1// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
2/*
3 * Google Veyron Jaq Rev 1+ board device tree source
4 *
5 * Copyright 2015 Google, Inc
6 */
7
8/dts-v1/;
9
10#include "rk3288-veyron-chromebook.dtsi"
11#include "cros-ec-sbs.dtsi"
12
13/ {
14	model = "Google Jaq";
15	compatible = "google,veyron-jaq-rev5", "google,veyron-jaq-rev4",
16		     "google,veyron-jaq-rev3", "google,veyron-jaq-rev2",
17		     "google,veyron-jaq-rev1", "google,veyron-jaq",
18		     "google,veyron", "rockchip,rk3288";
19};
20
21&backlight {
22	/* Jaq panel PWM must be >= 3%, so start non-zero brightness at 8 */
23	brightness-levels = <8 255>;
24	num-interpolated-steps = <247>;
25};
26
27&rk808 {
28	pinctrl-names = "default";
29	pinctrl-0 = <&pmic_int_l &dvs_1 &dvs_2>;
30	dvs-gpios = <&gpio7 RK_PB4 GPIO_ACTIVE_HIGH>,
31		    <&gpio7 RK_PB7 GPIO_ACTIVE_HIGH>;
32
33	regulators {
34		mic_vcc: LDO_REG2 {
35			regulator-name = "mic_vcc";
36			regulator-always-on;
37			regulator-boot-on;
38			regulator-min-microvolt = <1800000>;
39			regulator-max-microvolt = <1800000>;
40			regulator-state-mem {
41				regulator-off-in-suspend;
42			};
43		};
44	};
45};
46
47&sdio0 {
48	#address-cells = <1>;
49	#size-cells = <0>;
50
51	btmrvl: btmrvl@2 {
52		compatible = "marvell,sd8897-bt";
53		reg = <2>;
54		interrupt-parent = <&gpio4>;
55		interrupts = <RK_PD7 IRQ_TYPE_LEVEL_LOW>;
56		marvell,wakeup-pin = /bits/ 16 <13>;
57		pinctrl-names = "default";
58		pinctrl-0 = <&bt_host_wake_l>;
59	};
60};
61
62&sdmmc {
63	disable-wp;
64	pinctrl-names = "default";
65	pinctrl-0 = <&sdmmc_clk &sdmmc_cmd &sdmmc_cd_disabled &sdmmc_cd_pin
66			&sdmmc_bus4>;
67};
68
69&vcc_5v {
70	enable-active-high;
71	gpio = <&gpio7 RK_PC5 GPIO_ACTIVE_HIGH>;
72	pinctrl-names = "default";
73	pinctrl-0 = <&drv_5v>;
74};
75
76&vcc50_hdmi {
77	enable-active-high;
78	gpio = <&gpio5 RK_PC3 GPIO_ACTIVE_HIGH>;
79	pinctrl-names = "default";
80	pinctrl-0 = <&vcc50_hdmi_en>;
81};
82
83&gpio0 {
84	gpio-line-names = "PMIC_SLEEP_AP",
85			  "DDRIO_PWROFF",
86			  "DDRIO_RETEN",
87			  "TS3A227E_INT_L",
88			  "PMIC_INT_L",
89			  "PWR_KEY_L",
90			  "AP_LID_INT_L",
91			  "EC_IN_RW",
92
93			  "AC_PRESENT_AP",
94			  /*
95			   * RECOVERY_SW_L is Chrome OS ABI.  Schematics call
96			   * it REC_MODE_L.
97			   */
98			  "RECOVERY_SW_L",
99			  "OTP_OUT",
100			  "HOST1_PWR_EN",
101			  "USBOTG_PWREN_H",
102			  "AP_WARM_RESET_H",
103			  "nFALUT2",
104			  "I2C0_SDA_PMIC",
105
106			  "I2C0_SCL_PMIC",
107			  "SUSPEND_L",
108			  "USB_INT";
109};
110
111&gpio2 {
112	gpio-line-names = "CONFIG0",
113			  "CONFIG1",
114			  "CONFIG2",
115			  "",
116			  "",
117			  "",
118			  "",
119			  "CONFIG3",
120
121			  "",
122			  "EMMC_RST_L",
123			  "",
124			  "",
125			  "BL_PWR_EN",
126			  "AVDD_1V8_DISP_EN";
127};
128
129&gpio3 {
130	gpio-line-names = "FLASH0_D0",
131			  "FLASH0_D1",
132			  "FLASH0_D2",
133			  "FLASH0_D3",
134			  "FLASH0_D4",
135			  "FLASH0_D5",
136			  "FLASH0_D6",
137			  "FLASH0_D7",
138
139			  "",
140			  "",
141			  "",
142			  "",
143			  "",
144			  "",
145			  "",
146			  "",
147
148			  "FLASH0_CS2/EMMC_CMD",
149			  "",
150			  "FLASH0_DQS/EMMC_CLKO";
151};
152
153&gpio4 {
154	gpio-line-names = "",
155			  "",
