| /linux/Documentation/userspace-api/media/dvb/ |
| A D | fe-set-voltage.rst | 13 FE_SET_VOLTAGE - Allow setting the DC level sent to the antenna subsystem.
34 This ioctl allows to set the DC voltage level sent through the antenna
37 Usually, a satellite antenna subsystems require that the digital TV
45 .. attention:: if more than one device is connected to the same antenna,
|
| A D | fe-set-tone.rst | 37 Usually, satellite antenna subsystems require that the digital TV device
42 .. attention:: If more than one device is connected to the same antenna,
|
| A D | fe-diseqc-send-master-cmd.rst | 36 to the antenna subsystem.
|
| A D | fe-enable-high-lnb-voltage.rst | 34 to compensate for long antenna cables.
|
| A D | fe-diseqc-reset-overload.rst | 13 FE_DISEQC_RESET_OVERLOAD - Restores the power to the antenna subsystem, if it was powered off due -…
|
| /linux/Documentation/userspace-api/media/v4l/ |
| A D | ext-ctrls-rf-tuner.rst | 12 In this context, RF tuner is radio receiver circuit between antenna and
13 demodulator. It receives radio frequency (RF) from the antenna and
60 path, just right after the antenna input. The difference between the
68 signal path. It is located very close to tuner antenna input. Used
|
| /linux/arch/arm/boot/dts/broadcom/ |
| A D | bcm2711-rpi-cm4.dtsi | 70 /* internal antenna enabled */
78 /* external antenna disabled */
|
| /linux/Documentation/devicetree/bindings/net/wireless/ |
| A D | silabs,wfx.yaml | 39 - const: silabs,wf200 # Chip alone without antenna
68 silabs,antenna-config-file:
70 description: Use an alternative file for antenna configuration (aka
|
| A D | brcm,bcm4329-fmac.yaml | 116 apple,antenna-sku:
118 description: Antenna SKU used to identify a specific antenna configuration
120 platforms with different antenna configs to have different firmware and/or
|
| /linux/drivers/staging/vt6656/ |
| A D | main_usb.c | 185 u8 antenna; in vnt_init_registers() local
289 antenna = priv->eeprom[EEP_OFS_ANTENNA]; in vnt_init_registers()
291 if (antenna & EEP_ANTINV) in vnt_init_registers()
296 antenna &= (EEP_ANTENNA_AUX | EEP_ANTENNA_MAIN); in vnt_init_registers()
298 if (antenna == 0) /* if not set default is both */ in vnt_init_registers()
299 antenna = (EEP_ANTENNA_AUX | EEP_ANTENNA_MAIN); in vnt_init_registers()
301 if (antenna == (EEP_ANTENNA_AUX | EEP_ANTENNA_MAIN)) { in vnt_init_registers()
312 if (antenna & EEP_ANTENNA_AUX) { in vnt_init_registers()
|
| /linux/Documentation/networking/ |
| A D | radiotap-headers.rst | 91 0x01 //<-- antenna
107 int pkt_rate_100kHz = 0, antenna = 0, pwr = 0;
136 antenna = *iterator.this_arg);
|
| /linux/Documentation/admin-guide/media/ |
| A D | si470x.rst | 34 - Si4704: FM radio receiver, no external antenna required
35 - Si4705: FM radio receiver, no external antenna required, RDS support, Dig I/O
36 - Si4706: Enhanced FM RDS/TMC radio receiver, no external antenna required, RDS
|
| /linux/arch/arm64/boot/dts/apple/ |
| A D | t8112-j493.dts | 50 apple,antenna-sku = "XX";
|
| A D | t8112-j413.dts | 50 apple,antenna-sku = "XX";
|
| A D | t8103-jxxx.dtsi | 79 apple,antenna-sku = "XX";
|
| /linux/Documentation/ABI/testing/ |
| A D | sysfs-bus-iio-sx9324 | 11 + connected to an antenna where it can act as a base
|
| /linux/drivers/net/wireless/ralink/rt2x00/ |
| A D | rt2x00link.c | 252 void rt2x00link_reset_tuner(struct rt2x00_dev *rt2x00dev, bool antenna) in rt2x00link_reset_tuner() argument
284 if (antenna) in rt2x00link_reset_tuner()
|
| /linux/drivers/media/tuners/ |
| A D | mt20xx.c | 428 static void mt2050_set_antenna(struct dvb_frontend *fe, unsigned char antenna) in mt2050_set_antenna() argument
434 buf[1] = antenna ? 0x11 : 0x10; in mt2050_set_antenna()
436 tuner_dbg("mt2050: enabled antenna connector %d\n", antenna); in mt2050_set_antenna()
|
| /linux/drivers/net/wireless/silabs/wfx/ |
| A D | data_rx.c | 73 hdr->antenna = 0; in wfx_rx_cb()
|
| /linux/drivers/net/wireless/ath/ath9k/ |
| A D | Makefile | 9 antenna.o \
|
| /linux/Documentation/devicetree/bindings/gnss/ |
| A D | gnss-common.yaml | 24 device and the receiver antenna.
|
| /linux/Documentation/devicetree/bindings/media/i2c/ |
| A D | max2175.txt | 32 in this hardware for AM antenna input.
|
| /linux/drivers/staging/rtl8712/ |
| A D | rtl871x_mp_ioctl.c | 320 u32 antenna; in oid_rt_pro_set_antenna_bb_hdl() local
326 antenna = *((u32 *)poid_par_priv->information_buf); in oid_rt_pro_set_antenna_bb_hdl()
327 Adapter->mppriv.antenna_tx = (u16)((antenna & 0xFFFF0000) >> 16); in oid_rt_pro_set_antenna_bb_hdl()
328 Adapter->mppriv.antenna_rx = (u16)(antenna & 0x0000FFFF); in oid_rt_pro_set_antenna_bb_hdl()
|
| /linux/Documentation/devicetree/bindings/iio/proximity/ |
| A D | awinic,aw96103.yaml | 20 power of the antenna to keep the SAR within a safe range. Therefore,
|
| /linux/drivers/net/wireless/intersil/p54/ |
| A D | eeprom.h | 114 } __packed, antenna);
|