| /drivers/spi/ |
| A D | spi_mchp_mss.c | 119 uint32_t control; member
139 uint32_t control; in mss_spi_hw_tfsz_set() local
150 uint32_t control; in mss_spi_enable_controller() local
159 uint32_t control; in mss_spi_disable_controller() local
168 uint32_t control; in mss_spi_enable_ints() local
179 uint32_t control; in mss_spi_disable_ints() local
288 uint32_t control = mss_spi_read(cfg, MSS_SPI_REG_CONTROL); in mss_spi_hw_mode_set() local
343 uint32_t control; in mss_spi_configure() local
437 uint32_t control = 0; in mss_spi_init() local
|
| A D | spi_litex.c | 52 static int spi_config(const struct device *dev, const struct spi_config *config, uint16_t *control) in spi_config()
123 uint16_t control) in spi_litex_send()
146 uint16_t control) in spi_litex_xfer()
193 uint16_t control = 0; in spi_litex_transceive() local
|
| A D | spi_silabs_usart.c | 118 uint16_t *control) in spi_config()
384 uint16_t control = 0; in spi_silabs_usart_transceive() local
|
| A D | spi_mchp_mss_qspi.c | 360 uint32_t control = mss_qspi_read(s, MSS_QSPI_REG_CONTROL); in mss_qspi_clk_gen_set() local
425 uint32_t control = mss_qspi_read(cfg, MSS_QSPI_REG_CONTROL); in mss_qspi_release() local
567 uint32_t control = 0; in mss_qspi_init() local
|
| /drivers/watchdog/ |
| A D | wdt_intel_adsp.h | 92 uint32_t control; in intel_adsp_wdt_pause() local
111 uint32_t control; in intel_adsp_wdt_resume() local
|
| A D | wdt_dw.h | 307 uint32_t control = sys_read32(base + WDT_CR); in dw_wdt_enable() local
327 uint32_t control = sys_read32(base + WDT_CR); in dw_wdt_response_mode_set() local
346 uint32_t control = sys_read32(base + WDT_CR); in dw_wdt_reset_pulse_length_set() local
|
| A D | wdt_litex.c | 67 uint32_t control; in wdt_litex_enable() local
|
| /drivers/sensor/s11059/ |
| A D | s11059.c | 123 static int s11059_control_write(const struct device *dev, uint8_t control) in s11059_control_write()
143 uint8_t control; in s11059_start_measurement() local
202 uint8_t control; in s11059_sample_fetch() local
258 uint8_t control = S11059_INITIAL_CONTROL; in s11059_init() local
|
| /drivers/gpio/ |
| A D | gpio_ite_it8801.c | 63 uint8_t control; in gpio_it8801_configure() local
140 uint8_t control, value; in gpio_it8801_get_config() local
325 uint8_t control; in gpio_it8801_pin_interrupt_configure() local
|
| /drivers/dma/ |
| A D | dma_ti_cc23x0.c | 90 static uint32_t dma_cc23x0_set_addr_adj(uint32_t *control, uint16_t addr_adj, in dma_cc23x0_set_addr_adj()
113 uint32_t control; in dma_cc23x0_config() local
|
| A D | dma_nios2_msgdma.c | 72 uint32_t control; in nios2_msgdma_config() local
|
| A D | dma_mchp_xec.c | 91 volatile uint32_t control; member
123 uint32_t control; member
|
| A D | dma_xilinx_axi_dma.c | 162 uint32_t control; member
|
| /drivers/video/ |
| A D | video_ctrls.c | 290 int video_get_ctrl(const struct device *dev, struct video_control *control) in video_get_ctrl()
332 int video_set_ctrl(const struct device *dev, struct video_control *control) in video_set_ctrl()
|
| /drivers/sensor/adi/ad2s1210/ |
| A D | ad2s1210.c | 588 uint8_t control; in ad2s1210_set_resolution() local
645 uint8_t control; in ad2s1210_set_hysteresis() local
663 uint8_t control; in ad2s1210_hysteresis_is_enabled() local
|
| /drivers/sensor/microchip/mchp_tach_xec/ |
| A D | tach_mchp_xec.c | 39 uint32_t control; member
|
| /drivers/mbox/ |
| A D | mbox_esp32.c | 61 struct esp32_mbox_control *control; member
|
| /drivers/ipm/ |
| A D | ipm_esp32.c | 51 struct esp32_ipm_control *control; member
|
| /drivers/usb/uhc/ |
| A D | uhc_mcux_common.c | 42 int uhc_mcux_control(const struct device *dev, uint32_t control, void *param) in uhc_mcux_control()
|
| /drivers/ethernet/eth_nxp_enet_qos/ |
| A D | nxp_enet_qos_priv.h | 71 uint32_t control; member
|
| /drivers/adc/ |
| A D | adc_npcx.c | 97 control[DT_INST_PROP(0, threshold_count)]; member
|
| /drivers/firmware/tisci/ |
| A D | tisci.h | 1618 uint32_t control; member
1680 uint32_t control; member
|