| /linux/kernel/trace/ |
| A D | trace_events_user.c | 142 int attempt; member
411 int attempt) in user_event_mm_fault_in() argument
420 if (attempt > 10) in user_event_mm_fault_in()
450 int attempt = fault->attempt; in user_event_enabler_fault_fixup() local
507 fault->attempt = attempt; in user_event_enabler_queue_fault()
539 *attempt += 1; in user_event_enabler_write()
597 int attempt; in user_event_enabler_update() local
620 attempt = 0; in user_event_enabler_update()
888 int attempt = 0; in user_event_enabler_create() local
916 &attempt); in user_event_enabler_create()
[all …]
|
| /linux/Documentation/ABI/testing/ |
| A D | sysfs-bus-vdpa | 28 attempt to bind to the device. This is useful for overriding
36 attempt to unbind from the device. This may be useful when
51 device from its current driver or make any attempt to
|
| A D | sysfs-bus-fsl-mc | 6 the driver to attempt to bind to the device found at
19 driver to attempt to unbind from the device found at
|
| A D | sysfs-memory-page-offline | 8 physical address of the page. The kernel will then attempt
31 kernel will then attempt to hard-offline the page, by
|
| A D | sysfs-driver-ucsi-ccg | 5 Tell the driver for Cypress CCGx Type-C controller to attempt
|
| A D | sysfs-class-remoteproc | 44 Writing "start" will attempt to start the processor running the
49 Writing "stop" will attempt to halt the remote processor and
|
| A D | sysfs-bus-cdx | 66 Writing n/0/off will attempt to disable the CDX bus and.
67 writing y/1/on will attempt to enable the CDX bus. Reading this file
|
| A D | sysfs-bus-amba | 14 device from its current driver or make any attempt to
|
| /linux/drivers/char/tpm/ |
| A D | tpm_tis_spi_cr50.c | 101 unsigned int attempt = ++phy->irq_confirmation_attempt; in cr50_ensure_access_delay() local
107 attempt); in cr50_ensure_access_delay()
108 } else if (attempt > MAX_IRQ_CONFIRMATION_ATTEMPTS) { in cr50_ensure_access_delay()
|
| /linux/drivers/input/serio/ |
| A D | libps2.c | 47 int attempt = 0; in ps2_do_sendbyte() local
68 } while (ps2dev->nak == PS2_RET_NAK && ++attempt < max_attempts); in ps2_do_sendbyte()
88 if (error || attempt > 1) in ps2_do_sendbyte()
91 byte, error, ps2dev->nak, attempt); in ps2_do_sendbyte()
|
| /linux/Documentation/devicetree/bindings/thermal/ |
| A D | qcom-lmh.yaml | 54 will attempt to remove frequency throttling.
59 will attempt to throttle the frequency.
|
| /linux/arch/powerpc/platforms/pseries/ |
| A D | mobility.c | 673 unsigned int attempt = 1; in pseries_suspend() local
702 attempt, max_attempts, ret); in pseries_suspend()
704 if (attempt == max_attempts) in pseries_suspend()
724 attempt++; in pseries_suspend()
|
| /linux/Documentation/sound/cards/ |
| A D | img-spdif-in.rst | 24 This control is used to attempt acquisition of up to four different sample
30 hw_params will be ignored, and the block will attempt capture for each of the
|
| /linux/Documentation/ABI/stable/ |
| A D | sysfs-bus-mhi | 7 one attempt to power up the device has been done. If read
18 at least one attempt to power up the device has been done. If
|
| A D | sysfs-devices-system-xen_memory | 7 attempt to increase the balloon before giving up. See
27 zero (unlimited), this means that the driver will attempt
|
| A D | sysfs-devices-node | 198 ignored by memory error recovery attempt, usually because
207 failed by memory error recovery attempt. This usually means
215 delayed by memory error recovery attempt. Delayed poisoned
223 recovered by memory error recovery attempt.
|
| /linux/net/bluetooth/ |
| A D | hci_conn.c | 211 conn->attempt++; in hci_add_sco()
225 for (; conn->attempt <= size; conn->attempt++) { in find_next_esco_param()
230 conn, conn->attempt); in find_next_esco_param()
233 return conn->attempt <= size; in find_next_esco_param()
302 conn->attempt++; in hci_enhanced_setup_sync()
317 param = &esco_param_msbc[conn->attempt - 1]; in hci_enhanced_setup_sync()
342 param = &esco_param_msbc[conn->attempt - 1]; in hci_enhanced_setup_sync()
372 param = &sco_param_cvsd[conn->attempt - 1]; in hci_enhanced_setup_sync()
418 conn->attempt++; in hci_setup_sync_conn()
431 param = &esco_param_msbc[conn->attempt - 1]; in hci_setup_sync_conn()
[all …]
|
| /linux/drivers/of/unittest-data/ |
| A D | overlay_bad_add_dup_node.dtso | 10 * result in an attempt to add the same node twice.
|
| A D | overlay_bad_add_dup_prop.dtso | 10 * result in an attempt to update the same property twice.
|
| /linux/arch/x86/kernel/ |
| A D | reboot.c | 631 int attempt = 0; in native_machine_emergency_restart() local
670 if (attempt == 0 && orig_reboot_type == BOOT_ACPI) { in native_machine_emergency_restart()
671 attempt = 1; in native_machine_emergency_restart()
|
| /linux/arch/powerpc/kvm/ |
| A D | book3s_64_mmu_host.c | 81 int attempt = 0; in kvmppc_mmu_map_page() local
163 if (attempt > 1) in kvmppc_mmu_map_page()
176 attempt++; in kvmppc_mmu_map_page()
|
| /linux/Documentation/driver-api/80211/ |
| A D | introduction.rst | 9 These books attempt to give a description of the various subsystems
|
| /linux/Documentation/networking/ |
| A D | xsk-tx-metadata.rst | 22 flag was not required. Applications might attempt to create a umem
23 with a flag first and if it fails, do another attempt without a flag.
|
| /linux/Documentation/process/ |
| A D | development-process.rst | 8 an attempt to document how this community works in a way which is
|
| /linux/Documentation/arch/arm64/ |
| A D | asymmetric-32bit.rst | 91 invalidate the affinity mask saved in (1) and attempt to restore the CPU
143 prevented from being offlined by userspace and any such attempt will
151 asymmetric system, a broken guest at EL1 could still attempt to execute
|