| /linux-6.3-rc2/drivers/soc/rockchip/ |
| A D | Kconfig | 13 special additional settings registers for a lot of soc-components.
14 In a lot of cases there also need to be default settings initialized
|
| /linux-6.3-rc2/tools/testing/kunit/configs/ |
| A D | arch_uml.config | 3 # Enable virtio/pci, as a lot of tests require it.
|
| /linux-6.3-rc2/Documentation/block/ |
| A D | biovecs.rst | 32 instead of an integer (that corresponded to bi_idx); for a lot of code the
59 pattern comes up in a lot of places; a lot of drivers were essentially open
61 simplifies a lot of code.
116 could eliminate a lot of complexity particularly in stacked drivers. Code
|
| /linux-6.3-rc2/drivers/gpu/drm/i915/ |
| A D | TODO.txt | 6 improved a lot the past 2 years, there's no reason anymore not to use it.
12 - There's a lot of complexity added past few years to make relocations faster.
|
| /linux-6.3-rc2/Documentation/maintainer/ |
| A D | index.rst | 6 There is a lot yet to go here! Please feel free to propose (and write)
|
| /linux-6.3-rc2/drivers/hid/bpf/ |
| A D | Kconfig | 12 kernel patch and allow a lot more flexibility.
|
| /linux-6.3-rc2/Documentation/admin-guide/device-mapper/ |
| A D | cache-policies.rst | 63 The mq policy used a lot of memory; 88 bytes per cache block on a 64
72 All this means smq uses ~25bytes per cache block. Still a lot of
96 smq doesn't maintain hit counts, so a lot of this problem just goes
|
| A D | persistent-data.rst | 17 Maintaining these data structures takes a lot of work, so if possible
79 array-like interface would see a lot of use.
|
| /linux-6.3-rc2/Documentation/powerpc/ |
| A D | kasan.txt | 29 lot of generic device-tree parsing code which is used to determine MMU
32 - Some code - most notably a lot of KVM code - also runs with translations off
|
| A D | mpc52xx.rst | 38 so. I didn't took 5xxx because there's apparently a lot of 5xxx that have
|
| /linux-6.3-rc2/Documentation/usb/ |
| A D | iuu_phoenix.rst | 72 So I have added this option to permit him to see a lot of color ( each activity change the color
75 - debug will produce a lot of debugging messages...
|
| /linux-6.3-rc2/sound/aoa/codecs/ |
| A D | Kconfig | 17 found in a lot of Apple Machines, especially
|
| /linux-6.3-rc2/drivers/misc/cb710/ |
| A D | Kconfig | 20 say N here. This adds a lot of debugging output to dmesg.
|
| /linux-6.3-rc2/drivers/infiniband/hw/qib/ |
| A D | qib_qsfp.c | 406 ret = qsfp_read(ppd, QSFP_LOT_OFFS, &cp->lot, QSFP_LOT_LEN); in qib_refresh_qsfp_cache()
410 cks += cp->lot[idx]; in qib_refresh_qsfp_cache()
531 QSFP_LOT_LEN, cd.lot); in qib_qsfp_dump()
|
| A D | qib_qsfp.h | 167 u8 lot[QSFP_LOT_LEN]; member
|
| /linux-6.3-rc2/Documentation/admin-guide/namespaces/ |
| A D | resource-control.rst | 5 There are a lot of kinds of objects in the kernel that don't have
|
| /linux-6.3-rc2/Documentation/driver-api/firmware/ |
| A D | introduction.rst | 25 stall or delay boot. Even if loading firmware does not take a lot of time
|
| /linux-6.3-rc2/drivers/accel/ |
| A D | Kconfig | 20 accelerators and GPUs share a lot in common and can use almost the
|
| /linux-6.3-rc2/arch/arm/mach-davinci/ |
| A D | Kconfig | 46 Makes the multiplexing functions print out a lot of debug info.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/interrupt-controller/ |
| A D | csky,apb-intc.txt | 8 - csky,apb-intc is used in a lot of csky fpgas and socs, it support 64 irq nums.
|
| /linux-6.3-rc2/Documentation/process/ |
| A D | index.rst | 12 So you want to be a Linux kernel developer? Welcome! While there is a lot
|
| /linux-6.3-rc2/Documentation/admin-guide/media/ |
| A D | philips.rst | 38 a lot of extra information, a FAQ, and the binary plugin 'PWCX'. This plugin
46 the latter, since it makes troubleshooting a lot easier. The built-in
75 Should you experience a lot of 'Dumping frame...' messages during
82 up 460 KB of RAM, so unless you have a lot of memory setting this to
|
| /linux-6.3-rc2/Documentation/driver-api/media/drivers/ |
| A D | dvb-usb.rst | 100 Thanks a lot to Joachim von Caron
120 Thanks a lot to Gunnar Wittich.
296 A lot of the currently supported devices are USB1.1 and thus they have a
351 user-level firmware loader, which saves a lot of time
|
| /linux-6.3-rc2/Documentation/trace/ |
| A D | events-nmi.rst | 30 really hogging a lot of CPU time, like a millisecond at a time.
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-driver-samsung-laptop | 7 sysfs file. These values don't always make a whole lot
|