1/*
2 * Copyright 2015 Hans de Goede <hdegoede@redhat.com>
3 *
4 * This file is dual-licensed: you can use it either under the terms
5 * of the GPL or the X11 license, at your option. Note that this dual
6 * licensing only applies to this file, and not this project as a
7 * whole.
8 *
9 *  a) This file is free software; you can redistribute it and/or
10 *     modify it under the terms of the GNU General Public License as
11 *     published by the Free Software Foundation; either version 2 of the
12 *     License, or (at your option) any later version.
13 *
14 *     This file is distributed in the hope that it will be useful,
15 *     but WITHOUT ANY WARRANTY; without even the implied warranty of
16 *     MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
17 *     GNU General Public License for more details.
18 *
19 * Or, alternatively,
20 *
21 *  b) Permission is hereby granted, free of charge, to any person
22 *     obtaining a copy of this software and associated documentation
23 *     files (the "Software"), to deal in the Software without
24 *     restriction, including without limitation the rights to use,
25 *     copy, modify, merge, publish, distribute, sublicense, and/or
26 *     sell copies of the Software, and to permit persons to whom the
27 *     Software is furnished to do so, subject to the following
28 *     conditions:
29 *
30 *     The above copyright notice and this permission notice shall be
31 *     included in all copies or substantial portions of the Software.
32 *
33 *     THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND,
34 *     EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES
35 *     OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND
36 *     NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT
37 *     HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY,
38 *     WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING
39 *     FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR
40 *     OTHER DEALINGS IN THE SOFTWARE.
41 */
42#include "sunxi-reference-design-tablet.dtsi"
43#include "sun8i-reference-design-tablet.dtsi"
44
45/ {
46	aliases {
47		serial0 = &r_uart;
48		/* Make u-boot set mac-address for wifi without an eeprom */
49		ethernet0 = &sdio_wifi;
50	};
51
52	panel: panel {
53		/* Tablet dts should provide panel compatible */
54		backlight = <&backlight>;
55		enable-gpios = <&pio 7 7 GPIO_ACTIVE_HIGH>; /* PH7 */
56		power-supply = <&reg_dc1sw>;
57
58		port {
59			panel_input: endpoint {
60				remote-endpoint = <&tcon0_out_lcd>;
61			};
62		};
63	};
64
65	wifi_pwrseq: wifi_pwrseq {
66		compatible = "mmc-pwrseq-simple";
67		/*
68		 * Q8 boards use various PL# pins as wifi-en. On other boards
69		 * these may be connected to a wifi module output pin. To avoid
70		 * short-circuits we configure these as inputs with pull-ups via
71		 * pinctrl, instead of listing them as active-low reset-gpios.
72		 */
73		pinctrl-names = "default";
74		pinctrl-0 = <&wifi_pwrseq_pin_q8>;
75		/* The esp8089 needs 200 ms after driving wifi-en high */
76		post-power-on-delay-ms = <200>;
77	};
78};
79
80&de {
81	status = "okay";
82};
83
84&ehci0 {
85	status  = "okay";
86};
87
88&mmc1 {
89	pinctrl-names = "default";
90	pinctrl-0 = <&mmc1_pg_pins>;
91	vmmc-supply = <&reg_dldo1>;
92	mmc-pwrseq = <&wifi_pwrseq>;
93	bus-width = <4>;
94	non-removable;
95	status = "okay";
96
97	sdio_wifi: sdio_wifi@1 {
98		reg = <1>;
99	};
100};
101
102&r_pio {
103	wifi_pwrseq_pin_q8: wifi-pwrseq-pins {
104		pins = "PL6", "PL7", "PL11";
105		function = "gpio_in";
106		bias-pull-up;
107	};
108};
109
110&tcon0 {
111	pinctrl-names = "default";
112	pinctrl-0 = <&lcd_rgb666_pins>;
113	status = "okay";
114};
115
116&usbphy {
117	usb1_vbus-supply = <&reg_dldo1>;
118};
119