| /linux-6.3-rc2/drivers/bus/ |
| A D | ts-nbus.c | 35 struct gpio_desc *rdy; member
76 ts_nbus->rdy = devm_gpiod_get(&pdev->dev, "ts,rdy", GPIOD_IN); in ts_nbus_init_pdata()
77 if (IS_ERR(ts_nbus->rdy)) { in ts_nbus_init_pdata()
79 return PTR_ERR(ts_nbus->rdy); in ts_nbus_init_pdata()
227 ret = gpiod_get_value_cansleep(ts_nbus->rdy); in ts_nbus_read()
262 while (gpiod_get_value_cansleep(ts_nbus->rdy) != 0) { in ts_nbus_write()
|
| /linux-6.3-rc2/drivers/mtd/nand/raw/ |
| A D | gpio.c | 39 struct gpio_desc *rdy; member
124 if (!gpiomtd->rdy) in gpio_nand_exec_instr()
127 return nand_gpio_waitrdy(chip, gpiomtd->rdy, in gpio_nand_exec_instr()
344 gpiomtd->rdy = devm_gpiod_get_optional(dev, "rdy", GPIOD_IN); in gpio_nand_probe()
345 if (IS_ERR(gpiomtd->rdy)) { in gpio_nand_probe()
346 ret = PTR_ERR(gpiomtd->rdy); in gpio_nand_probe()
|
| A D | lpc32xx_slc.c | 298 int rdy = 0; in lpc32xx_nand_device_ready() local
301 rdy = 1; in lpc32xx_nand_device_ready()
303 return rdy; in lpc32xx_nand_device_ready()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/bus/ |
| A D | ts-nbus.txt | 16 - ts,rdy-gpios : The GPIO pin connected to the rdy line on the FPGA
43 ts,rdy-gpios = <&gpio0 21 GPIO_ACTIVE_HIGH>;
|
| A D | nvidia,tegra20-gmi.txt | 45 - nvidia,snor-rdy-active-before-data: Assert RDY signal one cycle before data.
47 - nvidia,snor-rdy-active-high: RDY signal is active high
|
| /linux-6.3-rc2/drivers/scsi/aic7xxx/ |
| A D | aic7xxx_93cx6.c | 95 #define CLOCK_PULSE(sd, rdy) \ argument
96 while ((SEEPROM_STATUS_INB(sd) & rdy) == 0) { \
|
| /linux-6.3-rc2/drivers/input/touchscreen/ |
| A D | wacom_w8001.c | 60 u8 rdy; member
111 coord->rdy = data[0] & 0x20; in parse_pen_data()
256 input_report_key(dev, w8001->type, coord->rdy); in report_pen_events()
259 if (!coord->rdy) in report_pen_events()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/pinctrl/ |
| A D | lantiq,pinctrl-xway.txt | 62 ebu clk, ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy,
94 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
106 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
121 nand rdy, nand rd, nand_d0, nand_d1, nand_d2, nand_d3, nand_d4, nand_d5,
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/phy/ |
| A D | phy-miphy28lp.txt | 34 - st,osc-rdy : to check the MIPHY0_OSC_RDY status in the glue-logic. This
65 st,osc-rdy;
|
| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | stih418-b2199.dts | 43 st,osc-rdy;
|
| A D | stih418-b2264.dts | 121 st,osc-rdy;
|
| A D | stihxxx-b2120.dtsi | 77 st,osc-rdy;
|
| A D | rk3036.dtsi | 748 flash_rdy: flash-rdy {
|
| A D | rk3128.dtsi | 713 flash_rdy: flash-rdy {
|
| /linux-6.3-rc2/arch/mips/boot/dts/ni/ |
| A D | 169445.dts | 67 gpios = <&gpio2 0 0>, /* rdy */
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/spi/ |
| A D | fsl-imx-cspi.yaml | 68 fsl,spi-rdy-drctl:
|
| /linux-6.3-rc2/drivers/crypto/amcc/ |
| A D | crypto4xx_reg_def.h | 231 u32 rdy:1; member
|
| A D | crypto4xx_core.c | 893 sd->ctl.rdy = 1; in crypto4xx_build_pd()
904 sd->ctl.rdy = 1; in crypto4xx_build_pd()
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/mtd/ |
| A D | atmel-nand.txt | 181 gpios = <&pioC 13 0 /* rdy */
208 gpios = <&pioD 5 0 /* rdy */
|
| /linux-6.3-rc2/sound/pci/ |
| A D | sis7019.c | 895 u16 rdy; in sis_ac97_rw() local
903 rdy = codec_ready[codec]; in sis_ac97_rw()
923 if ((status & rdy) && !(status & SIS_AC97_STATUS_BUSY)) in sis_ac97_rw()
|
| /linux-6.3-rc2/drivers/scsi/be2iscsi/ |
| A D | be_cmds.c | 1619 u32 loop, post, rdy = 0; in beiscsi_check_fw_rdy() local
1627 rdy = 1; in beiscsi_check_fw_rdy()
1633 if (!rdy) { in beiscsi_check_fw_rdy()
1638 return rdy; in beiscsi_check_fw_rdy()
|
| /linux-6.3-rc2/drivers/scsi/hisi_sas/ |
| A D | hisi_sas.h | 651 extern void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy,
|
| A D | hisi_sas_main.c | 1945 void hisi_sas_phy_down(struct hisi_hba *hisi_hba, int phy_no, int rdy, in hisi_sas_phy_down() argument
1952 if (rdy) { in hisi_sas_phy_down()
|
| /linux-6.3-rc2/drivers/net/wireless/cisco/ |
| A D | airo.c | 1007 unsigned int rdy: 1; member
2603 ai->rxfids[i].rx_desc.rdy = 0; in mpi_map_card()
3665 if (rxd.rdy && rxd.valid == 0) { in mpi_receive_802_3()
3718 rxd.rdy = 0; in mpi_receive_802_3()
3804 rxd.rdy = 0; in mpi_receive_802_11()
|
| /linux-6.3-rc2/drivers/hid/ |
| A D | wacom_wac.c | 3135 bool range, prox, rdy; in wacom_bpt_pen() local
3142 rdy = (data[1] & 0x20) == 0x20; in wacom_bpt_pen()
3148 if (rdy) { in wacom_bpt_pen()
|