs[0]; in davinci_gpio_irq_setup()
569 irq_set_handler_data(chips->irqs[gpio], chips); in davinci_gpio_irq_setup()
606 irqdata->chip = chips; in davinci_gpio_irq_setup()
636 g = chips->regs[bank]; in davinci_gpio_save_context()
[all …]
|
| /linux-6.3-rc2/drivers/mtd/chips/ |
| A D | Kconfig | 6 tristate "Detect flash chips by Common Flash Interface (CFI) probe"
18 tristate "Detect non-CFI AMD/JEDEC-compatible flash chips"
26 covers most AMD/Fujitsu-compatible chips and also non-CFI
27 Intel chips.
139 flash chips addressed by each bus cycle, then say 'Y'.
146 flash chips addressed by each bus cycle, then say 'Y'.
153 flash chips addressed by each bus cycle, then say 'Y'.
161 "Protection Registers" present on some flash chips.
213 tristate "Support for RAM chips in bus mapping"
219 tristate "Support for ROM chips in bus mapping"
[all …]
|
| A D | cfi_cmdset_0002.c | 744 cfi->chips[i].buffer_write_time_max = in cfi_cmdset_0002()
750 cfi->chips[i].buffer_write_time_max = in cfi_cmdset_0002()
753 cfi->chips[i].ref_point_counter = 0; in cfi_cmdset_0002()
1502 chip = &cfi->chips[chipnum]; in cfi_amdstd_otp_walk()
2853 map, &cfi->chips[chipnum], adr, 0, in cfi_ppb_unlock()
2922 chip = &cfi->chips[i]; in cfi_amdstd_sync()
2961 chip = &cfi->chips[i]; in cfi_amdstd_sync()
2983 chip = &cfi->chips[i]; in cfi_amdstd_suspend()
3013 chip = &cfi->chips[i]; in cfi_amdstd_suspend()
3038 chip = &cfi->chips[i]; in cfi_amdstd_resume()
[all …]
|
| A D | cfi_cmdset_0001.c | 559 cfi->chips[i].erase_time = in cfi_cmdset_0001()
778 chip = &newcfi->chips[0]; in cfi_intelext_partition_fixup()
783 *chip = cfi->chips[i]; in cfi_intelext_partition_fixup()
1453 chip = &cfi->chips[chipnum]; in cfi_intelext_unpoint()
2040 chip = &cfi->chips[i]; in cfi_intelext_sync()
2059 chip = &cfi->chips[i]; in cfi_intelext_sync()
2336 chip = &cfi->chips[chip_num]; in cfi_intelext_otp_walk()
2522 chip = &cfi->chips[i]; in cfi_intelext_suspend()
2564 chip = &cfi->chips[i]; in cfi_intelext_suspend()
2613 chip = &cfi->chips[i]; in cfi_intelext_resume()
[all …]
|
| /linux-6.3-rc2/drivers/net/wireless/ralink/rt2x00/ |
| A D | Kconfig | 29 Supported chips: RT2460.
41 Supported chips: RT2560.
56 Supported chips: RT2561, RT2561S & RT2661.
86 Supported chips: RT3390
103 Supported chips: RT5390
111 Supported chips: RT3290
121 Supported chips: RT2571 & RT2572.
160 Supported chips: RT3370
168 Supported chips: RT3572
181 Supported chips: RT5370
[all …]
|
| /linux-6.3-rc2/drivers/mtd/lpddr/ |
| A D | Kconfig | 6 tristate "Support for LPDDR flash chips"
10 flash chips. Synonymous with Mobile-DDR. It is a new standard for
15 tristate "Detect flash chips by QINFO probe"
17 Device Information for LPDDR chips is offered through the Overlay
25 tristate "Support for LPDDR2-NVM flash chips"
|
| /linux-6.3-rc2/drivers/i2c/muxes/ |
| A D | i2c-mux-pca954x.c | 94 static const struct chip_desc chips[] = { variable
197 { .compatible = "nxp,pca9540", .data = &chips[pca_9540] },
198 { .compatible = "nxp,pca9542", .data = &chips[pca_9542] },
199 { .compatible = "nxp,pca9543", .data = &chips[pca_9543] },
200 { .compatible = "nxp,pca9544", .data = &chips[pca_9544] },
201 { .compatible = "nxp,pca9545", .data = &chips[pca_9545] },
202 { .compatible = "nxp,pca9546", .data = &chips[pca_9546] },
203 { .compatible = "nxp,pca9547", .data = &chips[pca_9547] },
204 { .compatible = "nxp,pca9548", .data = &chips[pca_9548] },
205 { .compatible = "nxp,pca9846", .data = &chips[pca_9846] },
[all …]
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/bus/ |
| A D | brcm,gisb-arb.yaml | 17 - brcm,bcm7445-gisb-arb # for other 28nm chips
21 - brcm,bcm7278-gisb-arb # for V7 28nm chips
22 - brcm,bcm7435-gisb-arb # for newer 40nm chips
23 - brcm,bcm7400-gisb-arb # for older 40nm chips and all 65nm chips
24 - brcm,bcm7038-gisb-arb # for 130nm chips
|
| /linux-6.3-rc2/sound/usb/6fire/ |
| A D | chip.c | 33 static struct sfire_chip *chips[SNDRV_CARDS] = SNDRV_DEFAULT_PTR; variable
94 if (chips[i]) in usb6fire_chip_probe()
95 chips[i]->intf_count++; in usb6fire_chip_probe()
96 usb_set_intfdata(intf, chips[i]); in usb6fire_chip_probe()
134 chips[regidx] = chip; in usb6fire_chip_probe()
179 chips[chip->regidx] = NULL; in usb6fire_chip_disconnect()
|
| /linux-6.3-rc2/drivers/cpufreq/ |
| A D | powernv-cpufreq.c | 141 } *chips; variable
988 chips[i].restore = true; in powernv_cpufreq_occ_msg()
989 schedule_work(&chips[i].throttle); in powernv_cpufreq_occ_msg()
996 if (chips[i].id == omsg.chip) in powernv_cpufreq_occ_msg()
1006 chips[i].restore = true; in powernv_cpufreq_occ_msg()
1008 schedule_work(&chips[i].throttle); in powernv_cpufreq_occ_msg()
1075 if (!chips) { in init_chip_info()
1081 chips[i].id = chip[i]; in init_chip_info()
1084 for_each_cpu(cpu, &chips[i].mask) in init_chip_info()
1100 if (chips) in clean_chip_info()
[all …]
|
| /linux-6.3-rc2/Documentation/hwmon/ |
| A D | tmp421.rst | 4 Supported chips:
54 TMP423, TMP441, and TMP442 temperature sensor chips. These chips
57 in degrees Celsius. The chips are wired over I2C/SMBus and specified
61 The chips support only temperature measurement. The driver exports
|
| A D | tmp464.rst | 6 Supported chips:
33 temperature sensor chips. TMP464 provides one local and four remote
35 Temperature is measured in degrees Celsius. The chips are wired over
40 The chips support only temperature measurements. The driver exports
|
| A D | thmc50.rst | 4 Supported chips:
38 List of adapter,address pairs to force chips into ADM1022 mode with
39 second remote temperature. This does not work for original THMC50 chips.
