Searched refs:SD0 (Results 1 – 12 of 12) sorted by relevance
| /linux/arch/arm/boot/dts/allwinner/ |
| A D | sun7i-a20-bananapi.dts | 229 "SD0-D1", "SD0-D0", "SD0-CLK", "SD0-CMD", "SD0-D3",
230 "SD0-D2", "", "",
241 "", "", "SD0-DET", "", "", "", "", "",
|
| /linux/drivers/regulator/ |
| A D | max77620-regulator.c | 727 RAIL_SD(SD0, sd0, "in-sd0", SD0, 600000, 1400000, 12500, 0x22, SD0),
744 RAIL_SD(SD0, sd0, "in-sd0", SD0, 800000, 1587500, 12500, 0x22, SD0),
762 RAIL_SD(SD0, sd0, "in-sd0", SD0, 600000, 3387500, 12500, 0xFF, NONE),
|
| /linux/arch/arm64/boot/dts/renesas/ |
| A D | rzg3s-smarc-som.dtsi | 22 * SW_OFF - SD0 is connected to eMMC
23 * SW_ON - SD0 is connected to uSD0 card
159 /* SD0 slot */
|
| A D | rzg2lc-smarc-som.dtsi | 180 * SD0 device selection is XOR between GPIO_SD0_DEV_SEL and SW1[2]
|
| A D | rzg2l-smarc-som.dtsi | 262 * SD0 device selection is XOR between GPIO_SD0_DEV_SEL and SW1[2]
|
| /linux/Documentation/devicetree/bindings/display/bridge/ |
| A D | sil,sii9022.yaml | 66 on. There are 4 FIFOs and 4 I2S pins (SD0 - SD3). Any I2S pin can be
69 default value is <0>, describing SD0 pin being routed to HDMI audio
|
| /linux/Documentation/devicetree/bindings/regulator/ |
| A D | regulator-max77620.txt | 18 in-sd0-supply: Input supply for SD0, INA-SD0 or INB-SD0 pins.
|
| /linux/Documentation/devicetree/bindings/media/ |
| A D | renesas,drif.yaml | 20 | |-----SD0------->|D0 |
164 # | |-----SD0------->|D0 |
|
| /linux/drivers/scsi/ |
| A D | nsp32.h | 239 # define SD0 BIT(0) macro
|
| /linux/arch/arm64/boot/dts/xilinx/ |
| A D | zynqmp-zcu100-revC.dts | 494 /* SD0 only supports 3.3V, no level shifter */
|
| /linux/arch/arm/boot/dts/marvell/ |
| A D | armada-385-clearfog-gtr.dtsi | 31 21,28,37,38,39,40 - SD0
|
| /linux/arch/powerpc/boot/dts/ |
| A D | akebono.dts | 136 SD0: sd@30000000000 { label
|
Completed in 26 milliseconds