Searched refs:additional (Results 1 – 25 of 124) sorted by relevance
12345
| /u-boot/arch/arm/include/asm/arch-mx31/ |
| A D | sys_proto.h | 15 u32 additional; member
|
| /u-boot/arch/arm/dts/ |
| A D | armada-3720-eDPU-u-boot.dtsi | 36 /* G.hn does not work without additional configuration */
|
| A D | exynos4412.dtsi | 12 * Exynos4412 SoC. As device tree coverage for Exynos4412 increases, additional
|
| A D | exynos4x12.dtsi | 12 * Exynos4x12 SoC. As device tree coverage for Exynos4x12 increases, additional
|
| A D | exynos4210.dtsi | 14 * Exynos4210 SoC. As device tree coverage for Exynos4210 increases, additional
|
| /u-boot/doc/device-tree-bindings/video/ |
| A D | sandbox-fb.txt | 5 required properties. Also an additional optional property is defined:
|
| /u-boot/ |
| A D | .readthedocs.yml | 19 # Optionally build your docs in additional formats such as PDF and ePub
|
| /u-boot/arch/arm/cpu/arm1136/mx31/ |
| A D | generic.c | 153 writel(weimcs->additional, &cscr->additional); in mxc_setup_weimcs()
|
| /u-boot/doc/device-tree-bindings/firmware/ |
| A D | ti,sci.txt | 20 This parent node may optionally have additional children nodes which describe
21 specific functionality such as clocks, power domain, reset or additional
|
| /u-boot/doc/device-tree-bindings/pmic/ |
| A D | max77686.txt | 9 To bind the regulators, please read the additional binding info:
|
| /u-boot/board/logicpd/omap3som/ |
| A D | README | 17 In this case the additional file is written to the filesystem. In this
44 In this case the additional data is written to another partition of the
|
| /u-boot/doc/usage/os/ |
| A D | plan9.rst | 8 Plan 9 from Bell Labs kernel images require additional setup to pass
|
| /u-boot/doc/device-tree-bindings/mtd/ |
| A D | mtd-physmap.txt | 33 For JEDEC compatible devices, the following additional properties
40 additional (optional) property is defined:
|
| /u-boot/lib/rsa/ |
| A D | Kconfig | 45 provide such additional key properties in standardized form,
63 provide such additional key properties in standardized form,
|
| /u-boot/doc/device-tree-bindings/net/ |
| A D | altera_tse.txt | 27 If present, TSE supports additional unicast addresses.
28 Otherwise additional unicast addresses are not supported.
|
| /u-boot/doc/board/toradex/ |
| A D | colibri_imx7.rst | 25 image, ready for flashing (but check next section for additional
46 U-Boot tree, check additional details in introduction_habv4.txt)
|
| /u-boot/doc/device-tree-bindings/input/ |
| A D | hid-over-i2c.txt | 21 Some devices may support additional optional properties to help with, e.g.,
|
| /u-boot/arch/mips/mach-mtmips/mt7628/ |
| A D | Kconfig | 12 and 8 MiB of flash (SPI NOR) and additional SPI NAND storage.
|
| /u-boot/doc/board/tbs/ |
| A D | tbs2910.rst | 76 additional details.
104 additional details.
191 SoC reference manual for additional details on the BOOT_CFG registers.
|
| /u-boot/doc/usage/cmd/ |
| A D | fatload.rst | 47 requirement for DMA transfer (ARCH_DMA_MINALIGN) additional buffering will be
|
| /u-boot/board/freescale/mx6memcal/ |
| A D | Kconfig | 181 int "Read additional latency"
191 int "Write additional latency"
|
| /u-boot/doc/SPL/ |
| A D | README.am335x-network | 27 (Or create additional board configuration with such option).
81 can use usual U-Boot commands from this script: tftp to load additional
|
| /u-boot/board/solidrun/clearfog/ |
| A D | Kconfig | 15 detection via additional EEPROM hardware. This option enables selecting
|
| /u-boot/board/toradex/common/ |
| A D | Kconfig | 81 bool "Support for additional EEPROMs (carrier board, display adapter)"
|
| /u-boot/board/theobroma-systems/puma_rk3399/ |
| A D | README | 22 * Companion Controller: onboard additional Cortex-M0 microcontroller
|
Completed in 689 milliseconds
12345