| /u-boot/drivers/phy/ |
| A D | phy-stm32-usbphyc.c | 449 dev_warn(dev, "phy%d: invalid st,current-boost-microamp value\n", index); in stm32_usbphyc_tuning()
467 dev_warn(dev, "phy%d: invalid st,tune-hs-dc-level value\n", index); in stm32_usbphyc_tuning()
480 dev_warn(dev, "phy%d: invalid st,trim-hs-current value\n", index); in stm32_usbphyc_tuning()
486 dev_warn(dev, "phy%d: invalid trim-hs-impedance value\n", index); in stm32_usbphyc_tuning()
492 dev_warn(dev, "phy%d: invalid st,tune-squelch-level value\n", index); in stm32_usbphyc_tuning()
501 dev_warn(dev, "phy%d: invalid st,tune-hs-rx-offset value\n", index); in stm32_usbphyc_tuning()
|
| /u-boot/drivers/pinctrl/ |
| A D | pinctrl-zynqmp.c | 448 dev_warn(dev, "Invalid drive strength for pin %d\n", pin); in zynqmp_pinconf_set()
459 dev_warn(dev, "Invalid IO Standard requested for pin %d\n", in zynqmp_pinconf_set()
466 dev_warn(dev, "Invalid IO Standard requested for pin %d\n", in zynqmp_pinconf_set()
479 dev_warn(dev, "unsupported configuration parameter '%u'\n", in zynqmp_pinconf_set()
552 dev_warn(dev, "Invalid drive strength\n"); in zynqmp_pinctrl_get_pin_muxing()
|
| A D | pinctrl-uclass.c | 87 dev_warn(dev, "%s: uclass_get_device_by_phandle_id: err=%d\n", in pinctrl_select_state_full()
94 dev_warn(dev, "%s: pinctrl_config_one: err=%d\n", in pinctrl_select_state_full()
|
| /u-boot/drivers/video/ti/ |
| A D | tilcdc-panel.c | 89 dev_warn(dev, "failed to get backlight\n"); in tilcdc_panel_probe()
94 dev_warn(dev, "failed to get enable GPIO\n"); in tilcdc_panel_probe()
|
| /u-boot/drivers/spi/ |
| A D | spi-sn-f-ospi.c | 199 dev_warn(ospi->dev, "Device frequency too large: %d\n", in f_ospi_config_clk()
212 dev_warn(ospi->dev, "Device frequency too small: %d\n", in f_ospi_config_clk()
325 dev_warn(ospi->dev, "Unsupported direction"); in f_ospi_config_indir_protocol()
370 dev_warn(ospi->dev, "Unsupported direction"); in f_ospi_indir_prepare_op()
515 dev_warn(ospi->dev, "Unsupported direction"); in f_ospi_exec_op()
|
| /u-boot/drivers/rtc/ |
| A D | ds3232.c | 127 dev_warn(dev, in verify_osc()
147 dev_warn(dev, "WARNING: year should be between 1900 and 2099!\n"); in ds3232_rtc_set()
|
| /u-boot/drivers/clk/ti/ |
| A D | clk-am3-dpll.c | 51 dev_warn(clk->dev, "%ld is to high a rate, lowered to %ld\n", in clk_ti_am3_dpll_round_rate()
144 dev_warn(clk->dev, in clk_ti_am3_dpll_ssc_program()
187 dev_warn(clk->dev, in clk_ti_am3_dpll_ssc_program()
|
| /u-boot/include/dm/ |
| A D | device_compat.h | 110 #define dev_warn(dev, fmt, ...) \ macro
|
| /u-boot/drivers/timer/ |
| A D | dw-apb-timer.c | 69 dev_warn(dev, "Can't get reset: %d\n", ret); in dw_apb_timer_probe()
|
| /u-boot/drivers/misc/ |
| A D | k3_avs.c | 229 dev_warn(dev, "supply not found for VD%d.\n", vd->id); in k3_avs_configure()