57 The THMC50 is usually used in combination with LM78-like chips, to measure
88 The driver was tested on Compaq AP550 with two ADM1022 chips (one works
|
| A D | tmp401.rst | 4 Supported chips:
57 TMP431, TMP432, and TMP435 chips. These chips implement one or two
67 The TMP411 and TMP431 chips are compatible with TMP401. TMP411 provides
|
| A D | emc1403.rst | 4 Supported chips:
55 The Standard Microsystems Corporation (SMSC) / Microchip EMC14xx chips
61 The chips implement three limits for each sensor: low (tempX_min), high
62 (tempX_max) and critical (tempX_crit.) The chips also implement an
|
| /linux-6.3-rc2/drivers/iio/potentiometer/ |
| A D | Kconfig | 45 potentiometer chips.
56 chips.
67 chips.
78 digital potentiometer chips.
96 digital potentiometer chips.
110 digital potentiometer chips.
122 digital potentiometer chips.
134 digital potentiometer chips.
|
| /linux-6.3-rc2/Documentation/admin-guide/gpio/ |
| A D | gpio-mockup.rst | 7 chips for testing purposes. The lines exposed by these chips can be accessed
11 Creating simulated chips using module params
27 The line above creates three chips. The first one will expose 8 lines,
29 to 405 while for two first chips it will be assigned automatically.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/powerpc/fsl/ |
| A D | ccf.txt | 12 Example chips: T4240, B4860
15 Example chips: P5040, P5020, P4080, P3041, P2041
20 used for both CCF version 1 chips and CCF version 2
21 chips. It should be specified after either
|
| /linux-6.3-rc2/drivers/net/dsa/ocelot/ |
| A D | Kconfig | 23 This driver supports the VSC7511, VSC7512, VSC7513 and VSC7514 chips
26 The Ocelot switch family is a set of multi-port networking chips. All
27 of these chips have the ability to be controlled externally through
30 Say "Y" here to enable external control to these chips.
|
| /linux-6.3-rc2/drivers/memory/tegra/ |
| A D | Kconfig | 22 Tegra20 chips. The EMC controls the external DRAM on the board.
34 Tegra30 chips. The EMC controls the external DRAM on the board.
46 Tegra124 chips. The EMC controls the external DRAM on the board.
60 Tegra210 chips. The EMC controls the external DRAM on the board.
|
| /linux-6.3-rc2/drivers/nfc/st-nci/ |
| A D | Kconfig | 5 STMicroelectronics NFC NCI chips core driver. It implements the chipset
15 STMicroelectronics NFC NCI chips family.
27 STMicroelectronics NFC NCI chips family.
|
| /linux-6.3-rc2/sound/soc/bcm/ |
| A D | Kconfig | 13 tristate "SoC platform audio for Broadcom Cygnus chips"
17 Cygnus chips (bcm958300, bcm958305, bcm911360)
26 DSL/PON chips (bcm63158, bcm63178)
|
| /linux-6.3-rc2/drivers/mtd/nand/raw/ |
| A D | oxnas_nand.c | 34 struct nand_chip *chips[OXNAS_NAND_MAX_CHIPS]; member
145 oxnas->chips[oxnas->nchips++] = chip; in oxnas_nand_probe()
164 chip = oxnas->chips[i]; in oxnas_nand_probe()
181 chip = oxnas->chips[i]; in oxnas_nand_remove()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/gpio/ |
| A D | gpio-max3191x.txt | 17 Number of chips in the daisy-chain (default is 1).
21 (if all chips are wired to the same pin).
30 - maxim,modesel-8bit: Boolean whether the modesel pin of the chips is
39 (in 16-bit mode). Use this if the chips are powered
|
| /linux-6.3-rc2/drivers/mtd/maps/ |
| A D | Kconfig | 7 bool "Support non-linear mappings of flash chips"
10 paged mappings of flash chips.
17 ROM driver code to communicate with chips which are mapped
19 the physical address and size of the flash chips on your
42 This is the physical memory location at which the flash chips
52 This is the total length of the mapping of the flash chips on
54 physical memory map between the chips, this could be larger
74 and RAM driver code to communicate with chips which are mapped
135 which user-programmable flash chips are connected on various
153 to use the flash chips on it, say 'Y'.
[all …]
|