Searched refs:Shutdown (Results 1 – 25 of 45) sorted by relevance
12
| /linux/Documentation/devicetree/bindings/clock/ |
| A D | idt,versaclock5.yaml | 34 SH (en_global_shutdown) and SP bits of the Primary Source and Shutdown
42 1 0 Active/Shutdown
43 1 1 Inactive/Shutdown
91 bit of the Primary Source and Shutdown Register.
101 Shutdown Register.
|
| /linux/Documentation/devicetree/bindings/sound/ |
| A D | qcom,wsa8840.yaml | 28 description: Powerdown/Shutdown line to use (pin SD_N)
32 description: Powerdown/Shutdown line to use (pin SD_N)
|
| A D | qcom,wsa881x.yaml | 29 description: GPIO spec for Powerdown/Shutdown line to use
|
| A D | qcom,wsa883x.yaml | 29 description: GPIO spec for Powerdown/Shutdown line to use (pin SD_N)
|
| /linux/Documentation/sound/soc/ |
| A D | pops-clicks.rst | 28 Shutdown Order :- Digital Mute --> Output PGA --> Mixers --> DAC
45 Shutdown Order - ADC --> Mixers --> Input PGA
|
| /linux/Documentation/ABI/testing/ |
| A D | sysfs-driver-input-axp-pek | 10 Description: Shutdown time in us. Board is powered off if the button is pressed
|
| A D | sysfs-class-mic | 85 "crashed" Shutdown because of a HW or SW crash.
86 "halted" Shutdown because of a halt command.
87 "poweroff" Shutdown because of a poweroff command.
88 "restart" Shutdown because of a restart command.
|
| /linux/Documentation/hwmon/ |
| A D | thmc50.rst | 47 sensors, limits can be set through the appropriate Overtemperature Shutdown
50 temperature gets higher then the Overtemperature Shutdown value; it stays on
|
| A D | tmp102.rst | 22 set through the Overtemperature Shutdown register and Hysteresis register. The
|
| A D | lm78.rst | 46 when the Overtemperature Shutdown limit is crossed; it is triggered again
50 is above the Overtemperature Shutdown value. Measurements are guaranteed
|
| A D | lm75.rst | 152 Overtemperature Shutdown register and Hysteresis register. Each value can be
155 gets higher then the Overtemperature Shutdown value; it stays on until
|
| A D | lm80.rst | 46 drops below the HOT Hysteresis. The Overtemperature Shutdown (OS) limits
|
| A D | via686a.rst | 49 when the Overtemperature Shutdown limit is crossed; it is triggered again
|
| A D | abituguru-datasheet.rst | 245 - Volt sensor: Shutdown if alarm persist for more than 4 seconds (RW)
246 - Temp sensor: Shutdown if temp is over the shutdown threshold (RW)
320 Shutdown if alarm persist for more than 4 seconds (RW)
|
| /linux/Documentation/driver-api/thermal/ |
| A D | nouveau_thermal.rst | 37 * Shutdown:
50 * Shutdown: temp1_emergency and temp1_emergency_hyst.
|
| /linux/drivers/soc/loongson/ |
| A D | Kconfig | 27 Disk), ACPI S5 (Soft Shutdown) and supports multiple wake-up methods
|
| /linux/Documentation/devicetree/bindings/power/reset/ |
| A D | atmel,at91sam9260-shdwc.yaml | 7 title: Microchip AT91 SHDWC Shutdown Controller
|
| A D | atmel,sama5d2-shdwc.yaml | 7 title: Microchip AT91 SAMA5D2 SHDWC Shutdown Controller
|
| /linux/Documentation/devicetree/bindings/remoteproc/ |
| A D | qcom,pas-common.yaml | 35 - description: Shutdown acknowledge interrupt
|
| A D | qcom,sc7280-adsp-pil.yaml | 37 - description: Shutdown acknowledge interrupt
|
| A D | qcom,sc7280-wpss-pil.yaml | 33 - description: Shutdown acknowledge interrupt
|
| A D | qcom,sc7180-mss-pil.yaml | 43 - description: Shutdown acknowledge interrupt
|
| /linux/arch/mips/include/asm/mach-loongson64/ |
| A D | boot_param.h | 184 u64 Shutdown; member
|
| /linux/arch/mips/loongson64/ |
| A D | env.c | 168 loongson_sysconf.poweroff_addr = boot_p->reset_system.Shutdown; in prom_lefi_init_env()
|
| /linux/Documentation/devicetree/bindings/iio/adc/ |
| A D | maxim,max34408.yaml | 46 Shutdown Output. Open-drain output. This output transitions to high impedance
|
Completed in 31 milliseconds
12