Searched refs:mlx5_core_info (Results 1 – 15 of 15) sorted by relevance
| /linux/drivers/net/ethernet/mellanox/mlx5/core/fpga/ |
| A D | core.h | 79 mlx5_core_info((__adev)->mdev, "FPGA: " format, ##__VA_ARGS__)
82 mlx5_core_info((__adev)->mdev, "FPGA: " format, ##__VA_ARGS__)
|
| /linux/drivers/net/ethernet/mellanox/mlx5/core/steering/hws/ |
| A D | mlx5hws_internal.h | 38 #define mlx5hws_info(ctx, arg...) mlx5_core_info((ctx)->mdev, ##arg)
|
| /linux/drivers/net/ethernet/mellanox/mlx5/core/diag/ |
| A D | crdump.c | 59 mlx5_core_info(dev, "SW reset semaphore is already in use\n"); in mlx5_crdump_collect()
|
| /linux/drivers/net/ethernet/mellanox/mlx5/core/ |
| A D | main.c | 946 mlx5_core_info(dev, "PTM is not supported by PCIe\n"); in mlx5_pci_init()
1172 mlx5_core_info(dev, "firmware version: %d.%d.%d\n", fw_rev_maj(dev), in mlx5_function_enable()
2025 mlx5_core_info(__dev, "%s Device state = %d health sensors: %d pci_status: %d. " fmt, \
2055 mlx5_core_info(dev, "%s Device state = %d pci_status: %d. Exit, result = %d, %s\n", in mlx5_pci_err_detected()
2076 mlx5_core_info(dev, in wait_vital()
2095 mlx5_core_info(dev, "%s Device state = %d pci_status: %d. Enter\n", in mlx5_pci_slot_reset()
2118 mlx5_core_info(dev, "%s Device state = %d pci_status: %d. Exit, err = %d, result = %d, %s\n", in mlx5_pci_slot_reset()
2200 mlx5_core_info(dev, "Shutdown was called\n"); in shutdown()
|
| A D | fw_reset.c | 339 mlx5_core_info(dev, "Live patch updated firmware version: %d.%d.%d\n", fw_rev_maj(dev), in mlx5_fw_live_patch_event()
512 mlx5_core_info(dev, "PCI Link up\n"); in mlx5_pci_link_toggle()
530 mlx5_core_info(dev, "Firmware responds to PCI config cycles again\n"); in mlx5_pci_link_toggle()
|
| A D | events.c | 256 mlx5_core_info(events->dev, in port_module()
|
| A D | rl.c | 381 mlx5_core_info(dev, "Rate limit: %u rates are supported, range: %uMbps to %uMbps\n", in mlx5_init_rl_table()
|
| A D | mlx5_core.h | 92 #define mlx5_core_info(__dev, format, ...) \ macro
|
| A D | fs_counters.c | 264 mlx5_core_info(dev, in mlx5_fc_stats_bulk_query_size_increase()
|
| A D | health.c | 347 mlx5_core_info(dev, "health recovery succeeded\n"); in mlx5_health_try_recover()
|
| A D | en_main.c | 5252 mlx5_core_info(priv->mdev, "Assigned random MAC address %pM\n", netdev->dev_addr); in mlx5e_set_netdev_dev_addr()
|
| /linux/drivers/net/ethernet/mellanox/mlx5/core/en/ |
| A D | params.h | 157 mlx5_core_info(mdev, "MLX5E: StrdRq(%d) RqSz(%ld) StrdSz(%ld) RxCqeCmprss(%d %s)\n", in mlx5e_params_print_info()
|
| /linux/drivers/net/ethernet/mellanox/mlx5/core/lag/ |
| A D | lag.c | 204 mlx5_core_info(dev, "lag map active ports: %s\n", buf); in mlx5_lag_print_mapping()
216 mlx5_core_info(dev, "lag map:%s\n", buf); in mlx5_lag_print_mapping()
628 mlx5_core_info(dev0, "shared_fdb:%d mode:%s\n", in mlx5_create_lag()
644 mlx5_core_info(dev0, "Operation mode is single FDB\n"); in mlx5_create_lag()
|
| /linux/drivers/net/ethernet/mellanox/mlx5/core/en_accel/ |
| A D | ipsec.c | 1221 mlx5_core_info(mdev, "mlx5e: IPSec ESP acceleration enabled\n"); in mlx5e_ipsec_build_netdev()
|
| /linux/drivers/net/ethernet/mellanox/mlx5/core/steering/ |
| A D | dr_types.h | 27 #define mlx5dr_info(dmn, arg...) mlx5_core_info((dmn)->mdev, ##arg)
|
Completed in 53 milliseconds