| /linux-6.3-rc2/arch/arm/boot/dts/ |
| A D | twl4030.dtsi | 10 compatible = "ti,twl4030";
15 compatible = "ti,twl4030-rtc";
20 compatible = "ti,twl4030-bci";
28 compatible = "ti,twl4030-wdt";
32 compatible = "ti,twl4030-vaux1";
36 compatible = "ti,twl4030-vaux2";
40 compatible = "ti,twl4030-vaux3";
48 compatible = "ti,twl4030-vdd1";
54 compatible = "ti,twl4030-vdac";
60 compatible = "ti,twl4030-vio";
[all …]
|
| A D | omap3-cm-t3x30.dtsi | 16 compatible = "ti,omap-twl4030";
73 compatible = "ti,twl4030-audio";
80 #include "twl4030.dtsi"
|
| A D | twl4030_omap3.dtsi | 13 * On most OMAP3 platforms, the twl4030 IRQ line is connected
25 * If your board is not using the I2C4 pins with twl4030, then don't include
|
| A D | logicpd-torpedo-som.dtsi | 89 compatible = "ti,twl4030-audio";
187 #include "twl4030.dtsi"
192 compatible = "ti,twl4030-power-idle-osc-off", "ti,twl4030-power-idle";
|
| A D | omap3-evm-common.dtsi | 66 #include "twl4030.dtsi"
76 compatible = "ti,twl4030-power-omap3-evm", "ti,twl4030-power-idle";
|
| A D | omap3-beagle-xm.dts | 64 compatible = "ti,omap-twl4030";
288 compatible = "ti,twl4030-audio";
294 compatible = "ti,twl4030-power-beagleboard-xm", "ti,twl4030-power-idle-osc-off";
300 #include "twl4030.dtsi"
|
| A D | logicpd-som-lv.dtsi | 90 compatible = "ti,twl4030-audio";
279 #include "twl4030.dtsi"
289 compatible = "ti,twl4030-power-idle-osc-off", "ti,twl4030-power-idle";
|
| A D | omap3-igep.dtsi | 23 compatible = "ti,omap-twl4030";
192 compatible = "ti,twl4030-audio";
199 #include "twl4030.dtsi"
|
| A D | omap3-overo-base.dtsi | 29 compatible = "ti,omap-twl4030";
154 compatible = "ti,twl4030-audio";
161 #include "twl4030.dtsi"
|
| /linux-6.3-rc2/sound/soc/codecs/ |
| A D | twl4030.c | 136 if (twl4030->hsl_enabled || twl4030->hsr_enabled) in twl4030_can_write_to_chip()
342 twl4030->apll_enabled++; in twl4030_apll_enable()
347 twl4030->apll_enabled--; in twl4030_apll_enable()
712 twl4030->sysclk) + 1; in headset_ramp()
1612 twl4030->rate); in twl4030_constraints()
1620 twl4030->channels); in twl4030_constraints()
1657 twl4030_constraints(twl4030, twl4030->master_substream); in twl4030_startup()
1681 twl4030->master_substream = twl4030->slave_substream; in twl4030_shutdown()
1719 if (twl4030->configured) in twl4030_hw_params()
1800 twl4030->configured = 1; in twl4030_hw_params()
[all …]
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/regulator/ |
| A D | twl-regulator.txt | 35 For twl4030 regulators/LDOs
37 - "ti,twl4030-vaux1" for VAUX1 LDO
38 - "ti,twl4030-vaux2" for VAUX2 LDO
40 - "ti,twl4030-vaux3" for VAUX3 LDO
41 - "ti,twl4030-vaux4" for VAUX4 LDO
46 - "ti,twl4030-vsim" for VSIM LDO
47 - "ti,twl4030-vdac" for VDAC LDO
49 - "ti,twl4030-vio" for VIO LDO
50 - "ti,twl4030-vdd1" for VDD1 SMPS
51 - "ti,twl4030-vdd2" for VDD2 SMPS
[all …]
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/mfd/ |
| A D | twl4030-power.txt | 1 Texas Instruments TWL family (twl4030) reset and power management module
9 "ti,twl4030-power"
10 "ti,twl4030-power-reset"
11 "ti,twl4030-power-idle"
