Searched refs:from (Results 1 – 25 of 145) sorted by relevance
123456
11 Driver requests functions from the OP-TEE and implements RPC mechanism20 Sets the maximum notifications from OP-TEE to the Normal World. OP-TEE using
34 int "timeout when waiting for response from radio serial interface after send cmd"37 …Configure the number of milliseconds before timing out when waiting for acknowledgment from radio …
70 Support Host Notify from peripheral devices.76 Support SMBALERT signal from peripheral devices.95 Support SMBALERT signal from peripheral devices.
26 protection from external devices39 This feature prevents erroneous reading. Values read from an
27 bool "Basic Flash Parameters from devicetree node"36 Read all flash device characteristics from the device at runtime.59 code in RAM, because code can not be fetched from flash while
31 to erase-value prior to write as it only allows to change bits from erase-value46 Keep in mind that write operations can only change value of a bit from erase-value to the50 but only change from erase-value to opposite will be registered.
32 value from a sensor, it is powered up and its I2C address is reconfigured33 from the manufacturer default (0x29) to the address specified in the
9 Enable MDIO support from Litex LiteEth controller.
34 If disabled RF signal is disconnected from RF pin and connected45 If disabled RK signal is disconnected from RK pin and connected
141 bool "EC accepts 0x81 I/O cycle from eSPI transaction"144 With this option enabled, EC will accept 0x81 I/O cycle from the Host.145 This allows EC to accept 2 bytes of port 80 data written from the Host.
37 bool "Use CRC to check data received from the ADC"41 of received data from the ADC.
13 a GPIO connection from the processor.
18 The CC23x0 watchdog timer is sourced from the LFOSC 32.768 clock
26 work method provided. This driver differs from the pipe UART driver62 Enabling this setting will turn on VERY heavy debugging from the71 along with the modem_iface reference from your modem_context object133 the modem_cmd_handler reference from your modem_context object.152 modem "sockets" throughout their lifecycle (from the initial offload158 reserved from the fdtable, for which the max count is set using the
11 multiple interrupts from peripheral to one or
19 Verify the checksum byte from measurements
48 which uses internal designed BLEIF module (different from the57 The pins for the SPI transceiver are not exposed from the chips
12 registers an interrupt to wake up the EC from doze or deep
13 input pin, and we need to select one input from them.
15 input channel and we can select one input from two channel.
15 numbers: noise from these radios are used to feed entropy in this
15 channels, and the input of each comparator comes from ADC pin.
24 being defined as memory ranging from linker script60 sys_mm_drv_page_phys_get() function from the system_mm API.
4 # Keep this Kconfig separate from the fuel_gauge/sbs_gauge Kconfig so it may be shared with the
16 Mailbox driver for transmitting events from VPR to a remote core
Completed in 40 milliseconds