272 dev_warn(dev, "AVS-class 0 not supported for VD%d\n", in k3_avs_probe()
|
| A D | ls2_sfp.c | 142 dev_warn(dev, "secret value hamming error not zero: %08x\n", in ls2_sfp_check_secret()
185 dev_warn(dev, "fuses already programmed\n"); in ls2_sfp_ioctl()
|
| /u-boot/drivers/watchdog/ |
| A D | meson_gxbb_wdt.c | 37 dev_warn(dev, "%s: timeout_ms=%llu: maximum watchdog timeout exceeded\n", in amlogic_wdt_set_timeout()
|
| A D | xilinx_wwdt.c | 75 dev_warn(dev, "Can't stop Xilinx watchdog.\n"); in xlnx_wwdt_stop()
|
| /u-boot/drivers/usb/mtu3/ |
| A D | mtu3_plat.c | 145 dev_warn(dev, "can't get optional vusb33 %d\n", ret); in get_ssusb_rscs()
150 dev_warn(dev, "can't get optional vbus regulator %d!\n", ret); in get_ssusb_rscs()
|
| A D | mtu3_gadget.c | 173 dev_warn(mtu->dev, "%s is already enabled\n", mep->name); in mtu3_gadget_ep_enable()
205 dev_warn(mtu->dev, "%s is already disabled\n", mep->name); in mtu3_gadget_ep_disable()
264 dev_warn(mtu->dev, in mtu3_gadget_queue()
|
| /u-boot/drivers/remoteproc/ |
| A D | stm32_copro.c | 117 dev_warn(dev, "No valid resource table for this firmware\n"); in stm32_copro_load()
|
| /u-boot/drivers/video/tidss/ |
| A D | tidss_drv.c | 325 dev_warn(priv->dev, "%s: %d port width not supported\n", in dss_enable_oldi()
355 dev_warn(priv->dev, "%s: Incorrect oldi mode. Returning.\n", in dss_enable_oldi()
367 dev_warn(priv->dev, "%s: timeout waiting OLDI reset done\n", in dss_enable_oldi()
603 dev_warn(priv->dev, in dss_vp_set_clk_rate()
914 dev_warn(priv->dev, "failed to reset priv\n"); in tidss_drv_remove()
|
| /u-boot/drivers/mtd/nand/raw/ |
| A D | denali_dt.c | 149 dev_warn(dev, "Can't get reset: %d\n", ret); in denali_dt_probe()
|
| /u-boot/drivers/usb/cdns3/ |
| A D | core.c | 337 dev_warn(dev, "Unable to get USB2 phy (ret %d)\n", ret); in cdns3_probe()
345 dev_warn(dev, "Unable to get USB3 phy (ret %d)\n", ret); in cdns3_probe()
|
| /u-boot/drivers/rng/ |
| A D | smccc_trng.c | 194 dev_warn(dev, "Can't get TRNG UUID\n"); in smccc_trng_probe()
|
| /u-boot/drivers/mmc/ |
| A D | socfpga_dw_mmc.c | 45 dev_warn(dev, "Can't get reset: %d\n", ret); in socfpga_dwmci_reset()
|
| /u-boot/drivers/video/rockchip/ |
| A D | rk_vop.c | 102 dev_warn(dev, "failed to assert dclk reset (ret=%d)\n", ret); in rkvop_enable()
109 dev_warn(dev, "failed to deassert dclk reset (ret=%d)\n", ret); in rkvop_enable()
|
| /u-boot/drivers/video/stm32/ |
| A D | stm32_dsi.c | 291 dev_warn(dev, "Warning max phy mbps is used\n"); in dsi_get_lane_mbps()
295 dev_warn(dev, "Warning min phy mbps is used\n"); in dsi_get_lane_mbps()
|
| /u-boot/drivers/gpio/ |
| A D | dwapb_gpio.c | 127 dev_warn(dev, "Can't get reset: %d\n", ret); in gpio_dwapb_reset()
|
| /u-boot/drivers/i2c/ |
| A D | ocores_i2c.c | 530 dev_warn(dev, in ocores_i2c_probe()
558 dev_warn(dev, in ocores_i2c_probe()
|