1NXP Layerscape SoC qDMA Controller
2==================================
3
4This device follows the generic DMA bindings defined in dma/dma.txt.
5
6Required properties:
7
8- compatible:		Must be one of
9			 "fsl,ls1021a-qdma": for LS1021A Board
10			 "fsl,ls1028a-qdma": for LS1028A Board
11			 "fsl,ls1043a-qdma": for ls1043A Board
12			 "fsl,ls1046a-qdma": for ls1046A Board
13- reg:			Should contain the register's base address and length.
14- interrupts:		Should contain a reference to the interrupt used by this
15			device.
16- interrupt-names:	Should contain interrupt names:
17			 "qdma-queue0": the block0 interrupt
18			 "qdma-queue1": the block1 interrupt
19			 "qdma-queue2": the block2 interrupt
20			 "qdma-queue3": the block3 interrupt
21			 "qdma-error":  the error interrupt
22- fsl,dma-queues:	Should contain number of queues supported.
23- dma-channels:	Number of DMA channels supported
24- block-number:	the virtual block number
25- block-offset:	the offset of different virtual block
26- status-sizes:	status queue size of per virtual block
27- queue-sizes:		command queue size of per virtual block, the size number
28			based on queues
29
30Optional properties:
31
32- dma-channels:		Number of DMA channels supported by the controller.
33- big-endian:		If present registers and hardware scatter/gather descriptors
34			of the qDMA are implemented in big endian mode, otherwise in little
35			mode.
36
37Examples:
38
39	qdma: dma-controller@8390000 {
40			compatible = "fsl,ls1021a-qdma";
41			reg = <0x0 0x8388000 0x0 0x1000>, /* Controller regs */
42			      <0x0 0x8389000 0x0 0x1000>, /* Status regs */
43			      <0x0 0x838a000 0x0 0x2000>; /* Block regs */
44			interrupts = <GIC_SPI 185 IRQ_TYPE_LEVEL_HIGH>,
45				     <GIC_SPI 76 IRQ_TYPE_LEVEL_HIGH>,
46				     <GIC_SPI 77 IRQ_TYPE_LEVEL_HIGH>;
47			interrupt-names = "qdma-error",
48				"qdma-queue0", "qdma-queue1";
49			dma-channels = <8>;
50			block-number = <2>;
51			block-offset = <0x1000>;
52			fsl,dma-queues = <2>;
53			status-sizes = <64>;
54			queue-sizes = <64 64>;
55			big-endian;
56		};
57
58DMA clients must use the format described in dma/dma.txt file.
59