1SMSC/MicroChip LAN9303 three port ethernet switch
2-------------------------------------------------
3
4Required properties:
5
6- compatible: should be
7  - "smsc,lan9303-i2c" for I2C managed mode
8    or
9  - "smsc,lan9303-mdio" for mdio managed mode
10
11Optional properties:
12
13- reset-gpios: GPIO to be used to reset the whole device
14- reset-duration: reset duration in milliseconds, defaults to 200 ms
15
16Subnodes:
17
18The integrated switch subnode should be specified according to the binding
19described in dsa/dsa.txt. The CPU port of this switch is always port 0.
20
21Note: always use 'reg = <0/1/2>;' for the three DSA ports, even if the device is
22configured to use 1/2/3 instead. This hardware configuration will be
23auto-detected and mapped accordingly.
24
25Example:
26
27I2C managed mode:
28
29	master: masterdevice@X {
30
31		fixed-link { /* RMII fixed link to LAN9303 */
32			speed = <100>;
33			full-duplex;
34		};
35	};
36
37	switch: switch@a {
38		compatible = "smsc,lan9303-i2c";
39		reg = <0xa>;
40		reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
41		reset-duration = <200>;
42
43		ports {
44			#address-cells = <1>;
45			#size-cells = <0>;
46
47			port@0 { /* RMII fixed link to master */
48				reg = <0>;
49				ethernet = <&master>;
50			};
51
52			port@1 { /* external port 1 */
53				reg = <1>;
54				label = "lan1";
55			};
56
57			port@2 { /* external port 2 */
58				reg = <2>;
59				label = "lan2";
60			};
61		};
62	};
63
64MDIO managed mode:
65
66	master: masterdevice@X {
67		phy-handle = <&switch>;
68
69		mdio {
70			#address-cells = <1>;
71			#size-cells = <0>;
72
73			switch: switch-phy@0 {
74				compatible = "smsc,lan9303-mdio";
75				reg = <0>;
76				reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
77				reset-duration = <100>;
78
79				ports {
80					#address-cells = <1>;
81					#size-cells = <0>;
82
83					port@0 {
84						reg = <0>;
85						ethernet = <&master>;
86					};
87
88					port@1 { /* external port 1 */
89						reg = <1>;
90						label = "lan1";
91					};
92
93					port@2 { /* external port 2 */
94						reg = <2>;
95						label = "lan2";
96					};
97				};
98			};
99		};
100	};
101