Home
last modified time | relevance | path

Searched refs:DSP (Results 1 – 25 of 104) sorted by relevance

12345

/linux/Documentation/hwmon/
A Dlochnagar.rst33 in1_input Measured voltage for 1V8 DSP (milliVolts)
34 in1_label "1V8 DSP"
35 curr2_input Measured current for 1V8 DSP (milliAmps)
36 curr2_label "1V8 DSP"
37 power2_average Measured average power for 1V8 DSP (microWatts)
39 power2_label "1V8 DSP"
47 in3_input Measured voltage for VDDCORE DSP (milliVolts)
48 in3_label "VDDCORE DSP"
49 curr4_input Measured current for VDDCORE DSP (milliAmps)
50 curr4_label "VDDCORE DSP"
[all …]
/linux/Documentation/sound/soc/
A Ddpcm.rst22 Phone Audio System with SoC based DSP
35 * DSP *
66 * DSP *
83 * DSP *
136 * DSP *
211 * DSP *
228 DSP firmware.
252 /* The DSP will convert the FE rate to 48k, stereo */
277 Writing a DPCM DSP driver
288 3. DAPM widgets from DSP graph.
[all …]
A Dplatform.rst6 drivers and DSP drivers. The platform drivers only target the SoC CPU and must
68 SoC DSP Drivers
71 Each SoC DSP driver usually supplies the following features :-
75 3. DMA IO to/from DSP buffers (if applicable)
76 4. Definition of DSP front end (FE) PCM devices.
A Dcodec-to-codec.rst64 .name = "CPU-DSP",
65 .stream_name = "CPU-DSP",
76 .name = "DSP-CODEC",
77 .stream_name = "DSP-CODEC",
/linux/Documentation/devicetree/bindings/remoteproc/
A Dti,davinci-rproc.txt1 TI Davinci DSP devices
7 The TI Davinci family of SoCs usually contains a TI DSP Core sub-system that
13 controller, a dedicated local power/sleep controller etc. The DSP processor
14 core used in Davinci SoCs is usually a C674x DSP CPU.
16 DSP Device Node:
18 Each DSP Core sub-system is represented as a single DT node.
38 interrupts from the DSP. The value should follow the
52 /* DSP Reserved Memory node */
65 /* DSP node */
A Dti,keystone-rproc.txt1 TI Keystone DSP devices
4 The TI Keystone 2 family of SoCs usually have one or more (upto 8) TI DSP Core
13 DSP Device Node:
42 State Control node, and the register offset of the DSP
83 and an args specifier containing the DSP device id
101 /* 66AK2H/K DSP aliases */
113 /* 66AK2H/K DSP memory node */
126 /* 66AK2H/K DSP node */
147 /* 66AK2G DSP alias */
152 /* 66AK2G DSP memory node */
[all …]
A Dti,k3-dsp-rproc.yaml7 title: TI K3 DSP devices
13 The TI K3 family of SoCs usually have one or more TI DSP Core sub-systems
19 controller, a dedicated local power/sleep controller etc. The DSP processor
23 Each DSP Core sub-system is represented as a single DT node. Each node has a
149 /* J721E C66_0 DSP node */
166 /* J721E C71_0 DSP node */
A Dti,omap-remoteproc.yaml21 The OMAP SoCs usually have a DSP processor sub-system and/or an IPU processor
22 sub-system. The DSP processor sub-system can contain any of the TI's C64x,
23 C66x or C67x family of DSP cores as the main execution unit. The IPU processor
108 'reg-names'. These are mandatory for all DSP and IPU
132 all the DSP instances on OMAP4, OMAP5 and DRA7xx SoCs.
220 //Example 1: OMAP4 DSP
222 /* DSP Reserved Memory node */
235 /* DSP node */
290 //Example 3: DRA7xx/AM57xx DSP
/linux/Documentation/devicetree/bindings/gpio/
A Dgpio-dsp-keystone.txt1 Keystone 2 DSP GPIO controller bindings
3 HOST OS userland running on ARM can send interrupts to DSP cores using
4 the DSP GPIO controller IP. It provides 28 IRQ signals per each DSP core.
7 For example TCI6638K2K SoC has 8 DSP GPIO controllers:
10 Keystone 2 DSP GPIO controller has specific features:
12 - setting GPIO value to 1 causes IRQ generation on target DSP core;
/linux/drivers/firmware/imx/
A DKconfig3 tristate "IMX DSP Protocol driver"
6 This enables DSP IPC protocol between host AP (Linux)
7 and the firmware running on DSP.
8 DSP exists on some i.MX8 processors (e.g i.MX8QM, i.MX8QXP).
11 exchange information with DSP side.
/linux/arch/sh/
A DKconfig.cpu40 prompt "DSP support"
44 have DSP units (ie, SH2-DSP, SH3-DSP, and SH4AL-DSP).
46 This option must be set in order to enable the DSP.
/linux/Documentation/devicetree/bindings/dma/
A Dste-dma40.txt86 24: Multimedia DSP SXA0
87 25: Multimedia DSP SXA1
88 26: Multimedia DSP SXA2
89 27: Multimedia DSP SXA3
106 44: Multimedia DSP SXA4
107 45: Multimedia DSP SXA5
108 46: SLIMbus channel 8 or Multimedia DSP SXA6
109 47: SLIMbus channel 9 or Multimedia DSP SXA7
/linux/sound/soc/intel/
A DKconfig9 has an audio controller with a DSP and I2S or DMIC port, then
93 If you have a Intel Skylake platform with the DSP enabled
102 If you have a Intel Broxton/ApolloLake platform with the DSP
111 If you have a Intel Kabylake platform with the DSP
120 If you have a Intel GeminiLake platform with the DSP
129 If you have a Intel CNL/WHL platform with the DSP
138 If you have a Intel CoffeeLake platform with the DSP
