| /linux-6.3-rc2/drivers/gpu/drm/amd/display/modules/inc/ |
| A D | mod_info_packet.h | 68 struct frame_duration_op decrease; member
|
| /linux-6.3-rc2/drivers/gpu/drm/amd/display/modules/info_packet/ |
| A D | info_packet.c | 572 info_packet->sb[4] = (param->increase.support << 6 | param->decrease.support << 7); in mod_build_adaptive_sync_infopacket_v2()
574 info_packet->sb[6] = param->decrease.frame_duration_hex; in mod_build_adaptive_sync_infopacket_v2()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/input/ |
| A D | iqs626a.yaml | 189 azoteq,meas-cap-decrease:
455 channel in response to a decrease in counts. Node names suffixed with
459 that only events corresponding to a decrease in counts are reported
463 the counts increase or decrease such that events of either direction
527 azoteq,meas-cap-decrease:
766 azoteq,meas-cap-decrease;
861 azoteq,meas-cap-decrease;
869 azoteq,meas-cap-decrease;
|
| A D | iqs269a.yaml | 260 azoteq,meas-cap-decrease:
376 a decrease in counts. Node names suffixed with '-alt' instead corre-
380 that only events corresponding to a decrease in counts are reported
384 the counts increase or decrease such that events of either direction
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/net/wireless/ |
| A D | ieee80211.yaml | 30 decrease performance noticeably
|
| /linux-6.3-rc2/drivers/ras/ |
| A D | Kconfig | 22 a failed system increases, then availability will decrease.
|
| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | stm32mp135f-dk.dts | 307 st,decrease-hs-slew-rate;
321 st,decrease-hs-slew-rate;
|
| A D | socfpga_arria5_socdk.dts | 92 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| A D | socfpga_cyclone5_socdk.dts | 96 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| A D | socfpga_arria10_socdk.dtsi | 131 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/thermal/ |
| A D | qcom-spmi-adc-tm5.yaml | 50 description: This parameter is used to decrease ADC sampling rate.
115 description: This parameter is used to decrease ADC sampling rate.
|
| A D | qcom-spmi-adc-tm-hc.yaml | 46 description: This parameter is used to decrease ADC sampling rate.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/power/supply/ |
| A D | richtek,rt9455.yaml | 47 input voltage level in uV, used to decrease voltage level when the over current of the
|
| /linux-6.3-rc2/Documentation/hwmon/ |
| A D | sht15.rst | 51 measurement and decrease power consumption, while losing on precision.
|
| A D | w83793.rst | 91 if tempX_input < thermal_cruiseX - toleranceX, the chip will decrease
|
| /linux-6.3-rc2/Documentation/sound/soc/ |
| A D | pops-clicks.rst | 52 is heard when the gain increase or decrease changes the mean audio signal
|
| /linux-6.3-rc2/Documentation/scheduler/ |
| A D | schedutil.rst | 39 will decrease to reflect the fraction of time each task spends on the CPU
103 filter to instantly increase and only decay on decrease.
|
| /linux-6.3-rc2/fs/ocfs2/ |
| A D | Kconfig | 77 this option for debugging only as it is likely to decrease
|
| /linux-6.3-rc2/drivers/net/ethernet/wiznet/ |
| A D | Kconfig | 70 Performance may decrease compared to explicitly selected bus mode.
|
| /linux-6.3-rc2/arch/mips/cavium-octeon/ |
| A D | Kconfig | 10 workarounds will cause a slight decrease in performance on
|
| /linux-6.3-rc2/arch/sparc/lib/ |
| A D | M7memcpy.S | 278 sub %o2, 16, %o2 ! decrease count by 16
291 subcc %o2, 8, %o2 ! decrease count by 8
372 subcc %o2, 8, %o2 ! decrease count by 8
386 subcc %o2, 4, %o2 ! decrease count by 4
618 subcc %o3, 8, %o3 ! decrease count by 8
|
| /linux-6.3-rc2/Documentation/networking/ |
| A D | net_dim.rst | 52 compared in a similar fashion - increase == "better" and decrease == "worse".
55 increase in the interrupt rate is considered "worse" and a decrease is
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/iio/adc/ |
| A D | qcom,pm8018-adc.yaml | 84 This parameter is used to decrease the ADC sampling rate.
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-fs-f2fs | 183 needs to decrease this value to reduce the space overhead.
526 decrease. If you write "0" here, you can initialize
534 decrease. If you write "0" here, you can initialize
542 doesn't decrease. If you write "0" here, you can initialize
|
| /linux-6.3-rc2/Documentation/PCI/ |
| A D | sysfs-pci.rst | 79 echoed into it, it will then return '5'. Echoing a '0' into it will decrease
|