Home
last modified time | relevance | path

Searched refs:phydev_warn (Results 1 – 22 of 22) sorted by relevance

/linux/drivers/net/phy/
A Dmicrochip.c101 phydev_warn(phydev, "Failed to get current page\n"); in lan88xx_TR_reg_set()
111 phydev_warn(phydev, "Failed to write TR low data\n"); in lan88xx_TR_reg_set()
118 phydev_warn(phydev, "Failed to write TR high data\n"); in lan88xx_TR_reg_set()
128 phydev_warn(phydev, "Failed to write data in reg\n"); in lan88xx_TR_reg_set()
151 phydev_warn(phydev, "Failed to Set Register[0x0F82]\n"); in lan88xx_config_TR_regs()
159 phydev_warn(phydev, "Failed to Set Register[0x168C]\n"); in lan88xx_config_TR_regs()
167 phydev_warn(phydev, "Failed to Set Register[0x17A2]\n"); in lan88xx_config_TR_regs()
176 phydev_warn(phydev, "Failed to Set Register[0x16A0]\n"); in lan88xx_config_TR_regs()
184 phydev_warn(phydev, "Failed to Set Register[0x16A6]\n"); in lan88xx_config_TR_regs()
192 phydev_warn(phydev, "Failed to Set Register[0x16A4]\n"); in lan88xx_config_TR_regs()
[all …]
A Dmotorcomm.c854 phydev_warn(phydev, "Unsupported value %d for %s using default (%u)\n", in ytphy_get_delay_reg_value()
1113 phydev_warn(phydev, "Freq err:%u\n", freq); in yt8521_probe()
1140 phydev_warn(phydev, "Freq err:%u\n", freq); in yt8521_probe()
1144 phydev_warn(phydev, "PHY id err\n"); in yt8521_probe()
1181 phydev_warn(phydev, "Freq err:%u\n", freq); in yt8531_probe()
1773 phydev_warn(phydev, "Modify TX_CLK_SEL err:%d\n", ret); in yt8531_link_change_notify()
1955 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in ytphy_setup_master_slave()
2754 phydev_warn(phydev, "phy speed err :%d\n", phydev->speed); in yt8821_update_interface()
A Dphy-c45.c96 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in genphy_c45_pma_baset1_setup_master_slave()
233 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in genphy_c45_baset1_an_config_aneg()
1568 phydev_warn(phydev, "At least some EEE link modes are not supported.\n"); in genphy_c45_ethtool_set_eee()
A Dintel-xway.c193 phydev_warn(phydev, in xway_gphy_rgmii_init()
A Dnxp-c45-tja11xx.c679 phydev_warn(priv->phydev, in nxp_c45_process_txts()
775 phydev_warn(phydev, "The period can be set only to 1 second."); in nxp_c45_perout_enable()
781 …phydev_warn(phydev, "The start time is not configurable. Should be set to 0 seconds and 0 nanoseco… in nxp_c45_perout_enable()
787 phydev_warn(phydev, "The phase can be set only to 0 or 500000000 nanoseconds."); in nxp_c45_perout_enable()
A Ddp83640.c568 phydev_warn(phydev, in enable_status_frames()
575 phydev_warn(phydev, "failed to add mc address\n"); in enable_status_frames()
578 phydev_warn(phydev, "failed to delete mc address\n"); in enable_status_frames()
A Dmediatek-ge-soc.c689 phydev_warn(phydev, "TX-VCM SW cal result at low margin 0x%x\n", in tx_vcm_cal_sw()
694 phydev_warn(phydev, "TX-VCM SW cal result at high margin 0x%x\n", in tx_vcm_cal_sw()
A Dphy.c1365 phydev_warn(phydev, "Error %d requesting IRQ %d, falling back to polling\n", in phy_request_interrupt()
1370 phydev_warn(phydev, "Can't enable interrupt, falling back to polling\n"); in phy_request_interrupt()
A Dnxp-tja11xx.c248 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in tja11xx_config_aneg()
A Dphy-core.c494 …phydev_warn(phydev, "Downshift occurred from negotiated speed %s to actual speed %s, check cabling… in phy_check_downshift()
A Dadin.c263 phydev_warn(phydev, in adin_get_reg_value()
A Dair_en8811h.c936 phydev_warn(phydev, "Disabling autoneg is not supported\n"); in en8811h_config_aneg()
A Ddp83867.c526 phydev_warn(phydev, in dp83867_verify_rgmii_cfg()
A Dbcm-phy-lib.c1128 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in bcm_setup_lre_master_slave()
A Drealtek.c1137 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in rtl9000a_config_aneg()
A Dmicrochip_t1.c1001 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in lan87xx_config_aneg()
A Dmarvell.c829 phydev_warn(phydev, "Fail to config marvell phy LED.\n"); in marvell_config_led()
1522 phydev_warn(phydev, "Fast Link Down detection requires EEE to be disabled!\n"); in m88e1540_set_fld()
A Dphy_device.c2310 phydev_warn(phydev, "Unsupported Master/Slave mode\n"); in genphy_setup_master_slave()
A Dmicrel.c1218 phydev_warn(phydev, in ksz9031_config_init()
/linux/drivers/net/ethernet/realtek/
A Dr8169_phy_config.c444 phydev_warn(phydev, "chipset not ready for firmware\n"); in rtl8168d_apply_firmware_cond()
/linux/drivers/net/phy/aquantia/
A Daquantia_main.c696 phydev_warn(phydev, "unrecognised serdes mode %u\n", in aqr107_fill_interface_modes()
/linux/include/linux/
A Dphy.h1854 #define phydev_warn(_phydev, format, args...) \ macro

Completed in 109 milliseconds