12 "ti,twl4030-power-idle-osc-off"
14 The use of ti,twl4030-power-reset is recommended at least on
17 When using ti,twl4030-power-idle, the TI recommended configuration
20 When using ti,twl4030-power-idle-osc-off, the TI recommended
44 compatible = "ti,twl4030-power";
|
| A D | twl4030-audio.txt | 1 Texas Instruments TWL family (twl4030) audio module
7 - compatible : must be "ti,twl4030-audio"
36 compatible = "ti,twl4030-audio";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/input/ |
| A D | twl4030-pwrbutton.txt | 1 Texas Instruments TWL family (twl4030) pwrbutton module
10 - "ti,twl4030-pwrbutton": For controllers compatible with twl4030
12 - <8>: For controllers compatible with twl4030
18 compatible = "ti,twl4030-pwrbutton";
|
| A D | twl4030-keypad.txt | 16 - "ti,twl4030-keypad": For controllers compatible with twl4030 keypad
19 - <1>: For controllers compatible with twl4030 keypad controller.
23 compatible = "ti,twl4030-keypad";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/sound/ |
| A D | omap-twl4030.txt | 1 * Texas Instruments SoC with twl4030 based audio setups
4 - compatible: "ti,omap-twl4030"
9 - ti,codec: phandle for the twl4030 audio node
32 twl4030 pins:
58 compatible = "ti,omap-twl4030";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/watchdog/ |
| A D | twl4030-wdt.txt | 1 Device tree bindings for twl4030-wdt driver (TWL4030 watchdog)
4 compatible = "ti,twl4030-wdt";
9 compatible = "ti,twl4030-wdt";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/gpio/ |
| A D | gpio-twl4030.txt | 1 twl4030 GPIO controller bindings
5 - "ti,twl4030-gpio" for twl4030 GPIO controller
23 compatible = "ti,twl4030-gpio";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/power/supply/ |
| A D | twl4030-charger.yaml | 4 $id: http://devicetree.org/schemas/power/supply/twl4030-charger.yaml#
15 of the BCI node which is compatible with "ti,twl4030-usb", then that is used
26 const: ti,twl4030-bci
61 compatible = "ti,twl4030-bci";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/usb/ |
| A D | twlxxxx-usb.txt | 24 - compatible : Should be "ti,twl4030-usb"
33 If a sibling node is compatible "ti,twl4030-bci", then it will find
36 twl4030-usb {
37 compatible = "ti,twl4030-usb";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/iio/adc/ |
| A D | ti,twl4030-madc.yaml | 4 $id: http://devicetree.org/schemas/iio/adc/ti,twl4030-madc.yaml#
18 const: ti,twl4030-madc
43 compatible = "ti,twl4030-madc";
|
| /linux-6.3-rc2/Documentation/devicetree/bindings/rtc/ |
| A D | twl-rtc.txt | 4 - compatible : Should be "ti,twl4030-rtc"
9 compatible = "ti,twl4030-rtc";
|
| /linux-6.3-rc2/sound/soc/ti/ |
| A D | Makefile | 30 snd-soc-omap-twl4030-objs := omap-twl4030.o
41 obj-$(CONFIG_SND_SOC_OMAP3_TWL4030) += snd-soc-omap-twl4030.o
|
| /linux-6.3-rc2/Documentation/hwmon/ |
| A D | twl4030-madc-hwmon.rst | 1 Kernel driver twl4030-madc
8 Prefix: 'twl4030-madc'
|
| /linux-6.3-rc2/Documentation/ABI/testing/ |
| A D | sysfs-platform-twl4030-usb | 1 What: /sys/bus/platform/devices/*twl4030-usb/vbus
|