| /u-boot/cmd/ |
| A D | cls.c | 13 #define CSI "\x1b[" macro
27 printf(CSI "2J" CSI "1;1H"); in do_video_clear()
|
| /u-boot/arch/arm/dts/ |
| A D | r8a779g0-white-hawk-csi-dsi.dtsi | 3 * Device Tree Source for the R-Car V4H White Hawk CSI/DSI sub-board
|
| A D | meson-g12b-a311d-bananapi-m2s.dts | 21 /* Camera (CSI) bus */
|
| A D | sun50i-a64-amarula-relic.dts | 43 reset-gpios = <&pio 4 14 GPIO_ACTIVE_LOW>; /* CSI-RST-R: PE14 */
44 powerdown-gpios = <&pio 4 15 GPIO_ACTIVE_HIGH>; /* CSI-STBY-R: PE15 */
|
| A D | r8a779a0-falcon-csi-dsi.dtsi | 3 * Device Tree Source for the Falcon CSI/DSI sub-board
|
| A D | meson-g12b-bananapi-cm4-cm4io.dts | 137 /* CSI port */
|
| A D | k3-am62.dtsi | 65 <0x00 0x30101000 0x00 0x30101000 0x00 0x00010100>, /* CSI window */
|
| A D | sun4i-a10-gemei-g9.dts | 67 * 2x cameras via CSI
|
| A D | ste-ab8505.dtsi | 300 // supply for U8500 CSI/DSI; VANA LDO
|
| A D | k3-am62a.dtsi | 65 <0x00 0x30101000 0x00 0x30101000 0x00 0x00010100>, /* CSI window */
|
| A D | sun8i-h2-plus-bananapi-m2-zero.dts | 221 "", "", "", "", "", "", "CSI-PWR-EN", "",
|
| A D | ste-ab8500.dtsi | 364 // supply for U8500 CSI/DSI; VANA LDO
|
| A D | imx8mm-beacon-baseboard.dtsi | 159 /* MIPI CSI-2 bus endpoint */
|
| A D | imx6qdl-apalis.dtsi | 126 /* Note: The CSI module uses on-board 3.3V_SW supply */
136 /* Note: The CSI module uses on-board 3.3V_SW supply */
|
| /u-boot/arch/arm/mach-rockchip/rk3399/ |
| A D | Kconfig | 64 * HDMI, eDP, MIPI-DSI, MIPI-DSI/CSI and MIPI-CSI
105 * HDMI In/Out, DP, MIPI DSI/CSI, eDP
123 * HDMI In/Out, DP, MIPI DSI/CSI, eDP
|
| /u-boot/board/theobroma-systems/puma_rk3399/ |
| A D | README | 20 * Camera: 2x CSI (one on the edge connector, one on the Q7 specified CSI ZIF)
|
| /u-boot/arch/arm/mach-sunxi/ |
| A D | dram_sunxi_dw.c | 130 MBUS_CONF( CSI, true, HIGHEST, 0, 256, 128, 32); in mctl_set_master_priority_h3()
155 MBUS_CONF( CSI, true, HIGHEST, 0, 384, 256, 0); in mctl_set_master_priority_v3s()
178 MBUS_CONF( CSI, true, HIGH, 0, 256, 128, 0); in mctl_set_master_priority_a64()
208 MBUS_CONF( CSI, true, HIGHEST, 0, 150, 120, 100); in mctl_set_master_priority_h5()
236 MBUS_CONF( CSI, true, HIGHEST, 0, 150, 120, 100); in mctl_set_master_priority_r40()
|
| /u-boot/drivers/clk/stm32/ |
| A D | clk-stm32h7.c | 448 CSI, enumerator
458 [CSI] = "clk-csi",
514 pllsrc = stm32_get_rate(regs, CSI); in stm32_get_PLL1_rate()
658 sysclk = stm32_get_rate(regs, CSI); in stm32_clk_get_rate()
|
| /u-boot/arch/arm/mach-rockchip/rk3588/ |
| A D | Kconfig | 37 2x MIPI CSI 2 multiple lanes connector
|
| /u-boot/arch/arm/mach-rockchip/rk3368/ |
| A D | Kconfig | 41 with integrated CVBS (TP2825) / MIPI DSI / CSI / LVDS
|
| /u-boot/board/theobroma-systems/ringneck_px30/ |
| A D | README | 14 * MIPI-CSI
|
| /u-boot/arch/arm/mach-rockchip/px30/ |
| A D | Kconfig | 51 * MIPI-CSI
|
| /u-boot/doc/board/amlogic/ |
| A D | bananapi-cm4io.rst | 21 - MIPI CSI interface
|
| A D | bananapi-m2s.rst | 28 - MIPI CSI header
|
| /u-boot/doc/board/ti/ |
| A D | am62x_sk.rst | 32 1x CSI-RX-4L for Camera, eCAP/eQEP, ePWM, among other peripherals.
|