| /linux/drivers/spi/ |
| A D | spi-zynq-qspi.c | 183 u32 config_reg; in zynq_qspi_init_hw() local
189 config_reg = 0; in zynq_qspi_init_hw()
192 config_reg |= ZYNQ_QSPI_LCFG_TWO_MEM; in zynq_qspi_init_hw()
294 u32 config_reg; in zynq_qspi_chipselect() local
300 config_reg &= ~ZYNQ_QSPI_LCFG_U_PAGE; in zynq_qspi_chipselect()
302 config_reg |= ZYNQ_QSPI_LCFG_U_PAGE; in zynq_qspi_chipselect()
310 config_reg &= ~ZYNQ_QSPI_CONFIG_PCS; in zynq_qspi_chipselect()
312 config_reg |= ZYNQ_QSPI_CONFIG_PCS; in zynq_qspi_chipselect()
336 u32 config_reg, baud_rate_val = 0; in zynq_qspi_config_op() local
358 config_reg |= ZYNQ_QSPI_CONFIG_CPHA_MASK; in zynq_qspi_config_op()
[all …]
|
| A D | spi-zynqmp-gqspi.c | 270 u32 config_reg; in zynqmp_qspi_init_hw() local
293 config_reg &= ~GQSPI_CFG_MODE_EN_MASK; in zynqmp_qspi_init_hw()
297 config_reg &= ~GQSPI_CFG_ENDIAN_MASK; in zynqmp_qspi_init_hw()
301 config_reg |= GQSPI_CFG_WP_HOLD_MASK; in zynqmp_qspi_init_hw()
305 config_reg &= ~GQSPI_CFG_CLK_PHA_MASK; in zynqmp_qspi_init_hw()
307 config_reg &= ~GQSPI_CFG_CLK_POL_MASK; in zynqmp_qspi_init_hw()
451 u32 config_reg, baud_rate_val = 0; in zynqmp_qspi_config_op() local
639 u32 config_reg, genfifoentry; in zynqmp_process_dma_irq() local
738 u32 rx_bytes, rx_rem, config_reg; in zynqmp_qspi_setuprxdma() local
798 u32 config_reg; in zynqmp_qspi_write_op() local
[all …]
|
| /linux/drivers/iio/common/ms_sensors/ |
| A D | ms_sensors_i2c.c | 254 u8 *config_reg) in ms_sensors_read_config_reg() argument
264 ret = i2c_master_recv(client, config_reg, 1); in ms_sensors_read_config_reg()
288 u8 config_reg; in ms_sensors_write_resolution() local
295 config_reg &= 0x7E; in ms_sensors_write_resolution()
300 config_reg); in ms_sensors_write_resolution()
319 u8 config_reg; in ms_sensors_show_battery_low() local
345 u8 config_reg; in ms_sensors_show_heater() local
373 u8 val, config_reg; in ms_sensors_write_heater() local
390 config_reg &= 0xFB; in ms_sensors_write_heater()
391 config_reg |= val << 2; in ms_sensors_write_heater()
[all …]
|
| /linux/drivers/input/misc/ |
| A D | max77693-haptic.c | 107 unsigned int value, config_reg; in max77693_haptic_configure() local
116 config_reg = MAX77693_HAPTIC_REG_CONFIG2; in max77693_haptic_configure()
122 config_reg = MAX77843_HAP_REG_MCONFIG; in max77693_haptic_configure()
129 config_reg, value); in max77693_haptic_configure()
|
| /linux/drivers/hwmon/ |
| A D | max6620.c | 99 static const u8 config_reg[] = { variable
171 ret = i2c_smbus_read_byte_data(client, config_reg[i]); in max6620_update_device()
449 reg = i2c_smbus_read_byte_data(client, config_reg[i]); in max6620_init_client()
456 err = i2c_smbus_write_byte_data(client, config_reg[i], data->fancfg[i]); in max6620_init_client()
|
| /linux/drivers/clk/qcom/ |
| A D | clk-pll.c | 103 regmap_read(pll->clkr.regmap, pll->config_reg, &config); in clk_pll_recalc_rate()
162 regmap_write(pll->clkr.regmap, pll->config_reg, f->ibits); in clk_pll_set_rate()
242 regmap_update_bits(regmap, pll->config_reg, mask, val); in clk_pll_configure()
|
| A D | clk-hfpll.h | 17 u32 config_reg; member
|
| A D | clk-pll.h | 43 u32 config_reg; member
|
| A D | hfpll.c | 22 .config_reg = 0x14,
|
| A D | gcc-msm8960.c | 32 .config_reg = 0x3174,
59 .config_reg = 0x3154,
87 .config_reg = 0x3204,
113 .config_reg = 0x3244,
127 .config_reg = 0x3304,
153 .config_reg = 0x3284,
179 .config_reg = 0x32c4,
