Searched refs:configurations (Results 1 – 25 of 282) sorted by relevance
12345678910>>...12
| /linux-6.3-rc2/Documentation/xtensa/ |
| A D | booting.rst | 11 - For configurations without MMU, with region protection or with MPU the
13 - For configurations with region translarion MMU or with MMUv3 and CONFIG_MMU=n
16 - For configurations with MMUv2 the address must be a virtual address in the
18 - For configurations with MMUv3 and CONFIG_MMU=y the address may be either a
|
| /linux-6.3-rc2/Documentation/usb/ |
| A D | gadget_configfs.rst | 24 Creating a gadget means deciding what configurations there will be
103 2. Creating the configurations
155 4. Associating the functions with their configurations
161 function can be used in multiple configurations). This is achieved with
178 configurations and functions.
236 Remove functions from configurations::
249 Remove strings directories in configurations:
261 and remove the configurations::
378 2. The user creates configurations and functions, in the configurations
382 all configurations, and in each configuration it iterates over all
[all …]
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-bus-iio-magnetometer-hmc5843 | 6 Current configuration and available configurations
10 normal Normal measurement configurations (default)
|
| A D | sysfs-bus-coresight-devices-tpdm | 8 sure that the trace path is enabled and the link configurations
|
| A D | sysfs-platform-intel-pmc | 10 is required in order for manufacturing configurations
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/net/ |
| A D | snps,dwc-qos-ethernet.txt | 10 configurations.
29 In some configurations (e.g. GMII/RGMII), this clock also drives the PHY TX
30 path. In other configurations, other clocks (such as tx_125, rmii) may
34 In some configurations (e.g. GMII/RGMII), this clock is derived from the
35 PHY's RX clock output. In other configurations, other clocks (such as
47 The master bus interface clock. Only required in configurations that use a
59 Note: Support for additional IP configurations may require adding the
67 This will allow easy support for configurations that support multiple PHY
|
| /linux-6.3-rc2/Documentation/arm/pxa/ |
| A D | mfp.rst | 16 out of the GPIO controller. In addition to pin-mux configurations, the MFP
95 NOTE: PXA300 and PXA310 are almost identical in pin configurations (with
99 2. prepare an array for the initial pin configurations, e.g.::
123 a) once the pin configurations are passed to pxa{2xx,3xx}_mfp_config(),
127 b) when there is only one possible pin configurations for a component,
195 configurations, these definitions are processor and platform independent, and
211 configurations
215 for PXA2xx specific definitions and PXA25x/PXA27x common pin configurations
264 Examples of pin configurations are::
|
| /linux-6.3-rc2/Documentation/trace/coresight/ |
| A D | coresight-config.rst | 14 programming of the CoreSight system with pre-defined configurations that
20 be defined and enabled as named configurations.
136 The set of configurations and features that are currently loaded into the
148 configurations features
153 $ cd configurations/
212 The configurations loaded into the CoreSight configuration management are
240 When configurations are selected in this way, then the trace sink used is
253 $ cd configurations/autofdo
280 Custom configurations and / or features can be dynamically loaded into the
|
| /linux-6.3-rc2/arch/arm/mach-s3c/ |
| A D | Kconfig.s3c64xx | 85 Common setup code for S3C64XX KEYPAD GPIO configurations
90 Common setup code for S3C64XX SDHCI GPIO configurations
95 Common setup code for SPI GPIO configurations
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/pinctrl/ |
| A D | fsl,mxs-pinctrl.txt | 27 configurations, and it's called group node in the binding document. The other
39 there to adjust configurations for some pins in the group.
52 since config node is only meant to set up pin configurations.
118 to function as a 8-bit mmc device, with 8mA, 3.3V and pull-up configurations
|
| /linux-6.3-rc2/arch/mips/generic/ |
| A D | board-luton.its.S | 16 configurations {
|
| A D | board-boston.its.S | 15 configurations {
|
| A D | board-marduk.its.S | 15 configurations {
|
| A D | board-ni169445.its.S | 15 configurations {
|
| A D | board-serval.its.S | 16 configurations {
|
| A D | board-xilfpga.its.S | 15 configurations {
|
| A D | board-jaguar2.its.S | 26 configurations {
|
| A D | board-ocelot.its.S | 27 configurations {
|
| A D | vmlinux.its.S | 24 configurations {
|
| /linux-6.3-rc2/drivers/usb/typec/altmodes/ |
| A D | displayport.c | 333 static const char * const configurations[] = { variable
349 con = sysfs_match_string(configurations, buf); in configuration_store()
401 for (i = 1; i < ARRAY_SIZE(configurations); i++) { in configuration_show()
403 len += sprintf(buf + len, "[%s] ", configurations[i]); in configuration_show()
406 len += sprintf(buf + len, "%s ", configurations[i]); in configuration_show()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/mfd/ |
| A D | brcm,iproc-cdru.txt | 4 chip specific device and resource configurations. This node allows access to
|
| /linux-6.3-rc2/Documentation/admin-guide/ |
| A D | pstore-blk.rst | 20 divides all configurations into two parts, configurations for user and
21 configurations for driver.
33 All of these configurations support both Kconfig and module parameters, but
40 The detail of each configurations may be of interest to you.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/arm/ |
| A D | arm,coresight-tmc.yaml | 24 FIFO(ETF) and Embedded Trace Router(ETR) configurations. The configuration
101 and ETF configurations.
|
| /linux-6.3-rc2/kernel/bpf/preload/ |
| A D | Kconfig | 11 # in allmodconfig or allyesconfig configurations
|
| /linux-6.3-rc2/drivers/gpu/drm/i915/ |
| A D | Kconfig.unstable | 8 # allmodconfig or allyesconfig configurations
|
Completed in 26 milliseconds
12345678910>>...12