Lines Matching refs:is
6 # BT_CTLR_DF_SUPPORT is a wrapper for all DF features. It is referenced by Host
8 # It is required to enable it when Controller supports any DF related feature
61 This sampling mode is optional for Direction Finding according to
70 mode is optional for Direction Finding according to Bluetooth v5.1.
164 is able to store. For nRF5x-based controllers, the hardware imposes
165 the value is within range 2 to 38, where last value is maximum.
176 If this feature is not enabled, the Radio initialization procedure will
178 In such case application is responsible for appropriate GPIOs
188 periodic advertising chain. The range is taken from BT Core spec 5.1, Vol 4 Part E
198 periodic advertising chain. The range is taken from BT Core spec 5.1, Vol 4 Part E
207 Offset of start of antenna switching after end of the CRC. It is a signed value in number
217 Offset of sampling start from beginning of sampling slot. The value is a signed number
218 of 16M cycles relative. It is used when PHY is set to PHY 1M and sampling slot duration
219 is 1 us. Decreasing the offset beyond the trigger of the AoA/AoD procedure will have
228 Offset of sampling start from beginning of sampling slot. The value is a signed number
229 of 16M cycles relative. It is used when PHY is set to PHY 1M and sampling slot duration
230 is 1 us. Decreasing the offset beyond the trigger of the AoA/AoD procedure will have
240 Offset of sampling start from beginning of sampling slot. The value is a signed number
241 of 16M cycles relative. It is used when PHY is set to PHY 1M and sampling slot duration
242 is 2 us. Decreasing the offset beyond the trigger of the AoA/AoD procedure will have
251 Offset of sampling start from beginning of sampling slot. The value is a signed number
252 of 16M cycles relative. It is used when PHY is set to PHY 1M and sampling slot duration
253 is 2 us. Decreasing the offset beyond the trigger of the AoA/AoD procedure will have
268 CTEINLINECTRLEN is enabled and received PDU does not have CTEInfo field. The option
284 8 bits by ordinary right shift operation by 4 bits. That means there is loss in accuracy
295 is a loss in accuracy. This conversion may be used only if you are sure samples will not