Searched refs:slew (Results 1 – 7 of 7) sorted by relevance
| /drivers/ram/rockchip/ |
| A D | sdram-rv1126-loader_params.inc | 33 /* slew rate when odt enable */
36 /* slew ratee when odt disable */
55 /* slew rate when odt enable */
58 /* slew ratee when odt disable */
78 /* slew rate when odt enable */
81 /* slew ratee when odt disable */
105 /* slew rate when odt enable */
108 /* slew ratee when odt disable */
179 /* slew rate when odt enable */
182 /* slew ratee when odt disable */
|
| /drivers/power/regulator/ |
| A D | tps65941_regulator.c | 281 int ret, delta, uwait, slew, idx; in tps65941_buck_val() local
331 slew = pmic_reg_read(dev->parent, uc_pdata->ctrl_reg + 1); in tps65941_buck_val()
332 if (slew < 0) in tps65941_buck_val()
335 slew &= conv_ops->slew_mask; in tps65941_buck_val()
336 slew = conv_ops->lookup_slew(slew); in tps65941_buck_val()
337 if (slew <= 0) in tps65941_buck_val()
340 uwait = delta / slew; in tps65941_buck_val()
|
| /drivers/pinctrl/nuvoton/ |
| A D | Kconfig | 20 drive-strength, and slew rate control for some of the pins.
|
| /drivers/pinctrl/ |
| A D | pinctrl-zynqmp.c | 64 u32 slew; member
539 &pinmux.slew); in zynqmp_pinctrl_get_pin_muxing()
574 pinmux.slew ? "slow" : "fast", in zynqmp_pinctrl_get_pin_muxing()
|
| /drivers/mmc/ |
| A D | octeontx_hsmmc.h | 78 uint slew; /* clock skew */ member
|
| A D | octeontx_hsmmc.c | 663 printf(" 0: slew: %u %s\n", io_ctl.s.slew, in octeontx_mmc_print_registers2()
664 io_ctl.s.slew ? "high" : "low"); in octeontx_mmc_print_registers2()
2831 if (slot->drive < 0 || slot->slew < 0) in octeontx_mmc_io_drive_setup()
2836 io_ctl.s.slew = slot->slew; in octeontx_mmc_io_drive_setup()
3607 slot->slew = ofnode_read_s32_default(node, "cavium,clk-slew", -1); in octeontx_mmc_get_config()
|
| /drivers/power/ |
| A D | Kconfig | 303 "axp pmic (a)ldo3 inrush quirk" below to enable a slew rate to limit
317 the slew rate in reality is about 25 mV/31.250 uS.
324 the slew rate in reality is about 25 mV/15.625 uS.
|
Completed in 23 milliseconds