| /linux-6.3-rc2/drivers/hwmon/pmbus/ |
| A D | adm1275.c | 103 struct coefficients { struct
474 const struct coefficients *coefficients; in adm1275_probe() local
565 coefficients = adm1075_coefficients; in adm1275_probe()
593 coefficients = adm1272_coefficients; in adm1275_probe()
641 coefficients = adm1275_coefficients; in adm1275_probe()
660 coefficients = adm1276_coefficients; in adm1275_probe()
677 coefficients = adm1278_coefficients; in adm1275_probe()
712 coefficients = adm1293_coefficients; in adm1275_probe()
812 coefficients[cindex].m * shunt / 1000; in adm1275_probe()
818 coefficients[pindex].m * shunt / 1000; in adm1275_probe()
[all …]
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/dma/ |
| A D | brcm,iproc-sba.txt | 7 The "brcm,iproc-sba" has support for only 6 PQ coefficients
8 The "brcm,iproc-sba-v2" has support for only 30 PQ coefficients
|
| /linux-6.3-rc2/Documentation/hwmon/ |
| A D | sht15.rst | 48 The humidity calibration coefficients are programmed into an OTP memory on the
49 chip. These coefficients are used to internally calibrate the signals from the
50 sensors. Disabling the reload of those coefficients allows saving 10ms for each
|
| /linux-6.3-rc2/sound/pci/nm256/ |
| A D | nm256_coef.c | 4 static const char coefficients[NM_TOTAL_COEFF_COUNT * 4] = { variable
|
| /linux-6.3-rc2/drivers/clk/tegra/ |
| A D | cvb.h | 28 struct cvb_coefficients coefficients; member
|
| A D | cvb.c | 71 &entry->coefficients); in build_opp_table()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/thermal/ |
| A D | thermal-zones.yaml | 85 coefficients:
88 An array of integers containing the coefficients of a linear equation
93 where c0, c1, .., cn are the coefficients.
96 coefficients are ordered and are matched with sensors by means of the
97 sensor ID. Additional coefficients are interpreted as constant offset.
|
| A D | brcm,bcm2835-thermal.txt | 29 coefficients = <(-538) 407000>;
|
| A D | brcm,ns-thermal.yaml | 46 coefficients = <(-556) 418000>;
|
| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | omap3-cpu-thermal.dtsi | 13 coefficients = <0 20000>;
|
| A D | omap443x.dtsi | 72 coefficients = <0 20000>;
|
| A D | bcm2835.dtsi | 47 coefficients = <(-538) 407000>;
|
| A D | omap4460.dtsi | 82 coefficients = <348 (-9301)>;
|
| A D | bcm2836.dtsi | 135 coefficients = <(-538) 407000>;
|
| A D | bcm2837.dtsi | 137 coefficients = <(-538) 412000>;
|
| /linux-6.3-rc2/drivers/isdn/mISDN/ |
| A D | dsp_dtmf.c | 173 goto coefficients; in dsp_dtmf_goertzel_decode()
209 coefficients: in dsp_dtmf_goertzel_decode()
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-bus-iio-light-tsl2583 | 12 This property gets/sets the table of coefficients
|
| A D | sysfs-bus-iio-isl29501 | 36 From those two curves, a and b coefficients shall be
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/sound/ |
| A D | st,sta32x.txt | 63 If present, then MPCC bits are used for MPC coefficients,
64 otherwise standard MPC coefficients are used.
|
| A D | st,sta350.txt | 67 If present, then MPCC bits are used for MPC coefficients,
68 otherwise standard MPC coefficients are used.
|
| A D | infineon,peb2466.yaml | 56 Filters coefficients file to load. If this property is omitted, internal
|
| /linux-6.3-rc2/sound/soc/intel/avs/ |
| A D | topology.c | 726 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[0]),
732 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[1]),
738 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[2]),
744 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[3]),
750 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[4]),
756 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[5]),
762 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[6]),
768 .offset = offsetof(struct avs_tplg_modcfg_ext, updown_mix.coefficients[7]),
|
| A D | topology.h | 80 s32 coefficients[AVS_CHANNELS_MAX]; member
|
| /linux-6.3-rc2/drivers/gpu/drm/amd/display/modules/color/ |
| A D | color_gamma.c | 293 static bool build_coefficients(struct gamma_coefficients *coefficients, in build_coefficients() argument
317 coefficients->a0[i] = dc_fixpt_from_fraction( in build_coefficients()
319 coefficients->a1[i] = dc_fixpt_from_fraction( in build_coefficients()
321 coefficients->a2[i] = dc_fixpt_from_fraction( in build_coefficients()
323 coefficients->a3[i] = dc_fixpt_from_fraction( in build_coefficients()
325 coefficients->user_gamma[i] = dc_fixpt_from_fraction( in build_coefficients()
329 } while (i != ARRAY_SIZE(coefficients->a0)); in build_coefficients()
|
| /linux-6.3-rc2/Documentation/userspace-api/media/v4l/ |
| A D | ext-ctrls-codec-stateless.rst | 1004 - DCT coefficients sizes.
1455 - The quantisation matrix coefficients for non-intra-coded frames, in
1461 - The quantisation matrix coefficients for the chominance component of
2493 - The prediction weight coefficients for inter-picture prediction.
2563 for transform coefficients.
2586 coefficients. The values on each scaling list are expected
2591 coefficients. The values on each scaling list are expected
2596 coefficients. The values on each scaling list are expected
2601 coefficients. The values on each scaling list are expected
2606 coefficients. The values on each scaling list are expected
[all …]
|