Searched refs:sequence (Results 1 – 10 of 10) sorted by relevance
| /drivers/usb/gadget/rcar/ |
| A D | fifo.h | 71 int sequence; member
109 void *buf, int len, int zero, int sequence);
|
| A D | fifo.c | 47 void *buf, int len, int zero, int sequence) in usbhs_pkt_push() argument
80 pkt->sequence = sequence; in usbhs_pkt_push()
506 usbhs_pipe_data_sequence(pipe, pkt->sequence); in usbhsf_pio_try_push()
507 pkt->sequence = -1; /* -1 sequence will be ignored */ in usbhsf_pio_try_push()
626 usbhs_pipe_data_sequence(pipe, pkt->sequence); in usbhsf_prepare_pop()
627 pkt->sequence = -1; /* -1 sequence will be ignored */ in usbhsf_prepare_pop()
|
| A D | pipe.c | 567 void usbhs_pipe_data_sequence(struct usbhs_pipe *pipe, int sequence) in usbhs_pipe_data_sequence() argument
578 switch (sequence) { in usbhs_pipe_data_sequence()
611 int sequence; in usbhs_pipe_clear_without_sequence() local
614 sequence = usbhs_pipe_get_data_sequence(pipe); in usbhs_pipe_clear_without_sequence()
618 usbhs_pipe_data_sequence(pipe, sequence); in usbhs_pipe_clear_without_sequence()
|
| /drivers/net/ |
| A D | sandbox.c | 78 u16 sequence; member
324 icmpr->sequence = htons(1); in sandbox_eth_recv_ping_req()
|
| /drivers/ram/octeon/ |
| A D | octeon_ddr.c | 1952 int sequence) in oct2_ddr3_seq() argument
1998 lmc_config.cn63xx.sequence = sequence; in oct2_ddr3_seq()
2003 rank_mask, sequence, sequence_str[sequence]); in oct2_ddr3_seq()
|
| A D | octeon3_lmc.c | 176 int sequence) in oct3_ddr3_seq() argument
231 seq_ctl.s.seq_sel = sequence; in oct3_ddr3_seq()
235 rank_mask, sequence, sequence_str[sequence]); in oct3_ddr3_seq()
249 printf("Sequence %d timed out\n", sequence); in oct3_ddr3_seq()
254 ddr_seq_print(" LMC sequence=%x: Completed.\n", sequence); in oct3_ddr3_seq()
|
| /drivers/clk/ |
| A D | Kconfig | 17 Add the uclass sequence number of clock provider in the 8 higher bits
|
| /drivers/mtd/spi/ |
| A D | Kconfig | 128 if they _do_ support the Soft Reset sequence.
|
| /drivers/misc/ |
| A D | Kconfig | 419 device. When the device is started up, its power sequence can be
428 device. When the device is started up, its power sequence can be
|
| /drivers/video/ |
| A D | Kconfig | 171 Enable ANSI escape sequence decoding for a more fully functional
541 using the same DSI command sequence. The panel has a 720x1280
1050 sequence. It gives the board an opportunity to prepare the splash
|
Completed in 45 milliseconds