156			  "",
157			  "",
158			  "",
159			  "",
160			  "",
161			  "",
162
163			  "",
164			  "",
165			  "",
166			  "",
167			  "",
168			  "",
169			  "",
170			  "",
171
172			  "UART0_RXD",
173			  "UART0_TXD",
174			  "UART0_CTS",
175			  "UART0_RTS",
176			  "SDIO0_D0",
177			  "SDIO0_D1",
178			  "SDIO0_D2",
179			  "SDIO0_D3",
180
181			  "SDIO0_CMD",
182			  "SDIO0_CLK",
183			  "BT_DEV_WAKE",	/* Maybe missing from mighty? */
184			  "",
185			  "WIFI_ENABLE_H",
186			  "BT_ENABLE_L",
187			  "WIFI_HOST_WAKE",
188			  "BT_HOST_WAKE";
189};
190
191&gpio5 {
192	gpio-line-names = "",
193			  "",
194			  "",
195			  "",
196			  "",
197			  "",
198			  "",
199			  "",
200
201			  "",
202			  "",
203			  "",
204			  "",
205			  "SPI0_CLK",
206			  "SPI0_CS0",
207			  "SPI0_TXD",
208			  "SPI0_RXD",
209
210			  "",
211			  "",
212			  "",
213			  "VCC50_HDMI_EN";
214};
215
216&gpio6 {
217	gpio-line-names = "I2S0_SCLK",
218			  "I2S0_LRCK_RX",
219			  "I2S0_LRCK_TX",
220			  "I2S0_SDI",
221			  "I2S0_SDO0",
222			  "HP_DET_H",
223			  "ALS_INT",
224			  "INT_CODEC",
225
226			  "I2S0_CLK",
227			  "I2C2_SDA",
228			  "I2C2_SCL",
229			  "MICDET",
230			  "",
231			  "",
232			  "",
233			  "",
234
235			  "SDMMC_D0",
236			  "SDMMC_D1",
237			  "SDMMC_D2",
238			  "SDMMC_D3",
239			  "SDMMC_CLK",
240			  "SDMMC_CMD";
241};
242
243&gpio7 {
244	gpio-line-names = "LCDC_BL",
245			  "PWM_LOG",
246			  "BL_EN",
247			  "TRACKPAD_INT",
248			  "TPM_INT_H",
249			  "SDMMC_DET_L",
250			  /*
251			   * AP_FLASH_WP_L is Chrome OS ABI.  Schematics call
252			   * it FW_WP_AP.
253			   */
254			  "AP_FLASH_WP_L",
255			  "EC_INT",
256
257			  "CPU_NMI",
258			  "DVSOK",
259			  "SDMMC_WP",		/* mighty only */
260			  "EDP_HPD",
261			  "DVS1",
262			  "nFALUT1",		/* nFAULT1 on jaq */
263			  "LCD_EN",
264			  "DVS2",
265
266			  "VCC5V_GOOD_H",
267			  "I2C4_SDA_TP",
268			  "I2C4_SCL_TP",
269			  "I2C5_SDA_HDMI",
270			  "I2C5_SCL_HDMI",
271			  "5V_DRV",
272			  "UART2_RXD",
273			  "UART2_TXD";
274};
275
276&gpio8 {
277	gpio-line-names = "RAM_ID0",
278			  "RAM_ID1",
279			  "RAM_ID2",
280			  "RAM_ID3",
281			  "I2C1_SDA_TPM",
282			  "I2C1_SCL_TPM",
283			  "SPI2_CLK",
284			  "SPI2_CS0",
285
286			  "SPI2_RXD",
287			  "SPI2_TXD";
288};
289
290&pinctrl {
291	pinctrl-names = "default", "sleep";
292	pinctrl-0 = <
293		/* Common for sleep and wake, but no owners */
294		&ddr0_retention
295		&ddrio_pwroff
296		&global_pwroff
297
298		/* Wake only */
299		&suspend_l_wake
300		&bt_dev_wake_awake
301	>;
302	pinctrl-1 = <
303		/* Common for sleep and wake, but no owners */
304		&ddr0_retention
305		&ddrio_pwroff
306		&global_pwroff
307
308		/* Sleep only */
309		&suspend_l_sleep
310		&bt_dev_wake_sleep
311	>;
312
313	buck-5v {
314		drv_5v: drv-5v {
315			rockchip,pins = <7 RK_PC5 RK_FUNC_GPIO &pcfg_pull_none>;
316		};
317	};
318
319	hdmi {
320		vcc50_hdmi_en: vcc50-hdmi-en {
321			rockchip,pins = <5 RK_PC3 RK_FUNC_GPIO &pcfg_pull_none>;
322		};
323	};
324
325	pmic {
326		dvs_1: dvs-1 {
327			rockchip,pins = <7 RK_PB4 RK_FUNC_GPIO &pcfg_pull_down>;
328		};
329
330		dvs_2: dvs-2 {
331			rockchip,pins = <7 RK_PB7 RK_FUNC_GPIO &pcfg_pull_down>;
332		};
333	};
334};
335