/linux-6.3-rc2/drivers/gpio/ |
A D | gpio-mt7621.c | 112 u32 rise, fall, high, low; in mediatek_gpio_irq_unmask() local 117 rise = mtk_gpio_r32(rg, GPIO_REG_REDGE); in mediatek_gpio_irq_unmask() 121 mtk_gpio_w32(rg, GPIO_REG_REDGE, rise | (BIT(pin) & rg->rising)); in mediatek_gpio_irq_unmask() 135 u32 rise, fall, high, low; in mediatek_gpio_irq_mask() local 138 rise = mtk_gpio_r32(rg, GPIO_REG_REDGE); in mediatek_gpio_irq_mask() 143 mtk_gpio_w32(rg, GPIO_REG_REDGE, rise & ~BIT(pin)); in mediatek_gpio_irq_mask()
|
A D | gpio-mlxbf2.c | 290 bool rise = false; in mlxbf2_gpio_irq_set_type() local 296 rise = true; in mlxbf2_gpio_irq_set_type() 299 rise = true; in mlxbf2_gpio_irq_set_type() 315 if (rise) { in mlxbf2_gpio_irq_set_type()
|
A D | gpio-stmpe.c | 296 u8 rise = NOT_SUPPORTED_IDX; in stmpe_dbg_show_one() local 319 rise = !!(ret & mask); in stmpe_dbg_show_one() 344 rise_values[rise], in stmpe_dbg_show_one()
|
/linux-6.3-rc2/Documentation/devicetree/bindings/sound/ |
A D | cirrus,cs42l42.yaml | 75 cirrus,ts-dbnc-rise: 162 If present this sets the rate that the HS bias should rise and fall. 163 The actual rise and fall times depend on external hardware (the 164 datasheet gives several rise and fall time examples). 166 0 - Fast rise time; slow, load-dependent fall time 219 cirrus,ts-dbnc-rise = <CS42L42_TS_DBNCE_1000>;
|
/linux-6.3-rc2/Documentation/leds/ |
A D | leds-sc27xx.rst | 12 hardware pattern, which is used to configure the rise time, 17 format, we should set brightness as 0 for rise stage, fall
|
/linux-6.3-rc2/Documentation/devicetree/bindings/i2c/ |
A D | i2c-mux-ltc4306.txt | 24 - ltc,downstream-accelerators-enable: Enables the rise time accelerators 26 - ltc,upstream-accelerators-enable: Enables the rise time accelerators
|
A D | i2c-rk3x.yaml | 85 Number of nanoseconds the SCL signal takes to rise
|
A D | renesas,rcar-i2c.yaml | 107 Number of nanoseconds the SCL signal takes to rise; t(r) in the I2C
|
A D | i2c.txt | 45 Number of nanoseconds the SCL signal takes to rise; t(r) in the I2C
|
/linux-6.3-rc2/Documentation/ABI/testing/ |
A D | sysfs-class-led-driver-lm3533 | 27 Set the pattern generator fall and rise times (0..7), where:
|
/linux-6.3-rc2/arch/arm64/boot/dts/rockchip/ |
A D | rk3399-gru-kevin.dts | 185 /* These are relatively safe rise/fall times. */ 201 /* These are relatively safe rise/fall times. */
|
A D | rk3399-gru-chromebook.dtsi | 450 /* These are relatively safe rise/fall times */ 466 /* These are relatively safe rise/fall times */
|
A D | rk3399-gru-scarlet.dtsi | 263 /* These are relatively safe rise/fall times. */ 295 /* These are relatively safe rise/fall times; TODO: measure */
|
A D | rk3399-gru.dtsi | 418 /* These are relatively safe rise/fall times */ 428 /* These are relatively safe rise/fall times */
|
A D | px30-evb.dts | 440 /* These are relatively safe rise/fall times; TODO: measure */
|
/linux-6.3-rc2/Documentation/devicetree/bindings/phy/ |
A D | qcom,usb-snps-femto-v2.yaml | 114 qcom,hs-rise-fall-time-bp: 116 This adjusts the rise/fall times of the high-speed waveform.
|
A D | phy-stm32-usbphyc.yaml | 115 description: Enables the FS rise/fall tuning option 119 description: Enables the HS rise/fall reduction feature
|
/linux-6.3-rc2/Documentation/devicetree/bindings/memory-controllers/ |
A D | mvebu-devbus.txt | 92 address and data to DEV_WEn rise. 100 data after DEV_WEn rise.
|
/linux-6.3-rc2/Documentation/filesystems/ |
A D | locks.rst | 35 for example. This gave rise to some other subtle problems if sendmail was
|
/linux-6.3-rc2/Documentation/driver-api/gpio/ |
A D | intro.rst | 120 value (after the appropriate rise time passes), you know some other component is
|
/linux-6.3-rc2/Documentation/fb/ |
A D | udlfb.rst | 53 * It's not clear what the future of fbdev is, given the rise of KMS/DRM.
|
/linux-6.3-rc2/arch/arm/boot/dts/ |
A D | at91-sama5d2_icp.dts | 375 * Trigger can be configured on falling, rise
|
A D | rk3288-veyron.dtsi | 333 /* 100kHz since 4.7k resistors don't rise fast enough */
|
A D | at91-sama5d2_xplained.dts | 460 * Trigger can be configured on falling, rise
|
/linux-6.3-rc2/Documentation/m68k/ |
A D | buddha-driver.rst | 140 All the timings have in common: Select and IOR/IOW rise at
|