| /linux/Documentation/devicetree/bindings/sound/ |
| A D | rt5640.txt | 38 - realtek,jack-detect-source
40 0: jack-detect is not used
41 1: Use GPIO1 for jack-detect
42 2: Use JD1_IN4P for jack-detect
43 3: Use JD2_IN4N for jack-detect
44 4: Use GPIO2 for jack-detect
45 5: Use GPIO3 for jack-detect
46 6: Use GPIO4 for jack-detect
48 - realtek,jack-detect-not-inverted
49 bool. Normal jack-detect switches give an inverted signal, set this bool
[all …]
|
| A D | rt5651.txt | 19 - realtek,jack-detect-source
21 1: Use JD1_1 pin for jack-detect
22 2: Use JD1_2 pin for jack-detect
23 3: Use JD2 pin for jack-detect
25 - realtek,jack-detect-not-inverted
26 bool. Normal jack-detect switches give an inverted (active-low) signal,
27 set this bool in the rare case you've a jack-detect switch which is not
|
| A D | cirrus,cs42l43.yaml | 95 cirrus,detect-us:
123 Indicates tip detect polarity, inverted implies open-circuit whilst the
129 Indicates if the internal pullup on the tip detect should be disabled.
133 Time in milliseconds a falling edge on the tip detect should be hardware
140 Time in milliseconds a rising edge on the tip detect should be hardware
153 Indicates ring detect polarity, inverted implies open-circuit whilst the
159 Indicates if the internal pullup on the ring detect should be disabled.
163 Time in milliseconds a falling edge on the ring detect should be hardware
170 Time in milliseconds a rising edge on the ring detect should be hardware
|
| A D | st,sta32x.txt | 46 - st,fault-detect-recovery:
47 If present, fault detect recovery is enabled.
52 - st,fault-detect-recovery:
78 - st,invalid-input-detect-mute:
79 If present, automatic invalid input detect mute is enabled.
99 st,invalid-input-detect-mute; // mute if no valid digital
|
| A D | everest,es8326.yaml | 58 everest,jack-detect-inverted:
71 Bit(5) 1 means PIN9 is the irq source after MIC detect.
72 Bit(6) 1 means PIN27 is the irq source after MIC detect.
88 Bit(6) 1 means the chip do not detect jack type after button released.
89 0 means the chip detect jack type again after button released.
|
| A D | samsung,aries-wm8994.yaml | 74 headset-detect-gpios:
87 const: headset-detect
98 - headset-detect-gpios
120 io-channel-names = "headset-detect";
121 headset-detect-gpios = <&gph0 6 GPIO_ACTIVE_HIGH>;
|
| A D | nvidia,tegra-audio-common.yaml | 61 description: The GPIO that detect headphones are plugged in
65 description: The GPIO that detect microphone is plugged in
85 description: The Mic detect GPIO is viable only if HP detect GPIO is active
|
| A D | realtek,rt5645.yaml | 56 hp-detect-gpios:
58 A GPIO spec for the external headphone detect pin. If jd-mode = 0, we
59 will get the JD status by getting the value of hp-detect-gpios.
123 hp-detect-gpios = <&gpio 19 0>;
|
| /linux/Documentation/devicetree/bindings/net/ |
| A D | smsc-lan87xx.txt | 12 - smsc,disable-energy-detect:
13 If set, do not enable energy detect mode for the SMSC phy.
14 default: enable energy detect mode
17 smsc phy with disabled energy detect mode on an am335x based board.
