1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * Configuation settings for the Freescale MCF5329 FireEngine board. 4 * 5 * Copyright (C) 2004-2007 Freescale Semiconductor, Inc. 6 * TsiChung Liew (Tsi-Chung.Liew@freescale.com) 7 */ 8 9 /* 10 * board/config.h - configuration options, board specific 11 */ 12 13 #ifndef _M5329EVB_H 14 #define _M5329EVB_H 15 16 /* 17 * High Level Configuration Options 18 * (easy to change) 19 */ 20 21 #define CFG_SYS_UART_PORT (0) 22 23 /* I2C */ 24 25 #define CFG_EXTRA_ENV_SETTINGS \ 26 "netdev=eth0\0" \ 27 "loadaddr=40010000\0" \ 28 "u-boot=u-boot.bin\0" \ 29 "load=tftp ${loadaddr) ${u-boot}\0" \ 30 "upd=run load; run prog\0" \ 31 "prog=prot off 0 3ffff;" \ 32 "era 0 3ffff;" \ 33 "cp.b ${loadaddr} 0 ${filesize};" \ 34 "save\0" \ 35 "" 36 37 #define CFG_PRAM 512 /* 512 KB */ 38 39 #define CFG_SYS_CLK 80000000 40 #define CFG_SYS_CPU_CLK CFG_SYS_CLK * 3 41 42 #define CFG_SYS_MBAR 0xFC000000 43 44 #define CFG_SYS_LATCH_ADDR (CFG_SYS_CS1_BASE + 0x80000) 45 46 /* 47 * Low Level Configuration Settings 48 * (address mappings, register initial values, etc.) 49 * You should know what you are doing if you make changes here. 50 */ 51 /*----------------------------------------------------------------------- 52 * Definitions for initial stack pointer and data area (in DPRAM) 53 */ 54 #define CFG_SYS_INIT_RAM_ADDR 0x80000000 55 #define CFG_SYS_INIT_RAM_SIZE 0x8000 /* Size of used area in internal SRAM */ 56 #define CFG_SYS_INIT_RAM_CTRL 0x221 57 58 /*----------------------------------------------------------------------- 59 * Start addresses for the final memory configuration 60 * (Set up by the startup code) 61 * Please note that CFG_SYS_SDRAM_BASE _must_ start at 0 62 */ 63 #define CFG_SYS_SDRAM_BASE 0x40000000 64 #define CFG_SYS_SDRAM_SIZE 32 /* SDRAM size in MB */ 65 #define CFG_SYS_SDRAM_CFG1 0x53722730 66 #define CFG_SYS_SDRAM_CFG2 0x56670000 67 #define CFG_SYS_SDRAM_CTRL 0xE1092000 68 #define CFG_SYS_SDRAM_EMOD 0x40010000 69 #define CFG_SYS_SDRAM_MODE 0x018D0000 70 71 /* 72 * For booting Linux, the board info and command line data 73 * have to be in the first 8 MB of memory, since this is 74 * the maximum mapped by the Linux kernel during initialization ?? 75 */ 76 #define CFG_SYS_BOOTMAPSZ (CFG_SYS_SDRAM_BASE + (CFG_SYS_SDRAM_SIZE << 20)) 77 78 /*----------------------------------------------------------------------- 79 * FLASH organization 80 */ 81 #ifdef CONFIG_SYS_FLASH_CFI 82 # define CFG_SYS_FLASH_SIZE 0x800000 /* Max size that the board might have */ 83 #endif 84 85 #ifdef CONFIG_CMD_NAND 86 # define CFG_SYS_NAND_BASE CFG_SYS_CS2_BASE 87 # define CFG_SYS_NAND_BASE_LIST { CFG_SYS_NAND_BASE } 88 # define NAND_ALLOW_ERASE_ALL 1 89 #endif 90 91 #define CFG_SYS_FLASH_BASE CFG_SYS_CS0_BASE 92 93 /* Configuration for environment 94 * Environment is embedded in u-boot in the second sector of the flash 95 */ 96 97 #define LDS_BOARD_TEXT \ 98 . = DEFINED(env_offset) ? env_offset : .; \ 99 env/embedded.o(.text*); 100 101 /*----------------------------------------------------------------------- 102 * Cache Configuration 103 */ 104 105 #define ICACHE_STATUS (CFG_SYS_INIT_RAM_ADDR + \ 106 CFG_SYS_INIT_RAM_SIZE - 8) 107 #define DCACHE_STATUS (CFG_SYS_INIT_RAM_ADDR + \ 108 CFG_SYS_INIT_RAM_SIZE - 4) 109 #define CFG_SYS_ICACHE_INV (CF_CACR_CINVA) 110 #define CFG_SYS_CACHE_ACR0 (CFG_SYS_SDRAM_BASE | \ 111 CF_ADDRMASK(CFG_SYS_SDRAM_SIZE) | \ 112 CF_ACR_EN | CF_ACR_SM_ALL) 113 #define CFG_SYS_CACHE_ICACR (CF_CACR_EC | CF_CACR_CINVA | \ 114 CF_CACR_DCM_P) 115 116 /*----------------------------------------------------------------------- 117 * Chipselect bank definitions 118 */ 119 /* 120 * CS0 - NOR Flash 1, 2, 4, or 8MB 121 * CS1 - CompactFlash and registers 122 * CS2 - NAND Flash 16, 32, or 64MB 123 * CS3 - Available 124 * CS4 - Available 125 * CS5 - Available 126 */ 127 #define CFG_SYS_CS0_BASE 0 128 #define CFG_SYS_CS0_MASK 0x007f0001 129 #define CFG_SYS_CS0_CTRL 0x00001fa0 130 131 #define CFG_SYS_CS1_BASE 0x10000000 132 #define CFG_SYS_CS1_MASK 0x001f0001 133 #define CFG_SYS_CS1_CTRL 0x002A3780 134 135 #ifdef CONFIG_CMD_NAND 136 #define CFG_SYS_CS2_BASE 0x20000000 137 #define CFG_SYS_CS2_MASK (16 << 20) 138 #define CFG_SYS_CS2_CTRL 0x00001f60 139 #endif 140 141 #endif /* _M5329EVB_H */ 142