205 .config_reg = 0x3304,
219 .config_reg = 0x3404,
244 .config_reg = 0x31d4,
|
| A D | gcc-ipq806x.c | 32 .config_reg = 0x30d4,
59 .config_reg = 0x3174,
86 .config_reg = 0x3154,
114 .config_reg = 0x3204,
140 .config_reg = 0x3244,
166 .config_reg = 0x3304,
191 .config_reg = 0x31d4,
232 .config_reg = 0x31b4,
|
| A D | a53-pll.c | 113 pll->config_reg = 0x14; in qcom_a53pll_probe()
|
| A D | gcc-msm8939.c | 57 .config_reg = 0x21010,
88 .config_reg = 0x20010,
119 .config_reg = 0x4a010,
150 .config_reg = 0x23010,
181 .config_reg = 0x22010,
228 .config_reg = 0x24010,
274 .config_reg = 0x25010,
305 .config_reg = 0x37010,
|
| A D | clk-hfpll.c | 31 regmap_write(regmap, hd->config_reg, hd->config_val); in __clk_hfpll_init_once()
|
| A D | gcc-mdm9615.c | 44 .config_reg = 0x30d4,
82 .config_reg = 0x3154,
109 .config_reg = 0x31d4,
|
| A D | lcc-ipq806x.c | 30 .config_reg = 0x14,
|
| A D | mmcc-msm8974.c | 167 .config_reg = 0x0014,
194 .config_reg = 0x0050,
221 .config_reg = 0x4110,
236 .config_reg = 0x0090,
|
| A D | mmcc-apq8084.c | 218 .config_reg = 0x0014,
245 .config_reg = 0x0050,
272 .config_reg = 0x4110,
287 .config_reg = 0x0090,
303 .config_reg = 0x00b0,
|
| A D | lcc-mdm9615.c | 32 .config_reg = 0x14,
|
| A D | lcc-msm8960.c | 30 .config_reg = 0x14,
|
| A D | gcc-msm8916.c | 263 .config_reg = 0x21010,
290 .config_reg = 0x20010,
317 .config_reg = 0x4a010,
344 .config_reg = 0x23010,
|
| /linux/drivers/pinctrl/renesas/ |
| A D | core.c | 253 const struct pinmux_cfg_reg *config_reg = in sh_pfc_get_config_reg() local
255 unsigned int r_width = config_reg->reg_width; in sh_pfc_get_config_reg()
256 unsigned int f_width = config_reg->field_width; in sh_pfc_get_config_reg()
272 curr_width = config_reg->var_field_width[m]; in sh_pfc_get_config_reg()
276 if (config_reg->enum_ids[pos + n] == enum_id) { in sh_pfc_get_config_reg()
277 *crp = config_reg; in sh_pfc_get_config_reg()
|
| /linux/drivers/i2c/busses/ |
| A D | i2c-mlxbf.c | 1358 u32 config_reg; in mlxbf_i2c_init_master() local
1395 config_reg = readl(gpio_res->io + MLXBF_I2C_GPIO_0_FUNC_EN_0); in mlxbf_i2c_init_master()
1396 config_reg = MLXBF_I2C_GPIO_SMBUS_GW_ASSERT_PINS(priv->bus, in mlxbf_i2c_init_master()
1397 config_reg); in mlxbf_i2c_init_master()
1398 writel(config_reg, gpio_res->io + MLXBF_I2C_GPIO_0_FUNC_EN_0); in mlxbf_i2c_init_master()
1400 config_reg = readl(gpio_res->io + MLXBF_I2C_GPIO_0_FORCE_OE_EN); in mlxbf_i2c_init_master()
1401 config_reg = MLXBF_I2C_GPIO_SMBUS_GW_RESET_PINS(priv->bus, in mlxbf_i2c_init_master()
1402 config_reg); in mlxbf_i2c_init_master()
1403 writel(config_reg, gpio_res->io + MLXBF_I2C_GPIO_0_FORCE_OE_EN); in mlxbf_i2c_init_master()
|
| /linux/drivers/net/phy/ |
| A D | phylink.c | 2488 uint16_t config_reg, int speed) in phylink_decode_c37_word() argument
2498 mii_lpa_mod_linkmode_x(state->lp_advertising, config_reg, fd_bit); in phylink_decode_c37_word()
2519 uint16_t config_reg) in phylink_decode_sgmii_word() argument
2521 if (!(config_reg & LPA_SGMII_LINK)) { in phylink_decode_sgmii_word()
2526 switch (config_reg & LPA_SGMII_SPD_MASK) { in phylink_decode_sgmii_word()
2540 if (config_reg & LPA_SGMII_FULL_DUPLEX) in phylink_decode_sgmii_word()
|
| /linux/drivers/usb/cdns3/ |
| A D | cdnsp-mem.c | 1223 val = readl(&pdev->op_regs->config_reg); in cdnsp_mem_init()
1225 writel(val, &pdev->op_regs->config_reg); in cdnsp_mem_init()
|