25 smsc,disable-energy-detect;
|
| /linux/sound/firewire/digi00x/ |
| A D | digi00x-proc.c | 42 bool detect; in proc_read_clock() local
58 if (snd_dg00x_stream_check_external_clock(dg00x, &detect) < 0) in proc_read_clock()
60 snd_iprintf(buf, "External source: %s\n", detect ? "detected" : "not"); in proc_read_clock()
61 if (!detect) in proc_read_clock()
|
| /linux/drivers/gpu/drm/ |
| A D | drm_privacy_screen_x86.c | 17 bool (*detect)(void); member
68 .detect = detect_thinkpad_privacy_screen,
78 .detect = detect_chromeos_privacy_screen,
88 if (!arch_init_data[i].detect()) in drm_privacy_screen_lookup_init()
|
| /linux/Documentation/devicetree/bindings/usb/ |
| A D | qcom,pmic-typec.yaml | 51 - description: Type-C Legacy cable detect
65 - const: or-rid-detect-change
66 - const: vpd-detect
71 - const: legacy-cable-detect
72 - const: try-snk-src-detect
160 interrupt-names = "or-rid-detect-change",
161 "vpd-detect",
166 "legacy-cable-detect",
167 "try-snk-src-detect",
|
| A D | usb-nop-xceiv.yaml | 36 vbus-detect-gpio:
48 Specify if the USB phy can detect the remote wakeup signal
68 vbus-detect-gpio = <&gpio2 13 GPIO_ACTIVE_HIGH>;
|
| /linux/drivers/input/mouse/ |
| A D | psmouse-base.c | 729 .detect = ps2bare_detect,
737 .detect = ps2pp_detect,
751 .detect = cypress_detect,
759 .detect = genius_detect,
810 .detect = alps_detect,
845 .detect = hgpk_detect,
872 .detect = fsp_detect,
880 .detect = cortron_detect,
896 .detect = vmmouse_detect,
905 .detect = byd_detect,
[all …]
|
| /linux/Documentation/driver-api/media/drivers/ |
| A D | radiotrack.rst | 129 Default: BASE <-- 0xc8 (current volume, no stereo detect,
132 Card Off: BASE <-- 0x00 (audio mute, no stereo detect,
138 Volume Down: BASE <-- 0x48 (volume down, no stereo detect,
143 Volume Up: BASE <-- 0x88 (volume up, no stereo detect,
148 Check Stereo: BASE <-- 0xd8 (current volume, stereo detect,
160 BASE <-- 0x01 (audio mute, no stereo detect, radio
162 BASE <-- 0x03 (audio mute, no stereo detect, radio
165 BASE <-- 0x05 (audio mute, no stereo detect, radio
167 BASE <-- 0x07 (audio mute, no stereo detect, radio
|
| /linux/arch/arm64/boot/dts/qcom/ |
| A D | pm4125.dtsi | 56 interrupt-names = "or-rid-detect-change",
57 "vpd-detect",
62 "legacy-cable-detect",
63 "try-snk-src-detect";
|
| /linux/Documentation/devicetree/bindings/iio/frequency/ |
| A D | adi,adf4350.yaml | 39 description: Lock detect GPIO.
69 adi,lock-detect-precision-6ns-enable:
71 description: Enables 6ns lock detect precision. Default = 10ns.
73 adi,lock-detect-function-integer-n-enable:
76 Enables lock detect for integer-N mode. Default = factional-N mode.
94 5: Analog lock detect
95 6: Digital lock detect
|
| /linux/drivers/usb/common/ |
| A D | Kconfig | 23 of registers that can be used to detect the vendor and product which
46 to detect USB ID pin, and another input GPIO may be also used to detect
48 device if an input GPIO is only used to detect Vbus pin.
|
| /linux/drivers/gpu/drm/display/ |
| A D | drm_bridge_connector.c | 181 struct drm_bridge *detect = bridge_connector->bridge_detect; in drm_bridge_connector_detect() local
184 if (detect) { in drm_bridge_connector_detect()
185 status = detect->funcs->detect(detect); in drm_bridge_connector_detect()
232 .detect = drm_bridge_connector_detect,
|
| /linux/Documentation/devicetree/bindings/mfd/ |
| A D | maxim,max8925.yaml | 58 batt-detect:
84 no-insert-detect:
138 batt-detect = <0>;
142 no-insert-detect = <0>;
|
| /linux/drivers/char/ipmi/ |
| A D | ipmi_poweroff.c | 514 int (*detect)(struct ipmi_user *user); member
520 .detect = ipmi_atca_detect,
523 .detect = ipmi_cpi1_detect,
526 .detect = ipmi_dell_chassis_detect,
529 .detect = ipmi_hp_chassis_detect,
534 .detect = ipmi_chassis_detect,
612 if (poweroff_functions[i].detect(ipmi_user)) in ipmi_po_new_smi()
|
| /linux/Documentation/devicetree/bindings/power/supply/ |
| A D | sbs,sbs-manager.yaml | 83 sbs,battery-detect-gpios = <&batman 1 1>;
95 sbs,battery-detect-gpios = <&batman 2 1>;
107 sbs,battery-detect-gpios = <&batman 3 1>;
|
| A D | sc27xx-fg.yaml | 27 battery-detect-gpios:
58 - battery-detect-gpios
94 battery-detect-gpios = <&pmic_eic 9 GPIO_ACTIVE_HIGH>;
|
| /linux/Documentation/ABI/testing/ |
| A D | sysfs-class-power-rt9471 | 24 This entry allows enabling the USB BC12 port detect function of rt9471 charger
26 port detect and report the usb port type when port detect is done. See
|
| /linux/arch/arm/boot/dts/st/ |
| A D | stih410-pinctrl.dtsi | 15 usb-oc-detect = <&pio35 0 ALT1 IN>;
24 usb-oc-detect = <&pio35 2 ALT1 IN>;
|