Searched refs:rails (Results 1 – 25 of 35) sorted by relevance
12
| /linux-6.3-rc2/drivers/gpu/drm/nouveau/nvkm/subdev/iccsense/ |
| A D | base.c | 117 list_for_each_entry(rail, &iccsense->rails, head) { in nvkm_iccsense_read_all()
141 list_for_each_entry_safe(rail, tmpr, &iccsense->rails, head) { in nvkm_iccsense_dtor()
291 list_add_tail(&rail->head, &iccsense->rails); in nvkm_iccsense_oneinit()
328 INIT_LIST_HEAD(&(*iccsense)->rails); in nvkm_iccsense_new_()
|
| /linux-6.3-rc2/drivers/gpu/drm/nouveau/include/nvkm/subdev/ |
| A D | iccsense.h | 11 struct list_head rails; member
|
| /linux-6.3-rc2/arch/arm64/boot/dts/qcom/ |
| A D | sc7180-trogdor-kingoftown-r0.dts | 32 en_fp_rails: en-fp-rails-state {
|
| A D | sc7180-trogdor-homestar.dtsi | 98 * rail and eDP rails are separate from each other on homestar (but
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/mfd/ |
| A D | richtek,rt5120.yaml | 15 I/O, and peripheral rails in home entertainment devices. The I2C interface is
16 used for dynamic voltage scaling of the processor voltage, power rails on/off
|
| A D | max77620.txt | 122 GPIO1/nRST_IO pins are HIGH only if all rails
124 If any of the rails goes down(which are enabled for POK
|
| A D | rohm,bd9571mwv.yaml | 40 This is a bitmask that specifies which DDR power rails need to be kept
|
| A D | gateworks-gsc.yaml | 17 - Hardware monitor with ADC's for temperature and voltage rails and
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/regulator/ |
| A D | max77650-regulator.yaml | 20 three independent power rails.
|
| A D | tps65090.txt | 22 entry then driver will just configure this rails as external control
|
| A D | pfuze100.yaml | 54 power rails when PMIC_STBY_REQ line is asserted during the power off sequence.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/soc/qcom/ |
| A D | qcom-stats.yaml | 14 sleep modes involving powering down of the rails and oscillator clock.
|
| /linux-6.3-rc2/Documentation/hwmon/ |
| A D | ucd9200.rst | 108 rails. See chip datasheets for details.
114 created for enabled rails. See chip datasheets for
|
| A D | lochnagar.rst | 14 rails provided to the minicards. The Current Monitor does not require any
|
| A D | mp2975.rst | 31 setting of different formats on rails 1 and 2. For VID the following
|
| /linux-6.3-rc2/arch/arm64/boot/dts/rockchip/ |
| A D | rk3399-gru.dtsi | 25 * In general an attempt is made to include all rails called out by
26 * the schematic as long as those rails interact in some way with
30 * - Rails _are_ included if the rails go to the AP even if the AP
35 * If two rails are substantially the same from the AP's point of
37 * put the child rail as an alias of the parent rail. Sometimes rails
41 * - The rails are actually connected to each other by a jumper and
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-driver-bd9571mwv-regulator | 6 if DDR power rails will be kept powered during system suspend.
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/input/ |
| A D | goodix,gt7375p.yaml | 44 with what the touchscreen is expecting for its IO rails.
|
| /linux-6.3-rc2/drivers/regulator/ |
| A D | Kconfig | 574 power rails and an LDO.
766 This driver supports the control of different power rails of device
776 This driver supports the control of different power rails of device
786 This driver supports the control of different power rails of device
795 This driver supports the control of different power rails of device
804 This driver supports the control of different power rails of device
813 This driver supports the control of different power rails of device
822 This driver supports the control of different power rails of device
831 This driver supports the control of different power rails of device
840 This driver supports the control of different power rails of device
[all …]
|
| /linux-6.3-rc2/drivers/acpi/pmic/ |
| A D | Kconfig | 8 to control power rails and sensor reading/writing on the
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/display/panel/ |
| A D | panel-dsi-cm.yaml | 45 because all its power rails can be driven by the same supply. In that case
|
| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | r8a73a4-ape6evm.dts | 55 /* Common 1.8V and 3.3V rails, used by several devices on APE6EVM */
|
| A D | ste-hrefv60plus.dtsi | 72 /* Name the GPIO muxed rails on the HREF boards */
|
| /linux-6.3-rc2/Documentation/admin-guide/media/ |
| A D | si476x.rst | 134 0x10 afcrl Flag indicating if AFC rails
|
| /linux-6.3-rc2/Documentation/driver-api/ |
| A D | slimbus.rst | 108 that corresponding clocks and/or power-rails can be turned off to save power.
|
Completed in 28 milliseconds
12