147 If you have a Intel CometLake-H platform with the DSP
156 If you have a Intel CometLake-LP platform with the DSP
185 GeminiLake or CannonLake platform with the DSP enabled in the BIOS
/linux/drivers/remoteproc/
A DKconfig12 Support for remote processors (such as DSP coprocessors). These
38 tristate "i.MX DSP remoteproc support"
75 and DSP on OMAP4) via the remote processor framework.
81 offloaded to remote DSP processors using this framework).
120 offloaded to remote DSP processors using this framework).
135 Say Y here here to support Keystone remote processors (DSP)
230 used to control subsystems such as ADSP (Audio DSP),
231 CDSP (Compute DSP), MPSS (Modem Peripheral SubSystem), and
266 modem or DSP.
315 tristate "TI K3 DSP remoteproc support"
[all …]
/linux/Documentation/sound/designs/
A Dcompress-offload.rst17 In recent years, audio digital signal processors (DSP) were integrated
68 streaming compressed data to a DSP, with the assumption that the
75 DSP, eg. Android HAL or PulseAudio sinks. By construction, regular
95 is transmitted to the audio DSP. DMA transfers from main memory to an
132 This routines returns the actual settings used by the DSP. Changes to
140 refilled or the delay due to decoding/encoding/io on the DSP.
218 interface to pass this information to the DSP. Also DSP and userspace needs to
247 - then call partial_drain to flush most of buffer in DSP
249 - DSP switches to second track
290 coupling between the DSP and the host stack, limiting power savings.
[all …]
/linux/arch/arc/
A DKconfig368 bool "Reg Pair ACCL:ACCH (FPU and/or MPY > 6 and/or DSP)"
382 prompt "DSP support"
391 bool "No DSP extension presence in HW"
393 No DSP extension presence in HW
396 bool "DSP extension in HW, no support for userspace"
400 DSP extension presence in HW, no support for DSP-enabled userspace
405 bool "Support DSP for userspace apps"
410 DSP extension presence in HW, support save / restore DSP registers to
411 run DSP-enabled userspace applications
414 bool "Support DSP with AGU for userspace apps"
[all …]
/linux/Documentation/devicetree/bindings/iommu/
A Dti,omap-iommu.txt7 "ti,dra7-dsp-iommu" for DRA7xx DSP IOMMU instances
27 is required for DSP IOMMU instances on DRA7xx SoCs. The
28 instance number should be 0 for DSP MDMA MMUs and 1 for
29 DSP EDMA MMUs.
/linux/Documentation/devicetree/bindings/mfd/
A Dstericsson,db8500-prcmu.yaml115 description: Smart Video Accelerator (SVA) multimedia DSP (MMDSP)
116 voltage regulator. This is the voltage for the accelerator DSP
122 description: Smart Video Accelerator (SVA) multimedia DSP (MMDSP)
128 description: Smart Video Accelerator (SVA) multimedia DSP (MMDSP)
134 description: Smart Image Accelerator (SIA) multimedia DSP (MMDSP)
135 voltage regulator. This is the voltage for the accelerator DSP
141 description: Smart Image Accelerator (SIA) multimedia DSP (MMDSP)
147 description: Smart Image Accelerator (SIA) multimedia DSP (MMDSP)
/linux/Documentation/devicetree/bindings/arm/omap/
A Ddsp.txt1 * TI - DSP (Digital Signal Processor)
3 TI DSP included in OMAP SoC
/linux/Documentation/devicetree/bindings/powerpc/nintendo/
A Dgamecube.txt45 1.c) The Digital Signal Procesor (DSP) node
53 - reg : should contain the DSP registers location and length
54 - interrupts : should contain the DSP interrupt
60 The ARAM node must be placed under the DSP node.
/linux/sound/soc/sof/
A DKconfig6 generic open source audio DSP firmware for multiple devices.
154 if you are trying to debug IPC with the DSP firmware.
173 memory -> DSP resource (memory, register, etc)
174 before the audio DSP is suspended. This will increase the suspend
191 the DSP with test IPCs and gather stats about response times.
196 bool "SOF retain DSP context on any FW exceptions"
198 This option keeps the DSP in D0 state so that firmware debug
200 Say Y if you want to retain DSP context for FW exceptions.
/linux/Documentation/devicetree/bindings/sound/
A Dqcom,q6dsp-lpass-clocks.yaml7 title: Qualcomm DSP LPASS Clock Controller binding
13 This binding describes the Qualcomm DSP Clock Controller
/linux/Documentation/devicetree/bindings/interrupt-controller/
A Dti,keystone-irq.txt3 On Keystone SOCs, DSP cores can send interrupts to ARM
5 The IRQ handler running on HOST OS can identify DSP signal source by
/linux/Documentation/devicetree/bindings/misc/
A Dqcom,fastrpc.txt5 invocations across DSP and APPS boundaries. This enables developers
6 to offload tasks to the DSP and free up the application processor for
/linux/Documentation/devicetree/bindings/dsp/
A Dfsl,dsp.yaml7 title: NXP i.MX8 DSP core
14 Some boards from i.MX8 family contain a DSP core used for
71 used by DSP (see bindings/reserved-memory/reserved-memory.txt)

Completed in 33 milliseconds

12345